端接

端接装置。右击指定平衡网络，带有平衡网络功能的端接装置，或混合变压器。

Terminating set . Right-click for balancing network , terminating set w / balancing network , or hybrid transformer .

端接基苯甲酸二聚体结构性质的DFT研究

DFT Study on Structures and Properties of 4-substituted Terminated Benzonic Acid Dimers

本文给出了基于双端接载LC梯形原型的OTA全集成滤波器的设计方法。

A design method for full-integrated OTA filter based on double terminated LC ladder is presented .

基于ProtelSDK的传输线分析与端接处理系统

Analyzing Transmission Line and Termination for PCB Track Based on Protel SDK

基于终端匹配理论研究了简单并联端接、戴维南端接和RC端接等几种终端匹配方法。

Based on terminal-matching theory , it researched into some terminal-matching methods such as simple parallel termination , Thevenin termination and RC termination .

单端接电阻双口LC梯形网络实现中极点移除和网络传输零点关系的探讨

On the Relations of Pole Removal to the Network Transfer Function Zeros in the Realization of Resistive Terminated LC Ladder Networks

并对C60端接四臂星状高分子衍生物进行表征。

The structure of C60 end-capped four-arm polymer derivatives were also characterized and discussed .

高速ECL数字电路中的端接技术

Termination Technique of High Speed ECL Digital Circuits

在单端接电阻双口LC梯形网络的实现过程中要弄清楚的主要问题之一，就是极点移除和网络传输零点的关系。

One of the main problems in the realization of resistive terminated LC ladder networks is the relations of pole removal to the transfer function zeros .

根据传输线理论，提出端接迹线最大匹配长度值限定法，结合PCB设计，可避免端接失配反射。

The maximum matching length of termination trace based on the transportation theory was set up , which was helpful to decrease the termination reflection in PCB designing .

介绍了利用Protel对PCB板进行信号完整性分析，并通过Protel仿真给出采用端接技术后信号质量的提高。

Analyzes signal integrity with Protel . Finally , a simulation with Portel illustrates high quality of signal by applying termination technology to signal .

在均匀多导体传输线的时域有限差分法（FDTD）基础上，对非均匀多导体传输线及端接非线性负载的情况进行了分析。

Based on the uniform multi-conductor transmission lines ( MTL ), the FDTD method is adopted to research the transient response of the nonuniform transmission lines with nonlinear loads .

±500kV直流输电工程送端接地极大地参数测试报告

The Measurements of Earth Parameter of Sending End Grounding Electrode for ± 500kV DC Transmission Project

你还需要使用一个带接地线的BNC端接器将网络接地。

You may also need to use a BNC terminator with a grounding wire to ground the network .

以双端接载LC网络组成的模拟滤波器为原型，取LDI变换进行数字滤波器的设计，可以保持LDI数字滤波器低灵敏度性质不变。

It is possible to remain the expected low-sensitivity properties of a LDI digital filter based on a two-port LC network analog filter model by LDI transformation .

分析了嵌入式视频系统高速数字的信号完整性问题，使用串行端接和分支总线拓扑解决信号完整性问题，通过PROTELDXP2004进行SI仿真验证；

The high speed signal integrity in the embedded video system is analyzed by using serial ports connection and part-bus structure to resolve the SI . And the signal integrity simulation is performed on the Protel DXP 2004 software platform .

本文论述了双端接阻容负载RC二端口网络转移电压函数的极点与RC阻抗和导纳乘积的零，极点位置分布关系定理。

In this paper , a theorem about the position 's distribution of the poles of the transfer voltage function of a two-port network with double-end connected load RC and ! the zeroes and poles of the RC impedance and RC admittance 's product is presented .

同时笔者还着重研究了DDR模块的拓扑结构的优化以及如何在趋肤效应的情况下对矩形截面直导线进行正确的端接。

During the process , I have researched the topology optimization of DDR modules and the problem of how to match the Characteristic Impedance of square cross section wire which is affected by the Skin Effect .

最后对XLPE电缆中局部放电老化进行了理论研究。3、应用接地线电流法重点研究金属屏蔽层单端接地XLPE电缆绝缘在线检测方法。

Finally , partial discharge of XLPE cables to the theoretical study of aging has been studied . 3 、 It is Single-ended earthing of metal shield layer XLPE cable insulation on-line detection which is made focus research on with Grounding Current .

另外，本文还研究了FDTD分析微波电路时散射参数的两种提取方法，着重研究了端接匹配负载提取散射参数的方法，并对微带线端接匹配负载模型作了进一步的研究。

In addition , two methods for extracting the scattering parameters of microwave circuits are studied in this paper , with the emphasis on the matched load termination method . And a further research of the FDTD modeling of matched load terminating a microstrip line is made .

基于传输线分布参数节点导纳方程和数值拉普拉斯反变换（NILT）方法，仿真分析了传输线串扰电压响应及传输线参数和端接阻抗对串扰电压峰值的影响。

Based on distribution parameter node admittance equations and the method of the numerical inverse Laplace transformation ( NILT ), crosstalk coupling voltage responses are analyzed at terminals of transmission lines with common ground .

利用时域空间扩展方法（TDSE）对多导体传输线端接动态元件的情况进行了分析，为电磁兼容分析提供了一种新的途径。

The analysis of multiconductor transmission lines connected with dynamic component used time domain space expansion ( TDSE ) method is implemented . It is a new approach for analyzing electromagnetic compatibility .

本文在转移函数构成和求解开路阻抗参数等方面，提出新的概念和方法，将Darlington的经典实现理论，一般性地引伸到两侧都端接任意阻抗（Non-Foster正实函数型式）的情况。

This paper presents new ideas and methods for constructing the transfer function , solving the open-circuit impedance parameters , etc. The classical Darlington 's realization theory has been generalized to include arbitrary generator and load impedances ( Non-Foster positive-real functions ) .

传输线端接阻抗对线间串扰的影响研究

Research on Impact of Termination Impedance to Crosstalk of Transmission Line

板级高速时钟信号建模仿真与端接方法

Simulation and Termination Methods for Board Level High Speed Clock Signals

高速数字电路中，各级电路在端接很容易出现信号完整性问题。

There are problems with signal integrity in high speed digital circuits .

端接非线性负载的不等长传输线瞬态分析

Transient analysis of unequal length multiconductor transmission lines loaded by nonlinear devices

端接配体原子的电负性对磁耦合作用的影响

Effect of Electronegativity of Atoms in Terminal Ligands on Magnetic Coupling Interactions

连接器的端接形式对电磁干扰的影响

The Influence of Termination on EM Disturbance in Connectors

端接阻抗对传输线线间耦合的影响分析

The Impact of Terminal Impedance on the Coupling Effect of the Transmission Line