回弹性

  • 网络Resilience;resiliency;rebound resilience;Rebound elasticity
回弹性回弹性
  1. 研究结果表明:加入PP时,材料的拉伸强度、熔体流动速率和压缩永久变形增大,但其断裂伸长率迅速下降,回弹性逐渐降低;

    The results showed that in case of adding PP , the tensile strength , melt flow rate and compression set of the SEBS increase , but the elongation at break decreases quickly and the elastic resilience decreases gradually ;

  2. 随纳米CaCO3含量增多,拉伸强度下降,扯断伸长率单调下降,体系100%定伸应力和硬度增大,回弹性降低。

    With the content of CaCO_3 increasing , tensile strength first increased and then dropped , elongation at break decreased , 100 % tensile modulus and Shore A hardness increased and impact resilience got weaker .

  3. W形金属柔性石墨缠绕垫片的回弹性高出国标十几个百分点,达到了国际先进水平。

    Recovery performance of W-shape matallic flexible graphite spiral wound gasket exceeds over ten percentage on nation standard and reaches international advanced level .

  4. 通过对树脂、催化剂、添加剂等助剂以及工艺条件的研究,摸索出一套纯棉高支织物PP整理的加工方法,使之加工的衬衫缩水率<0.5%,回弹性。

    The influence of resin , catalyst , additives as well as process conditions were researched on permanent press ( PP ) finishing of high counts pure cotton fabric .

  5. MC尼龙(单体浇铸尼龙)具有质量轻、不产生噪音、机械性能好和良好的回弹性等独特性能。

    MC nylon , is called monomer casting nylon . MC nylon has lots of very good properties , such as light quality , no noise and good mechanical properties , and so on .

  6. 随CHDM含量的增加,共聚酯结晶性能下降,纤维强度下降。共聚酯纤维具有优异的弯曲回弹性和染色性能,且随CHDM含量的增加而提高。

    The crystallization ability of PETG copolyester and its fiber strength decrease with the increasing of CHDM content .

  7. 介绍了超细玻璃纤维(AGM)隔板性能对密封铅酸电池性能的影响,包括基重和厚度的均匀性、回弹性和压缩率、孔率和吸酸量、孔径、电阻、杂质等。

    Effects of the specificity of AGM separators on the performance of sealed lead-acid batteries were introduced , including the uniformity of basis weight and thickness , elasticity and compressibility , porosity and absorption , pore-size , electrical resistance , impurity , etc.

  8. 乳液共沉胶的拉伸强度、撕裂强度、硬度、回弹性等与SBR1502基本相当,扯断伸长率和压缩永久变形有所增大,耐磨耗性能大幅度提高;

    The SBR / OMMT nanocomposites had similar tensile strength , tear strength , hardness and resilience to SBR1502 , while the elongation at break , compression set and abrasion properties were higher .

  9. 提高中空涤纶短纤维压缩回弹性生产技术研究

    Techniques of Improving the Compression Elasticity of Polyester Hollow Fibers

  10. 塑性形变和蠕变是很不利的,回弹性则是有利的。

    Plastic deformation and creep are highly undesirable , resilience is favourable .

  11. 可靠性、回弹性、脆弱性在水资源系统中的应用

    A Study and Application of Reliability , Resilience . Vulnerability of Water Resources System

  12. 其容重比板材轻,有良好的回弹性,价格便宜,施工方便。

    Its bulk density than plank light , good recovery , cheap price , construction is convenient .

  13. 接枝改性胶乳硫化胶膜的回弹性优于共混改性的,且其有更好的耐疲劳性能。

    And the better bounce impact elasticity and antifatigue property were attained by the grafted latex vulcanized film .

  14. 竹纤维具有优良的着色性,色彩鲜艳,悬垂性好,回弹性和耐磨性比粘胶好。

    Bamboo fiber has excellent color , colorful and draping , resilience and abrasion resistance than viscose fibers .

  15. 金属波纹垫片是一种传统的密封元件,具有制造简单、回弹性好、整体性好的特点。

    Metal corrugated gasket is a traditional sealing element , and has the features of simple fabrication , good resilience and good integrality .

  16. 泡沫稳定剂用量增加,微孔弹性体的机械强度和回弹性均升高,扯断伸长率也稍有升高。

    The increase of foam-stabilizer would make both the mechanical strength and resilience / resiliency increased and the elongation at break also increased slightly .

  17. 聚酯/粘胶共混织物&平纹竹节呢用1%的该硅乳整理,烘干、定型后则具有柔软滑爽的手感和良好的回弹性。

    Polyester / rayon blends are padded with above emulsion , dried , cured , give the fabrics with soft hand 、 smoothness and good elasticity .

  18. 它具有柔软的手感、优异的回弹性、易染性、易保养性等诸多特点,这都是它用于纺织面料的优势所在。

    To be a textile fiber , PTT has plenty of advantages such as soft handle , excellent elastic recovery property and dying characteristic , easy care etc.

  19. 经过热定形的织物在使用时能够抗折皱,可以免烫,其原因是纤维的回弹性和弹性的改变。

    Heat setting gives cloth resistance to wrinkling during wear and the ease - of - care properties that may be attributed to improvements in resiliency and elasticity .

  20. 统计结果表明:果岭光滑度与草坪密度、盖度、颜色、质地呈负相关关系,与均一性和回弹性呈正相关关系。

    Green speed has a positive linear correlation with turf uniformity and rebound elasticity , while a negative correlation with turf density , coverage , color and texture was found .

  21. 而不同的前处理加工对织物风格如拉伸线性度、回弹性、弯曲刚度、剪切特性、压缩功、表面粗糙度、膨松性等影响各异。

    Different pretreatment process can differently affect fabric style such as drawing linearity , elastic resilience , bending rigidity , shearing characteristic , compression work , surface roughness , bulkiness etc.

  22. 隔板的回弹性和压缩率是电池实现紧装配的保证,也是电池内隔板与极板有较好紧贴效果的保证;

    The elasticity and compressibility is the warranty of realizing the battery being tightly assembled , and it is also the warranty of separator clinging to the battery plates tightly ;

  23. 试验了810酯用量比对材料硬度、拉伸强度、断裂伸长率、回弹性、热失重、熔体流动速率的影响。

    The effect of dosage of 810 ester on rigidity , tensile strength , breaking extension , rebound elasticity , heat weight loss , flow rate of fused mass were studied .

  24. 此外,碱改性可使麻纤维发生物理化学变化和结构变异,从而改善麻纤维的回弹性、柔软度和抗皱性能。

    In addition , t he modified kender with alkali gives rise to the variation of physical chemical properties and structure , and this improves elasticity and softness and wrinkle resistance of kender .

  25. 应用结果表明,反应性氨基硅油整理后的织物有优异的柔软性、滑爽性、回弹性以及很高的耐洗性,对整理织物的白度影响很小。

    The application results showed that the fabrics finished with the reactive amino-silicone oil had excellent softness , smoothness , elasticity and high durability in home laundering , and produced little influence on the finished fabric whiteness .

  26. 发泡剂用量增加,微孔弹性体的机械强度、回弹性先剧烈下降,当用量大于2%时又略有上升或下降缓慢。

    The increase of addition amount of foaming agent makes the mechanical strength and the resilience / resiliency of cellular elastomer decreased violently at first and , when that amount becomes greater than 2 % , it increased slightly or decreased slowly .

  27. 首先建立了供水水库群的优化调度模型,然后对度量风险的可靠性、脆弱性、回弹性、事故周期等指标作了论述。

    In which the optimal operation model for a group of water supply reservoirs is developed at first , and then the indexes for the risk estimation , such as reliability , frangibility , resiliency and the accident periods etc. are discussed .

  28. Ln-BIR硫化胶的回弹性和耐寒性随Bd/Ip(摩尔比)的增加而增加,耐磨性在谊值为40/60~50/50时出现峰值;

    With increasing the Bd content in the copolymers , the resilience and low temperature resistance increased , wet skid index decreased , while the abrasion loss appeared a peak at 40 / 60 - 50 / 50 ( molar rate ) of Bd / Ip .

  29. 在相同固结压力下,淤泥及淤泥质土比粘性土、砂土表现出更为明显的回弹变形滞后性。

    Under the same consolidation pressure , the hysteresis of mucky soil is much more obvious than clay and sandy soil . 4 .

  30. 筋条的塑性变形既有凸模下压导致的塑性变形,又有蒙皮回弹导致的塑性变形;

    The plastic deformation on ribs caused by punch push down and skin springback .