脱壳

tuō qiào
  • decladding;shucking

脱壳

tuō ké
  • decorticate;unshell;shell
脱壳脱壳
脱壳[tuō ké]
脱壳[tuō qiào]
  1. 松籽脱壳工艺及主要设备的工作原理

    The Shell & process of Pinenut and the Principle of Main Equipments

  2. 新型板栗脱壳机及其技术经济分析

    New Machine of Cutting Chestnut 's Shell off and Its Technologies Economical Analysis

  3. 产品说明:注:该机即可用于咖啡脱壳亦可用于碾米。

    Note : machine be used in both coffee hulling and rice milling .

  4. 注:该机即可用于咖啡脱壳亦可用于碾米。

    Note : The machine be used in both coffee hulling and rice milling .

  5. 采用TVD有限体积格式对尾翼稳定脱壳穿甲弹弹托脱落时的流场进行了数值模拟。

    Using TVD finite cubage format , the numerical simulation of APFSDS sabots discatding is proceeding .

  6. 阻力型APFSDS脱壳过程参数优化设计

    Optimum seeking parameter of drag type 's APFSDS during sabot discard

  7. 尾翼稳定脱壳穿甲弹(APFSDS)是杀伤地面装甲目标的利器。

    APFSDS is the main weapon that kills the armor target in battlefield .

  8. MS-1型白瓜籽脱壳机上料排序装置原理

    Principle of Loading and Sequence Installation on MS 1 Pumpkin Sheller

  9. 菜籽多酚的抗氧化作用APFSDS脱壳非对称性研究

    Antioxidation of polyphenol from rapeseed A Study about the Asymmetry in the Sabot Discard Process of APFSDS

  10. 本文以30mm尾翼稳定脱壳穿甲弹为研究对象,对其膛内发射动态强度、振动特性和结构优化设计问题进行了系统而深入的理论分析、数值模拟和计算研究。

    This thesis presents theoretic analysis , numerical simulation and calculational studies on dynamic launching strength and vibration analysis during launching and structure optimization design of 30 fin-stabilited sabot-discarded penetrator .

  11. 三种必需脂肪酸(18∶2,18∶3,20∶5)EFA含量:成体为16%,幼体21%,脱壳卵26%;

    For three necessary fatty acids , the content of EFA ( 18 : 2 , 18 : 3 , 20 : 5 ) of adult brine shrimp is 16 % and that of nauplius and decapsulated eggs is 21 % and 26 % respectively .

  12. 脱壳后的栗仁与带壳板栗不同,呼吸强度明显增加,耐贮性下降,在常温下30d腐烂率达10%~13%,褐变率为15%~18%,并出现了发芽现象。

    Chestnut kernel with higher respiration rate than that of chestnut fruit reflected its more difficulty in preservation . The rot rate was 10 % to 35 % , and the browning rate was 15 % to 18 % , after stored at room temperature for 30 days .

  13. 结论在PEH组织中丧失分化和表皮结构形成能力的表皮基底细胞呈脱壳样与原细胞浆膜结构分离,是基底细胞去分化的典型形态特征。

    Conclusion The loss of the ability of differentiation and epithelial formation and the harvest of the capability of brooding from former plasmalemma ' nutshell ' of original epithelial cells might be the typically morphological characteristics of the dedifferentiated basal cells in PEH .

  14. 三种高级不饱和脂肪酸(20∶2,20∶4,20∶5)HUFA含量:成体近8%,幼体和脱壳卵均超过20%;

    For three unsaturated fatty acids , the content of HUFA ( 20 : 3 , 20 : 4 , 20 : 5 ) of adult brine shrimp is nearly 8 % , and that of both nauplius and decapsulated brine shrimp eggs exceeds 20 % .

  15. 花生脱壳机的不同部件对脱壳性能的影响

    Effects of different parts of peanut huller on the hulling performance

  16. 谷类或干豆类植物脱壳机,工业用

    Husking machine , industrial , for cereals or dried leguminous vegetables

  17. 通过试验,找出壳法制芯脱壳的原因。

    The causes of shell hulling have been found through experiment .

  18. 响应曲面法优化气体射流冲击锥栗脱壳工艺

    Optimization of Air-impingement Shelling for Castanea Henryi Using Response Surface Methodology

  19. 油茶籽脱壳制油工艺的研究与实践

    Research and application in oil processing of camellia oleosa seed dehulling

  20. 带壳物料脱壳方法及脱壳装备现状与分析

    Actuality of the Decladding Method and Sheller of Shell Fruit

  21. 银杏脱壳的有限元受力分析

    Analysis of finite element method for threshing gingko fruit shell

  22. 基于有限元分析的核桃脱壳技术研究

    Technology for breaking walnut shell based on finite element analysis

  23. 气爆式花生脱壳性能的试验研究

    Test Study on Performance of Peanuts Shelling by Gas Burst

  24. 油茶籽脱壳机的研制与应用

    Research and application of dehulling machine for camellia oleosa seed

  25. 弹托前端结构对脱壳性能的影响

    Effect of Sabot Leading Edge Structures on Sabot Discarding Performance

  26. 覆膜砂脱壳性检测方法;

    Test method of peel back resistance of coated sand ;

  27. 从脱壳大麦中提取和纯化β-葡聚糖的研究

    Extraction and Purification of β - Glucan from Hulled Barley

  28. 蛇会脱壳,但决不会改变它的本性。

    A snake can peel , but it never changes its nature .

  29. 尾翼稳定脱壳弹脱壳时的R/W理论模型

    R / W Theory Model of APFSDS in Sabot-Discard Period

  30. 高速脱壳穿甲弹的中间弹道研究

    Intermediate Ballistic Research of High Speed Armour - Piercing Sabot Discard Projectile