改性乳化沥青

  • 网络modified emulsified asphalt;modified asphalt emulsion
改性乳化沥青改性乳化沥青
  1. 皂液pH值对改性乳化沥青性质的影响

    Influence of Soap Solution 's pH Value on the Property of Modified Asphalt Emulsion

  2. 实验中的改性乳化沥青不但能够满足公路路面施工技术规范的要求,而且较传统乳化沥青降低了成本,将产生良好的经济效益。

    The modified asphalt emulsion not only meet highway surface construction technology criteria requirement , but also has good economy efficiency which has lower cost compared with traditional asphalt emulsion .

  3. 液体星型SBS改性乳化沥青生产

    The Production of Modified Emulsified Bitumen for Liquid SBS Model Star

  4. SBR改性乳化沥青透层在京张高速公路上的应用

    Application of Modified Emulsified Bitumen to the Beijing-Zhangjiakou Expressway

  5. SBS改性乳化沥青生产技术探讨

    Study on Production Technology of SBS Modified Emulsified Asphalt

  6. SBS胶乳研制及对改性乳化沥青的影响

    The synthesis research of emulsified SBS and effect of emulsified SBS to modified emulsified asphalt

  7. SBS改性乳化沥青在赤通高速公路施工中的应用

    Application of SBS emulsified modified emulsified asphalt to the construction of Chifeng to Tongliao Expressway

  8. SBR改性乳化沥青稀浆封层在乡村道路路面工程中的应用

    Application of Slurry Seal Coat of SBR Modified Emulsified Asphalt in Pavement Project of Rural Road

  9. 通过对SBR改性乳化沥青稀浆封层技术在乡村道路砂石路面上的应用,提出作为路面封层的配比、生产工艺及施工工序。

    The application of SBR modified emulsion asphalt slurry seal in used pavement reconstruction is presented .

  10. SBS聚合物改性乳化沥青作为桥面防水粘结材料路用性能研究

    Study on road performance of SBS polymer modified emulsified asphalt for bridge waterproof and cohesive layer

  11. 就液体星型SBS改性乳化沥青生产中,原材料、生产工艺、乳化设备的选择及生产影响因素进行了论述。

    The paper discussed the raw materials , production technology , the choice of emulsified equipment and influenced factors in the production of modified emulsified bitumen .

  12. 而SBS改性乳化沥青的效果虽然较好,但由于乳化困难,一直没有大范围的使用。

    And the effect of emulsified asphalt SBS modification is good , but because of emulsified difficulties , never be in a wide range of use .

  13. SBR改性乳化沥青做为高速公路下封层、粘层,是将乳化沥青的应用向前推进了一步。

    The SBR modified emulsified bitumen does for the highway under the sealing course , the tacky surface , was prompted forward the emulsified bitumen application step .

  14. 介绍了影响SBS改性乳化沥青生产的因素,分别从SBS改性沥青、乳化剂、乳化沥青生产工艺、乳化沥青生产设备等几个方面进行了探讨。

    Discussion on factors affected the production of SBS modified emulsified asphalt from SBS modified asphalt , emulsifier , production process and equipments for emulsified asphalt ect .

  15. 简述改性乳化沥青的生产方法并介绍了一种生产SBS改性乳化沥青的新技术。

    The production methods of modified emulsion are discussed in this thesis and a kind of new technique for SBS modified emulsion production is put forward and introduced in details .

  16. 采用SBR改性乳化沥青、SBS改性沥青和日本环氧粘结剂三种层间粘结剂,利用直剪试验和拉拔试验进行层间抗剪性能分析,可以推荐出适合不同条件的粘结层材料。

    Adhesive layer materials for different conditions may be recommended by using of direct shear test and pullout test with SBR modified emulsion asphalt , SBS modified asphalt and Japan epoxy binder .

  17. 得到了以下结论:液/非复合乳化剂(7∶3)制备SBR改性乳化沥青,乳液质量最好;

    And the results was made : the modified emulsified asphalt with SBR was the best prepared , using the compound emulsifier mixed by the proportion of 7 ∶ 3 between positive emulsifier and nonionic emulsifier .

  18. 微表处技术作为主要的养护措施虽然已经在国内得到了大力推广,但是目前所使用改性乳化沥青多采用SBR胶乳为改性剂,品种单一,高温稳定性不够理想。

    The micro-surfacing technology as the main maintenance measures though has vigorously promoted in the domestic , at present the modification emulsified asphalt mostly using modifying agent as SBR latex , it is single in species , and insufficiently ideal in a high temperature stability .

  19. 氮丁胶乳改性乳化沥青的软化点约54℃,5℃延度约16cm,与高温聚合型丁苯胶乳大致相当。

    Performance of asphalt emulsion modified by CR latex was similar with high-temperature polymer SBR latex-softening point about 54 ℃ , ductility of 5 ℃ about 16 cm .

  20. 结果表明:在聚合物加入量3%的情况下,高温聚合型丁苯胶乳改性乳化沥青的性能较差,其蒸发残留物的软化点低于55℃,5℃延度小于20cm;

    It was found that , with 3 % polymer , performance of the asphalt emulsion modified by high-temperature SBR latex was not satisfied , its softening point was under 55 C , ductility of 5 ℃ was below 20 cm .

  21. 而低温聚合型丁苯胶乳改性乳化沥青的性能较好,其蒸发残留物的软化点在56~60℃,5℃延度大于150cm;

    But performance of the asphalt emulsion modified by low-temperature polymer SBR latex was better , its softening point was between 55-60 ℃, ductility of 5 ℃ submit 150 cm .

  22. 水泥改性乳化沥青混凝土力学性能与微观机理

    Mechanical Properties and Microcosmic Mechanism of Cement Modified Asphalt Emulsion Concrete

  23. 改性乳化沥青-水泥就地冷再生混合料性能研究

    Research on Performance of Modified Asphalt Emulsion-cement Cold In-place Recycling Mixture

  24. 改性乳化沥青做高速公路下封层试验

    Experiment on Sub-sealing Course by Modified Emulsified Bitumen in Highway

  25. 浅议改性乳化沥青稀浆封层

    Simply Talking about Slurry Seal Coat of Modified Emulsified Asphalt

  26. 从理论上确定了改性乳化沥青的研究方向。

    Theoretically determine the direction of research on the modification emulsified asphalt .

  27. 改性乳化沥青下封层施工质量控制

    Construction Quality Control of Under-sealed Layer for Modification Emulsified Asphalt

  28. 改性乳化沥青稀浆封层技术质量控制要点

    Essentials in the Quality Control of Slurry Sealing with Modified Emulsified Asphalt

  29. 复合式改性乳化沥青稀浆封层技术的实验研究

    Compound Modified Emulsion Asphalt slurry Seal Coat Technology Research

  30. 转相法低温丁苯胶乳改性乳化沥青的制备

    Styrene-butadiene rubber latex modified bitumen emulsions prepared by phase inversion in low temperature