分解电压

电动势法测定冰晶石-氧化铝熔体中Al2O3的平衡分解电压

Measurement of Equilibrium Decomposition Voltage of A1_2O_3 in Cryolite-Alumina Melt by EMF Method

添加TFP对电解液的分解电压没有影响。

The decomposition voltage of the electrolyte was not effected by adding TFP .

求得的乙醛酸理论分解电压Ed接近为一常数（-1.00v）。

The theoretical decomposition potential of glyoxalic acid could be a constant ( -1.00 V ) approximately .

通过热力学计算，得到了TiO2逐级还原各阶段的理论分解电压。

Through thermodynamics calculation , theoretical decomposition voltages about step-by-step reduction of TiO_2 have been achieved .

结果表明，采用惰性阳极，理论分解电压按Nd2O3、NdF3、LiF顺序依次增大，温度升高，理论分解电压降低；

The results indicate that the EMF in inactive anodes increases in sequence of Nd 2O 3 , NdF 3 and LiF , and that it drops with rising of temperature .

水的理论分解电压是1.23v，而将氢气和氧气的过电位考虑进去，实际所需电压在2V左右，对半导体光催化材料有比较苛刻的要求。

The theoretical splitting voltage of water is 1.23 V , while the practical voltage is about 2.0 V taking the over-potential generated from oxygen and hydrogen redox into account . Water splitting takes serious requirements to the property of semiconductors .

钕电解相关物质理论分解电压的计算

Theoretical Decomposition Voltage for Some Related Substance on Neodymium Electrolysis

氧化镝、氟化钠分解电压的测定及其热力学分析

The Measurement of Decomposition Voltage for Dysprosium Oxide and Sodium Fluoride and the Thermodynamical Analysis

参数包括离子电导率，电子电导率，迁移数和分解电压等。

And the parameters include ionic specific conductivity , electronic specific conductivity , transference number and decomposition potential and so on .

采用熔盐电化学还原理论，计算并分析了理论分解电压和金属的的电极电位。

In this paper , according the theory of molten salt electrolysis , the decomposition voltage molten salt and the electrode potential of the metals were calculated and analysised .

前者包括反应自由焓、平衡常数、最大产量、气相分压以及熔盐电解理论分解电压的计算；

The former includes the calculation of reaction free enthalpy , equilibrium constants , maximum output , gaseous phase partial pressure and theoretical decomposition voltage of molten salt electrolysis .

在达到金属分解电压或沉积电压后，溶解或沉积的电极反应速度取决于单个脉冲宽度内通过的电量，同时还受脉冲电源占空比的影响。

After reached the dissolved voltage or deposited voltage , the machining rate lied on the energy during the pulse on time , and it also was influenced by the duty ratio of pulses power supply .

随后，在基于分解电压测量量和功率测量量的估计算法的基础上，对状态估计中经常出现的变压器抽头位置问题和零阻抗支路潮流估计问题进行了分析和处理；

Then , based on the estimation algorithm decomposing the measurement of voltage scope and power scope , the problems of the location of transformation tap settings and the tide current estimation of Zero-Impedance branches in state estimation are solved ;

快离子导体的导电离子种类、导电率、离子输率、分解电压值的正确测定，是综合判定快离子导体性质及其应用前景的重要前提条件。

The important Prerequisite of judging the character of super ionic conductor synthetically and its application prospect is to determine correctly the type of electric conducting ion , the electric conductivity , ionic conducting rate and decomposition voltage of any super ionic conductor .

基于LDU分解的电压稳定指标与负荷节点灵敏度的关系

Relationship Between Static Voltage Stability Index Based on LDU Factorization and Load Bus Sensitivity

基于希尔伯特振动分解的电压闪变检测新方法

Novel method for detection of voltage flicker based on Hilbert vibration decomposition

为解决多电平逆变器的空间矢量调制（SVM）算法设计及实现的复杂性问题，提出了基于参考电压分解和零序电压等效的新型多电平SVM算法。

A simple , fast , and generally applicable multilevel space vector modulation ( SVM ) algorithm is described in this paper . The complex reference voltage vector is decomposed into an offset vector and a two-level model .

基于静态等值和奇异值分解的快速电压稳定性分析方法

Fast voltage stability analysis methods based on static equivalence and singular value resolution

考虑负荷静特性的基于奇异值分解法静态电压稳定分析

Application of Singular Value Decomposition Method to Static Voltage Stability Analysis Considering Static Load Model

提出了基于Hankel矩阵奇异值分解技术的短时电压扰动检测与定位方法。

For the start point , the time-stamp is very exact . ( 3 ) A detection and time-stamp method of instantaneous voltage disturbances based on Hankel matrix singular value decomposition is proposed .

醇类，有机酸等其中许多有机物的分解与水相比，所需能量相对要低，则其分解电压也将低于水。

Decomposing of some alcohols and organic acid needs less energy than that of water , which means lower the splitting voltage can be obtained .