首页 / 词典 / good

保温

bǎo wēn
  • heat preservation;insulation work;keep warm;preserve heat
保温保温
保温 [bǎo wēn]
  • [preserve heat;heat preservation] 保持温度使热不散出去或传进来

  • 积雪可以保温保墒

保温[bǎo wēn]
  1. 术后行灯光照射保温,并加强营养。术后24h颈静脉抽血,并行水迷宫及旷场实验。

    Postoperative lights and insulation to keep warm , and enhance nutrition.24h after the operation draw the blood , then measured them by the means of Morris water maze and open field test .

  2. 此工艺参数为压制压力:200Mpa,烧结温度:870℃,保温时间120分钟;

    This technology parameter is to suppress pressure : 200 Mpa . sintering temperature : 870 C , keep warm time 120 minutes ;

  3. 她做了三明治,把保温瓶灌满,又放了糖进去。

    She made sandwiches , filled a flask and put sugar in

  4. 四五个男人在喝保温瓶里的茶水。

    Four or five men were drinking tea from flasks .

  5. 水箱和屋顶都需要敷设严密的保温层。

    Water tanks should be well lagged and the roof well insulated .

  6. 把土豆倒在一个保温的盛菜用的盘子里。

    Pile potatoes into a warm serving dish .

  7. 如果加盖放在暖和的地方,这些米饭可以保温足足一个小时。

    If left covered in a warm place , this rice will retain its heat for a good hour .

  8. 这种容器保温性能很好。

    This container has good heat-retaining properties .

  9. 瓷器盘子比金属盘子保温时间长。

    China dishes retain heat longer than metal pans .

  10. 这种方法近年来在欧美和日本得到推崇,但在中国尚未普及,更常见的是早产儿一出生就“住进了”保温箱中。

    KMC has been widely used in the US , Japan and Europe , yet in China premature infants are often put in incubators from birth .

  11. 墙体保温迫在眉睫配筋砌块砌体剪力墙构件CAD的研究与开发

    The Research and Design of the Reinforced Concrete Masonry Shear Wall Element CAD

  12. 采取提高熔化温度降低保温时间的措施可以降低Al的挥发烧损。

    Volatilization loss of Al element can be decreased by increasing melting temperature and shorten holding time .

  13. SAC外墙内保温砂浆施工技术及应用

    Construction technology of SAC inner insulating sand pulp for external wall and its application

  14. EPS外墙外保温节能体系的概念设计与应用

    The conceptual design and application of the energy-saving system of EPS outer-wall warm-keeping and weight-bearing buildings

  15. 外墙外保温应用PG复合板

    Exterior Wall External Insulation Uses PG Composite Panel

  16. 对于Si3N4-MoSi2复相陶瓷,在1100℃保温时质量变化很小,其氧化动力学曲线没有明显的规律性;

    As for Si_3N_4-MoSi_2 ceramics , when held at 1100 ℃, there is no significant weight change .

  17. 在分析最优保温结构的基础上,第一次提出了临界热绝缘层数N(c(?)

    Furthermore , the author , for the first time , presents the idea of Critical Insulation Layer Number ( CILN : N_ ( er )) . The number of C.

  18. 涂层层数和保温时间对纳米TiO2薄膜显微结构的影响

    Coating ; Effect of coating layer number and soaking time on microstructure of nanometer TiO_2 film

  19. SiO2气凝胶柔性保温隔热薄膜

    SiO_2 aerogel flexible heat insulation film

  20. 泡沫-EPS保温砂浆是以聚苯乙烯(EPS)颗粒和大量微气泡配制而成。

    Foamed EPS thermal insulation mortar is made from polystyrene ( EPS ) grain and large amount of micro-bubbles .

  21. 利用XRD、SEM等测试手段,研究了不同保温时间对各种掺量的粉煤灰烧结砖的显微结构及性能的影响。

    The effect of sintering time on the microstructure and properties of various flyash content fired brick was studied by XRD , SEM and so on .

  22. 环合反应温度为195°C,然后在此条件下保温5h是较好的工艺参数;能获得高产率的丁二酰亚胺。

    The cyclization reaction temperature was 195 ° C and this temperature was maintained for 5h , the yield of succinimide was good .

  23. 结果表明:合成温度900℃保温2h后,可以得到钙钛矿结构。

    The results show that a pure perovskite structure is obtained after synthesis at 900 ℃ for 2 h.

  24. 利用中间添加Ni层,在610℃保温60min工艺成功实现了SiCp/2014Al铝基复合材料的真空扩散焊接。

    SiC_p / 2014Al aluminum matrix composite was welded by vacuum diffusion welding technique using Ni as the interlayer metal .

  25. PU硬泡是一种集保温隔热、防水性能于一体的新型屋面材料。

    PU rigid foam is a kind of mew roof material incorporating properties such as thermal protection , heat insulation and water repellency .

  26. 在N2气氛中以粉煤灰为原料,采用碳热还原氮化工艺制备了β-Sialon粉体,研究了碳含量、合成反应温度、保温时间和氮气流量等因素对生成物物相的影响。

    β - Sialon powder was prepared from fly ash and carbon black via carbothermal reduction nitridation in this study .

  27. 随着烧结温度的提高和保温时间的延长,Nd∶YAG陶瓷的密度增大,晶形发育完整,透过率提高。

    The density of the ceramics increases , and the transmittance improves gradually with the increase of the sintering temperatures and the prolonging of the holding time .

  28. 分析了施主、AST相、烧结温度、保温时间对材料复阻抗特性的影响。

    The effect of donor 、 AST phase 、 sinter temperature and sinter time on complex impedance property have been analyzed .

  29. 用自制的保温式多功能离子热处理炉对45钢进行了离子氮碳共渗+离子后氧化双重复合处理(Ion(NC+O)复合处理)。

    The duplex treatment of plasma nitrocarburizing plus post oxidation ( Ion ( NC + O ) duplex treatment ) was carried out in a self-made heat isolated type of multipurpose plasma heat treatment furnace .

  30. 并讨论了小牛白蛋白(BSA)的初始质量浓度、反应体系温度、溶液离子强度、pH以及吸附保温时间对Fe3O4/PAM微球吸附蛋白质的影响规律。

    The effects of concentration of BSA , reaction temperature , ion intensity , incubation time and pH on the adsorption on ferrite / polyacrylamide were discussed .