测量信号
- 网络Measurable Signal;measurement signal;Ilamp
-
其测量信号是经过TA末屏电压信号放大器引入谐波信号数字测量分析系统的。
Its measurement signal is to lead into harmonic signal digital measurement analysis system via TA end screen voltage signal amplifier .
-
文章对基于广域测量信号的可控串补(ThyristorControlledSeriesCompensator,TCSC)系统进行了分析,建立了基于广域测量的TCSC系统模型。
The authors analyze the wide-area measurement signal based thyristor controlled series compensator ( TCSC ) system , establish a TCSC system model based on wide-area measurement .
-
采用16位AD转换器,提高测量信号的分辨率。
A 16 bit AD converter is used to improve the resolution .
-
线阵CCD尺寸测量信号的提取
Signal extraction of line scan CCD used in dimension measurement
-
以CCD获取测量信号为基础的激光三角法测量技术被广泛运用于物体的非接触式测量。
The triangular laser measuring technique based on CCD is widely used in non-contacted measuring requirements .
-
针对模糊控制技术进行了无人机控制算法研究,对于姿态测量信号以及导航信息,利用了卡尔曼滤波的方式进行了数据处理,并进行了GPS/惯性导航的组合导航技术的研究;
Using the fuzzy control on the control methods , and apply the KALMAN filter wave on the measured information and combined navigation ;
-
在GPS定时接收机的研制过程中,需要测量信号的时延,以便进行校准提高接收机的性能。
It is necessary to survey the delay of signal in order to calibrate and improve the performance of GPS Timing Receiver on the development of GPS Receiver .
-
对GPS动态形变测量信号的性质进行了分析,采用小波分析对GPS动态变形数据滤波、变形特征提取和不同变形频率分离。
By analyzing the data obtained by GPS in dynamic deformation , wavelet analysis is used to filter GPS data of dynamic deformation , distill deformation character and separate different frequency of deformation .
-
分析表明广域反馈具有相位稳定的特点,可以根据参与因子和传递函数留数选取广域测量信号,通过模式辨识进行2级PSS控制,抑制区间低频振荡。
The phasor of global feedback is stable . Global measurement signal is selected according to participation factor and residue of transfer function and PSS is configured by mode analysis .
-
对MEMS陀螺仪测量信号的仿真结果表明:算法只需更短的处理时间就可以完成去噪声过程,并且可以取得同样的去噪效果。
Simulation results of the MEMS ( micro-electro mechanical systems ) gyroscope drift signal show that the algorithm spends much less processing time to finish the de-noising process than the usual WT. And the de-noising effect is the same .
-
为分析气液两相流差压信号的内在特征,提高测量信号的信噪比(SNR),提出了一种基于小波变换和高阶统计量的信号分析方法。
A novel signal analytical method based on wavelet transform and higher-order statistics was presented for analyzing the intrinsic characteristics of differential pressure signal of gas-liquid two-phase flow and enhance the signal to noise ratio ( SNR ) .
-
重点讨论了分布式温度测量信号的特点,根据这些特点选择合适的小波函数,并借用信息论中Shannon熵的概念,提出了根据信息熵的大小确定小波分解层数的方法。
The characteristics of distributed temperature measurement signal were discussed first . Then , how to select proper wavelet functions was emphasized as well as how to ascertain the levels of wavelet decomposition by means of Shannon entropy .
-
本文利用广域测量信号为输入设计SVC的附加阻尼控制(PSDC)。
This paper describes a systematic approach to design a SVC supplementary controller for improving the damping of power system oscillation ( PSDC ) based on wide area signals .
-
提出了适用于多元校正滴定分析的误差传递率(REP)的概念,其定义为待测物预报的标准差与测量信号的标准差之比。
According to the multivariate calibration titration , a concept of the ratio of error propagation ( REP ) is proposed , whose definition is the ratio of the standard deviation of the prediction of analyte and that of the measured signal .
-
在海洋水色遥感中,瑞利散射占大气顶(TOA)处测量信号的绝大部分,作为大气修正的第一步,必须精确计算瑞利散射的贡献,并从总信号中去除。
In ocean color remote sensing , Rayleigh scattering dominates the signal measured at the top-of-atmosphere ( TOA ) . Therefore , as the first step in atmospheric correction , Rayleigh scattering item must be computed accurately and removed from the sensor measured total signal .
-
结合本课题的性能要求,在系统建模仿真时采用傅里叶变换的方法测量信号的中心频率,以其值作为NCO的控制输入,完成对NCO的控制。
According to the subject of performance requirements , used in system modeling and simulation of Fourier transform method for measuring the center frequency of the signal , with its value as a control input of the NCO , complete control of the NCO .
-
521双感应球形聚焦测井仪原有的变感器电路和1kHz振荡电路用导线连接的多个分立元器件构成,导线之间的干扰大,对测量信号处理有很大影响。
Because the original varindor circuit and the 1 kHz oscillator of 521 Dual Induction-Spherically Focused Logging Tool consist of isolate circuit elements connected by wires , the interference among the wires affects the processing of the measured signal .
-
应用表明,高炉由改造前的平均每年发生料位测量信号故障7.7次、休风12.8h、慢风41h,达到零故障。
The application has proved that the trouble ratio has been up to zero from producing burden level signal trouble 7.7 times , wind off 12.8h , slow wind 41h mean every year before reforming of BF .
-
利用滑动窗口法改善测量信号的示值稳定性
Improvement of indication stability of measuring signal by slip window sampling
-
精确测量信号频率的一种简易方法
A Simple Method for the Accurately Measuring of Signal Frequency
-
最后用软件细分法对测量信号进行高倍数数字细分。
Finally , digital subdivision is adopted to obtain high division number .
-
软件滤波解决测量信号的稳定性。
The software filte improve the reliability of signal measurement .
-
非线性自适应统计滤波器在声测量信号处理中的应用
Non-linear adaptive statistics filters for acoustic signal processing in non-Gaussian noise environment
-
最后给出对实际测量信号的处理结果。
Finally , The processing results of practical measurement signals are given .
-
河流流速测量信号处理电路的优化设计
Optimization Design of Signal Processing Circuit for River Velocity and Discharge Measurement
-
由电磁测量信号估算平衡磁面
Calculation of equilibrium magnetic surface using measured electro-magnetic signals
-
在线表面粗糙度外差干涉仪中测量信号的自动电压控制
Implementation of Automatic Voltage Control of Online Heterodyne Interferometer for Measuring Surface Roughness
-
计算机控制的在线智能酸度测量信号采集问题研究
Study on Problem of Signal-collecting in Computer Intelligent PH-meter
-
雷达侦察设备测量信号极化的方法
Measuring methods of singal polarization in radar reconnaissance device
-
利用潜油泵电机的电力线传送测量信号是一种新型油田井下压力测量方法。
A new pressure measuring method applying in deep oil-well is as follows .