回溶

低碳微合金钢中Nb、Ti碳氮化物的回溶行为研究

Dissolution Behavior of Nb , Ti Carbonitride Precipitates in Low Carbon Microalloyed Steel

VC在100小时之前略有增加，之后又有回溶，且颗粒长大；

VC slightly increased up to 100h exposure and then dissolved back with VC particle growing ;

V-Ti微合金钢中，Ti的加入对于V的回溶具有拖曳作用。

The dissolution of V in V-Ti microalloyed steel is restrained by Ti .

强塑性变形下Al-Cu合金不同析出相的回溶及性能变化

Re-dissolution and Evolution of Properties of Different Precipitated Phases in Al-Cu Alloy under Severe Plastic Deformation

采用双向反复压缩变形研究了Al-Cu合金中不同析出相的回溶速度及性能变化。

The speed of re-dissolution and changes of properties of different precipitated phases in Al-Cu alloy are studied using double-directional alternative compress deformation .

XRD分析显示强塑性变形引起SWRH72A钢丝中渗碳体回溶，部分碳原子溶入铁素体形成过饱和铁素体，过饱和铁素体中含碳量约0.34at%。

The XRD analysis shows that severe plastic deformation causes partial of cementite decomposition and dissolution of carbon into ferrite up to 0.34 at % .

结果表明：在强塑性变形过程中，GP区回溶的速度最快，介稳相（θ〃+θ′及θ′）次之，稳定相（θ）最慢。

It is obtained that the speed of re-dissolution of GP zone is the fastest , that of metastable phase (θ″ + θ′ and θ′) is second , and that of equilibrium phase (θ) is the slowest during severe plastic deformation .

减少聚合物阵列波导光栅损耗的蒸气回溶技术

Steam-Redissolution Technique for Reduction of Polymer / Si Arrayed Waveguide Grating Loss

微合金钢中常见析出相的回溶规律的研究

Study on Dissolution Rule of Precipitate Phases in Microalloyed Steel

赤砂糖回溶糖浆澄清脱色方法的研究

Researches on Decolorization of Remelt Syrup of Brown Granulated Sugar

双级固溶处理综合了低温单级固溶和高温单级固溶的优点，即再结晶晶粒尺寸较小，同时回溶颗粒较多。

The two-stage solution treatment has the advantages of low and high temperature single solution .

室温强塑性变形下回溶和再析出的机理研究

Mechanism of re-dissolution and re-precipitation of second phases in Al-Zn-Mg-Cu alloy under severe plastic deformation

研究强塑性变形过程中第二相回溶现象的现状及发展趋势

Current Situation and Development of the Research on Re-Dissolution of Second Phases During Severe Plastic Deformation

以粉体粒径为指标，确定氨水回溶成胶法为最佳制备方法。

In the view of particle size , sol-gel method by ammonia dissolving is the best preparation method .

原糖直接回溶饱充套种煮糖的炼糖新方法

New Sugar Refining Method : Direct Carbonation of Raw Sugar Remelt without Affination and Four-Boiling Double Magma System

综述了在室温强塑性变形过程中发现的新现象：第二相颗粒的回溶，合金基体重新形成过饱和固溶体。

A new phenomenon of re-dissolution of second phases and re-formation of supersaturate solid solution found in processes of severe plastic deformation was summarized .

在剧烈塑性变形过程中合金中第二相粒子的低温回溶是一个很重要的微观现象，对时效强化轻合金制定新的热处理工艺具有潜在的重要意义。

The re-dissolution of the second phase particles during severe plastic deformation ( SPD ) is a significant micro-phenomenon , which is of significance for developing a new heat-treatment technique of age hardening alloy .

本文主要论述了福建漳州糖厂利用原有设备，采用原糖不复筛直接回溶进行碳酸饱充脱色和四系套种煮糖的炼糖方法，生产出口优级白砂糖。

Superior white sugar for export is produced in Zhangzhou Sugar Mill with a new sugar refining method , i.e. direct carbonation of raw sugar remelt without affination and using four-boiling double magma system for industrial sucrose crystallization .

在1100℃持久蠕变过程中合金组织发生显著变化，γ相聚集回溶成高位错密度的胞状组织，对合金仍起强化作用。

In the process of protracted creep at 1100 ℃ microstructure of the alloy changed distinctively into circular structure of high dislocation density because of the Y phase coalescence and resolution , it still had a strengthening effect to the alloy .