显示接口

基于单片机串行扩展的大屏幕LED显示接口电路

A LED Display Interface Circuit of Large-screen by COM Port Extended of Embedded Microcontroller

基于FPGA的液晶显示接口设计

The Design of LCD Display Interface Module Based on FPGA

LED屏显示接口技术研究

Study of Led Display Screen on Interface Technique

全新大屏幕/高分辨率LCD内部显示接口技术

A New Intra-Panel Interface for Large Size / High Resolution TFT-LCD Applications

基于8031单片机，研制出一种低成本的串行口扩展的LED显示接口电路，介绍其硬件电路与程序。

A low cost serial I / O driver circuit for LED Array Displayers based on single-chip 8031 is presented .

新型LCD控制芯片显示接口设计

Design of a Novel Display Interface For LCD Controller

利用处理器自带的LCD控制器设计了新的显示接口；

Designed a new display interface by the own LCD controller of the processor .

基于CPLD的数据采集与显示接口电路仿真设计

Simulation and Design of Display Interface Circuit and Data Acquisition Based on CPLD

基于SoPC的视频监视器千兆网显示接口设计

The design of video monitor Gigabit Ethernet display interface based on SoPC

设计了LCD显示接口电路，以显示凝血指标和描绘凝固曲线。

A LCD interface circuit is designed to display the blood coagulation time and describe the blood coagulation curve . 5 .

基于PLD的单片机显示接口电路设计

Interface Circuit Devising on the Basis of PLD

一种新型键盘、LED显示接口芯片HD7279A

7279A , A New Interface Chip for Keyboard and LED Display

显示接口电路以地址译码和显示单元选择相配合，仅用16点输出，即可实现最多128位LED数码显示；

Using only 16 output points , the display interface circuit can realize at most 128 bits of LED digital display by making address decoding cooperate with unit selection ;

PCI局部总线与AGP显示接口

PCI Local Bus and AGP Video Interface

视频图形阵列（VGA）作为一种标准的显示接口已得到广泛应用。

As a standard display interface , VGA has been widely used .

分析了核心板的存储器接口电路、JTAG调试接口电路和LCD显示接口电路。

Analyzed memory interface circuit , JTAG debug interface circuit and LCD display interface circuit on core board .

主控单元的主控芯片选用了ARM芯片，并配以数据存储电路、按键和液晶显示接口电路。

ARM chip is chosen as the master chip of main control unit , main control unit includes data storage circuit and key and LCD display interface circuit besides .

研究气味传感器阵列的组成形式以及其采集到的数据，设计了传感器与DSP的接口数据采集电路以及视频显示接口电路。

The form of smell sensor arrays and collected data were investigated , as well as the circuit of sensor and DSP and the circuit of video display interface .

PL／M－96语言是一种非常优秀的单片机软件开发工具，本文将介绍一个使用该语言编写的MCS96单片机键盘显示接口实例程序。

The paper introduces a routine programmed by PL / M language for the interface of MCS 96 SCP ' keyboard and display .

整个测试系统包括交流源电路、信号采集与调理电路、LED电子负载电路、ARM处理器控制电路、液晶显示接口电路、开关量接口电路和通信接口电路。

The whole test system includes AC source , signal acquisition and regulate circuit , LED electronic load , ARM control circuit , LCD interface circuit , switching value circuit and communication interface circuit .

VGA显示接口标准统一，市场覆盖广，技术成熟，目前使用非常广泛。

The display interface of VGA is standard , wide-ranging in the market , technology mature and is widely used at present .

外围电路模块主要包括触摸屏和LCD显示接口电路、Uart接口电路、以太网外围接口电路、电机驱动电路、流量阀控制电路、光信号和温度数据采集电路、电压转换电路等几个模块。

Peripheral circuit module includes the touch screen , LCD display interface circuit , UART , the motor drive circuit , the light signal and temperature data acquisition circuit .

介绍一种基于MCS-51或MCS-96系列单片机控制的超声波测距仪所使用的LED显示器的动态显示接口电路。

The dynamic display interface circuit of the LED display used in the Ultrasonic Distance Tester which is controlled with a series of SCM such as MCS-51 or MCS-96 , is introduced .

分析了8279芯片的显示接口及8段和16段LED显示驱动电路的特点，提出了8段和16段LED混合显示驱动的方法，并介绍了一种经济实用的显示驱动电路。

The displaying interface of 8279 and the characteristics of 8 - and 16-segment LED displaying and driving circuit are analyzed in the paper . The displaying and driving method of 8-segment LED mixed with 16-segment LED is presented and an economical and practical displaying circuit is introduced .

显示接口模块又是LCD控制芯片与LCD驱动器的接口，其最终决定液晶显示图形的质量和效果，所以显示接口模块是液晶显示系统的核心部件。

As the interface of LCD driver and LCD control IC , the display interface module determines the ultimate quality and effect of the display figure . Therefore , the display interface module is the core part in the LCD display system .

同时，利用EDA技术，采用复杂可编程逻辑器件实现地址译码及其它控制逻辑、键盘扫描及液晶显示接口等，进一步简化外围硬件电路的设计。

Also , by use of EDA technology , address-encoding circuit , control logic circuit , keyboard scanning circuit and LCD interface were realized with complex programmable logic device , so the assistant hardware circuit was more simplified .

考虑到采用FPGA芯片可以集成多个功能模块，本设计将函数信号发生器和扫频信号源、频率计集成在同一个FPGA芯片中，该芯片同时集成了键盘、数码显示接口模块。

FPGA is such chip where one can integrate multi-function modules in it . One FPGA chip is used here to integrate function signal source , sweeping source and frequency meter , and the interfaces modules to keyboard and numeral display are built in as well .

OSD大多由硬件实现，提供分辨率小、色彩数低的文字和图形显示接口，被广泛用于嵌入式系统。

OSD is usually implemented in hardware , providing small resolution of small number of low-color text and graphics display interface , and has been widely used in embedded systems .

该方案是以DSP作为处理器，由FPGA实现输入输出等外围接口，完成对IMU信号的采集和缓存、多串行口的扩展、键盘接口扩展以及液晶显示接口扩展等功能；

In this scheme , DSP is used to be a processor . And the I / O interface function is realized by FPGA that performs the IMU signal acquisition and buffering data , expanding multi UART , keypad interface and LCD interface .

以两种形式实现了该拼贴显示接口：函数调用形式（DSDM）和访存形式（DSDMJ）。

Two styles of the interface are implemented , which are the style of invoking function and the style of accessing memory .