首页 / 词典 / good

修正算法

  • 网络Correction algorithm;modified algorithm
修正算法修正算法
  1. 给出了有限颗粒法(FCM)的一个修正算法,用来模拟二维多孔介质中复杂的物理、生物化学输运现象。

    A modified algorithm of finite cell method ( FCM ) is presented for simulating complex physical , biological and chemical transport in porous media .

  2. 针对这两个效应,提出了相对应的修正算法,并将该修正算法应用于Lee、平方环、对数、绝对值等定时同步算法中。

    To eliminate them , two modified algorithm are proposed . And the modified algorithms are applied in the Lee , square , logarithm , and absolute timing synchronization algorithms .

  3. 一种引入行驶状态识别的半主动悬架PID控制修正算法

    A Modified Algorithm of Semi-Active Suspension PID Control with Driving State Identification Introduced

  4. 五坐标NC加工曲面干涉检测及刀位角修正算法研究

    An Algorithm for Interference Checking and Angle Adjust of 5 axis NC Machining

  5. 基于等高线构建TIN模型的平三角形修正算法

    Flat Triangles Correct Algorithm to Create TIN Based on Contours

  6. 强vanderpol振子的谐波与修正算法

    Harmonic wave and correction algorithm for forced Van der Pol oscillator

  7. Newton迭代法的修正算法&预测式迭代法

    Modified method of Newton iterative-prognosticated iterative method

  8. 基于活动轮廓模型的DP修正算法

    A Modified DP Algorithm Based on Active Contour Model

  9. 提出AR模型谱估计与双峰谱线修正算法相结合的间谐波检测方法。

    A method for interharmonic measurement is presented based on AR model spectral estimation and correction algorithm of double spectral lines .

  10. 一是利用分段FFT的相位差修正算法,二是基于二次内插的频率FFT校正法。

    One method is phase difference correction of partly FFT ; the other is FFT frequency correction with quadratic interpolation .

  11. 基于Blankman-harris窗的加窗FFT插值修正算法

    The Correction Algorithm Based on the Blankman-harris Windows and Interpolated FFT

  12. 提出一种用于调度员培训仿真器(DTS)动态过程仿真的、广度优先的快速拓扑搜索以及跟踪、修正算法。

    This paper describes a new topology processor based on width-priority for dynamic simulation in dispatcher training simulator ( DTS ) .

  13. 改进的WAAS电离层时延网格修正算法

    An improved grid-based correction algorithms for the ionospheric delay in WAAS

  14. 从SOC的定义出发,通过比较几种常用SOC估计方法,并结合车用动力电池的应用环境,本文提出了卡尔曼滤波修正算法。

    After comparing some commonly used methods and considering the electric vehicle environment , this paper proposes a new method named Kalman filter correction algorithm on the basis of SOC definition .

  15. 本文针对噪声背景下单频信号难以估计准确的问题,讨论了1种基于FFT的信号频率幅值修正算法,分析了不同窗函数下对信号的估计效果。

    This paper presented a frequency and amplitude modification method based on FFT is to estimate single-frequency signal correctly in noises . Different window functions ' affection on estimation is analyzed .

  16. 在设计过程中,把QUEST法作为矢量观测数据压缩技术有效地结合进姿态估计器中,使得在多矢量观测情况下的滤波修正算法得到了简化。

    In addition , the QUEST algorithm is efficiently combined with the attitude estimator as the compressing technique of multi vector observation information in order to simplify the update implementation .

  17. 极小l1范数的修正算法

    A modified algorithm for_1 norm minimization

  18. 为改善ABS转向控制性能,研究了转向工况下的轮速特征,提出了基于ABS控制信息的转向识别和参数修正算法。

    To improve ABS performance of steering braking , the characteristics of wheel speed under steering condition are studied . The algorithms of turning identification and parameter correction are proposed based on ABS control information .

  19. 在特征提取方面,利用矩算法提取图像的不变性特征,并详细讨论了Hu矩及其修正算法、Zernike矩和小波矩。

    We use moment algorithm to extract the invariant features of image , and discuss zernike moments , wavelet moments , Hu moments and improve algorithm of Hu moments in detail .

  20. 本文着重分析了PT法带电测tgδ的干扰和系统误差来源,并提出了排除方法和修正算法。

    This paper emphatically analyses the sources of the interference and system errors in the measurement of tg δ with PT method on line , and proposes measures of eliminating them and methods to correct the calculations .

  21. 基于规范形随机VDE新息表示和新息修正算法的多变量动态系统辨识方法

    A method for multivariable system identification based on the canonical stochastic VDE innovation representation and the modified durbin 's algorithm

  22. 对于非线性系统中的机动目标跟踪问题,首先针对当前统计模型的缺陷提出了一种修正算法,然后应用转换测量Kalman滤波算法进行跟踪。

    Considering the problem of the maneuvering target tracking in the nonlinear system , this paper first proposes a modified algorithm based on " current " statistical model . Then a converted measurement Kalman filter is applied to tracking the target .

  23. 为解决这一类非线性系统的控制问题,提出了基于反演控制设计和非连续自适应修正算法的自适应鲁棒控制器(ARC)设计方法,给出了基于Lyapunov稳定性理论的系统稳定性证明。

    To solve this kind of problems , the recently proposed adaptive robust control ( ARC ) was applied which based on backstepping control technique and discontinuous projection method . The stability of the overall system was verified by the Lyapunov stability criterion .

  24. GMS5资料反演地表温度的一个修正算法

    An improved algorithm to retrieve land surface temperature by GMS 5 data

  25. 阐明了概率数据互联(PDA)算法能很好地解决密集环境下的目标跟踪问题,在该算法基础上,人们又提出了联合概率数据互联(JPDA)算法和一些基于PDA的修正算法。

    Probabilistic data association ( PDA ) algorithm can resolve the problem of tracking targets in clutter . Based on the method , joint probabilistic data association algorithm ( JPDA ) and some modified algorithms were proposed .

  26. 由于针对时间的表示和推理是AI中的重要因素,因而提出了时态框架的表示方法.利用约束时间传播和对框架的更新以及变异,可以分别以时刻链和修正算法对框架进行推理。

    Aiming at the temporal representation and reasoning are the important factors of AI , a new representation tense frame is presented . The restraint propagation algorithm is also described . And the modification method , which might renew the frame , is discussed .

  27. 在该算法基础上,人们又提出了多传感器联合概率数据互联(MSJPDA)算法和一些基于JPDA的修正算法。

    Based on the method , MSJPDA and some modified algorithms are proposed . A very important parameter used in JPDA algorithm is clutter density .

  28. 文中介绍了用该算法构造QRS波检测阈值和QRS波模板集的实现方法,并探讨了在连续监护过程中,检测阈值和模板集的修正算法。

    The implementation method of this algorithm for constructing the QRS wave detection thresholds and the QRS wave template set , as well as discussion of the adaptive algorithm of the detection thresholds and the template set in continuous monitoring are introduced .

  29. 本文讨论了GSVD的更新修正算法,在每步计算中只需有限次的运算,即可由前一次的近似分解结果计算出新的近似分解。

    With this procedure , a new approximate decomposition can be computed from previous one , with finite operations at each iteration .

  30. 其次分析了控制器的硬件和软件设计,硬件着重分析其原理和基本构成,软件着重分析了液晶编程、ADC编程、物料称量编程和动态修正算法;

    Second , the hardware and software of the controller is analyzed . For its hardware , the principle and basic structure are analyzed . For its software , the programming of liquid crystal , ADC , weighing and the algorithm of dynamic modifying are analyzed .