模块电源

适用于DC-DC模块电源的IM-FAC变换器

The IM-FAC Converter Applicable to DC-DC Power Module

仪器主要由半导体恒温器，模块电源，研华公司的数据采集模块以及温度，湿度传感器组成。

It consists of semiconductor thermostat , power module , and dater collector module of yanhua , temperature sensor and humidity sensor .

介绍了针对通信用多逆变模块电源设备的远程监控要求，利用CAN总线与底层多逆变模块连接、通过Web服务器连入Internet的嵌入式远程监控系统。

This paper presents a distributed embedded remote monitor and control system , which realizes the connection of lower terminals , inverter models which were connected via CAN bus , with Internet through Web server .

建立了模块电源的寄生参数模型，提出改善模块电源EMC性能的措施。

The parasitic parameter model of the modular power supply is built and the optimization strategies of improving the EMC performance are proposed .

本文针对DC-DC模块电源中应用较多的有源箝位正激变换器，研究磁集成技术的应用，以减小输出电流脉动并提高变换器的整体性能。

The thesis researches the magnetic-integration applied to the active-clamp forward converter so as to reduce the ripple current and improve its performance .

然后，在分析了模块电源主电路拓扑和控制策略的基础上，设计了模块电源的主电路，以ARM芯片为核心的控制电路和模块电源并机均流的硬件电路。

Secondly , design the module power supply main circuit hardware , controller peripheral circuit and module power supply paralleled current sharing controlling hardware , by analyzing main circuit topology and circuit controlling strategy .

用于控制200W模块电源功率因数校正电路的数字控制

Digital Control for PFC of 200W Modular Power

本文介绍了模块电源滤波器原理，并重点介绍了用于模块式电源的电磁干扰滤波模块VIIAM的原理、参数，并给出了应用电路。

The principle of module power filter was introduced in this paper . The principle , parameters on VI IAM were discussed and the application circuit was given .

Interpoint系列模块电源及其替代产品设计要点

The Design Outlines for Interpoint Module Power and its Substitute Products

近年来，随着诸如3.3V微处理器、数字信号处理器以及各种专用低压IC电路的应用日益普及，低压、大电流输出的模块电源日益成为一个重要的研究方向。

In these recent years , with the increasing popularization of the applications such as 3.3V microprocessor , digital signal processor and many kinds of special low-voltage integrated circuit .

采用三维叠层封装结构，在实验室完成28V／36A输出航空用模块电源样机，给出了模块电源的实验结果。

A 28V / 36A prototype aviation modular power supply is built in the lab using three dimensional stacked-layer structure . Finally , experimental results are given .

文中从时域和频域两个角度对此电路进行了详细的原理分析。采用所推荐驱动电路的36~75V输入，1.8V/60A输出，四分之一砖标准的模块电源效率高达90%以上。

The principle of operation and the characteristics of the scheme are analyzed in time domain and frequency domain , and verified on a 36V-75V input 1.8V/60A output experimental prototype , whose size is 1 / 4 brick and efficiency is above 90 % at rating condition .

S系列低纹波模块电源的研制

The Development of 5 Series Low Ripple Modular Power Supply

大功率DC/DC模块电源的研究

Research on High Power DC / DC Module Power Supply

模块电源应用电路的可靠性设计

Reliability Design of the Applied Circuits of Module Power Supply

DC/DC模块电源的发展方向与标准化

The Developing Trend And Standardization Of The Power Supply For DC / DC Module

采用双管正激拓扑构建高性能模块电源

Two - Switch Forward Topology Power Supply Module

航空用大功率模块电源的设计及关键技术应用研究

Development of High Power Aviation Modular Power Supply and Research on Key Application Technologies

高压输入低压大电流输出模块电源的设计输出输入电压相等符号相反的放大器

Design of Modular Power Supply with High Voltage Input Low Voltage High Current Output

系统主要分为中央控制器、采集装置、灯丝转换器和模块电源电路组成。

This system is includes central controller , acquisition machine , filament converter , power supply .

模块电源及其应用

Moduler Power Circuit and its Application

其中，模块电源的高转换效率是各模块电源厂商产品的重要技术指标，也是电力电子界科研人员的主要研究对象；

To obtain the high converter efficiency is a main technology issue of switching power supplies .

介绍了模块电源在电源系统中的应用，对其工作原理及优点进行了论述。

The paper introduces the application of moduler circuit to power system , and discusses its principle and advantages .

分析比较大功率硅堆在模块电源中的安装位置不同，有着不同的放电特性。

Analysis and comparison of power diode stack are installed different lacation , and they have different discharge characteristics .

本文介绍了DC/DC模块电源的发展方向，以及DC/DC模块电源的可靠性及标准化工作的建立。

This paper introduces the developing trend of the power supply for DC / DC module , its reliabilities and standardized procedures .

随着我国通讯、电力系统以及个人数字产品的快速发展，模块电源的应用越来越广泛。

For the rapid development of telecommunications , power systems and personal digital products , the power supply module is used more widely .

为了适应多种需求，本文提出了使用单模块电源来积木式迭加功率的方法。

To meet the diverse needs , we propose to use single-module supply to increase power like the superposition of building block method .

分布式电源系统的发展对模块电源提出越来越高的要求。

There are higher and higher requirements for the DC / DC converters due to the development of the distributed power supply system .

随着多电飞机技术的飞速发展，多路输出模块电源在航空电气系统中的应用越来越广泛。

With the development of the more-electric aircraft , multi-output power supply modules have been more and more widely applied in aviation electrical system .

论述了模块电源并联运用中的自动均分电流原理，并给出应用于具有冗余结构的程控交换机二次电源的一个实例。

This paper introduces the framework , operation method and function of power supply module automatic testing system based on the virtual instrument technology .