控制总线

MIC总线是一种具有高可靠性的现场控制总线。

MIC bus is a kind of high dependable field control bus .

MIC总线是为解决在恶劣环境下数据的管理而开发的一种具有高可靠性的现场控制总线。

MIC bus is a high reliability worksite control bus used for data management under adverse circumstance .

一种采用FBG滤波器的WDM媒质访问控制总线光网络

A WDM Media Access Controlled Bus Optical Network with FBG Filter

MVB为快速响应的过程控制总线，对于固定编组的列车，也可以用作列车总线。

MVB can still be used for train bus if the train is fixed organized .

SERCOS接口是新一代的数字驱动器运动控制总线接口。

SERCOS interface is a kind of motion control bus for new generation numeral driver .

本文介绍了一种采用STD工业控制总线构成的智能低频减负荷系统，介绍了该系统的工作原理、系统结构及软件设计。

N STD bus based intelligent load shedding system according to frequency is described in this paper . The principle , architecture and software design of the system is presented .

提出了一种采用新型光纤器件&光纤Bragg光栅（FBG）滤波器的波分复用（WDM）媒质访问控制总线光网络设计，使得网络的分光损耗明显降低。

This paper proposes a Wavelength Division Multiplexing Media Access controlled optical bus network with low splitting loss by using a new optical fiber element fiber Bragg grating ( FBG ) filter .

利用该方法，SoC芯片中地址、数据和控制总线的串扰故障均得到了测试，实验结果也表明其硬件开销较其它方案大大降低。

By means of this method the Crosstalk faults of address bus , data bus and control bus in a SoC chip can be tested . The result also show that the area overhead is also decreased drastically compared with other method .

通过可编程并行接口芯片8255将IBMPc并行打印端口扩展成3个具有双向通讯功能的8位I/O端口，利用这3个I/O端口分别作为数据采集仪器的数据总线、地址总线和控制总线。

The parallel print ports of IBM-PC can be extended to three bi-directional 8-bit I / O ports by a programmable integrated circuit chip named 8255 . The three I / O ports can be used as data bus , address bus and control bus of the data-acquisition instrument .

通过组态配置程控电源、串行A/D和相应的硬件接口电路，基于单控制总线的编译码系统，构成PTCR参数测试虚拟仪器，并成功应用于PTCR零功率伏安特性测量。

Serial A / D and hardware interface , the virtual instrument for measuring of PTCR parameters is constructed , and it succeed to work in measuring the zero power consumption V-I characteristics of PTCR .

随着FCS的发展和广泛应用，用户对现代工业控制总线的带宽、传输距离、冗余能力、可靠性和性价比的要求越来越强烈。

With the rapid development and widely utilization of the FCS , users get more and more expectation on a better performance in industrial control bus bandwidth , transmitting distance , redundancy ability , reliability , and performance to cost ratio .

GPIB总线接口是现在无线电系统中使用的较多的常用测量仪表的标准配置之一，它是用来连接多个测量仪表和测量计算机的一种标准工业控制总线。

GPIB bus interface is one of the commonly used measurement meter standard configures which are often used in the wireless systems . It is a kind of standard industrial control bus applied to link many measurement meters and measurement computers .

主要介绍了智能家居的4种控制总线技术，分析了它们的工作原理和特点，并以EIB总线为例，详细论述了它的应用结构及应用模块的开发。

The paper introduces four control bus technologies in smart home , analyzes their working principles and characteristics in application , and taking EIB for example , discusses detailedly its application structure and exploitation of application module .

针对传统交叉铺网机生产的非织造布棉网均匀度较差等问题，将运动控制总线SERCOS应用于W1251交叉铺网机数字伺服系统。

Aiming at the poor web uniformity of non-woven fabrics produced by traditional cross lapper , the motion control bus SERCOS is applied in the digital servo system of the W1251 cross lapper .

介绍利用自行设计的开发板将计算机EISA总线的部分信号引出，来完成微机接口的各种实验，并对译码电路、数据总线、控制总线的设计作了详细的阐述。

This article introduced how to make use of self-designed development board to complete all kinds of experiments on the microprocessor interface by fetching part signal of computer EISA bus , and elaborated the design methods of coding circuits , data bus , control bus .

建筑电气的控制总线系统与应用

General Line Control System of Architectural Electric System and Its Application

智能建筑控制总线技术浅析

An Analysis on Control Bus Technology of Intelligent Buildings

新的工业控制总线&1553B总线

A New Industrial Control BUS & 1553B

智能家居的控制总线技术

Control Bus Technology of Smart Home

工业现场控制总线在农业温室大棚中的应用

Application of Industry in Agricultural Hothouses

控制总线则包含几条表示路由分时和系统的控制信号。

The control bus contains various lines used to route timing and control signals throughout the system .

控制总线用来控制要执行的操作的种类和顺序。

The control bus is used to control the sequencing and nature of the operation being performed .

现场控制总线和组态软件是构成各种子系统硬件和软件的有效实现方法。

Field control bus and configuration software are effective methods that compose of each subsystem 's hardware and software .

第一种为单层控制总线网，应用于铁路机务段内的远程监控项目。

The first kind of network is a single-layer bus involved in a railway project to control many isolating switches carefully .

系统总线的功能在逻辑上被划分为三部分：地址总线、数据总线和控制总线。

The system bus is divided into three logical functions ; the address bus , the data bus and the control bus .

结合现场控制总线的通信机理，阐述了上位机和下位机的通信过程。

Based on the communication mechanism of the Profibus fieldbus , this paper expatiates the communication implementation and configration of the system .

现阶段建筑智能化工程中控制总线技术应用较多，但各类技术之间差别很大。

In the present intelligent construction projects , control bus technology is in varieties of application , but there are great differences among them .

CAN（ControlAreaNetwork）控制局域网总线是一种广泛应用于工业控制领域的现场总线。

CAN ( Control Area Network ) bus is widely used in industrial control field .

基于多DSP的伺服电机分布式控制CAN总线通讯系统

Distributed Servo-motor Control Based on Multi-DSP with CAN Bus

MARKⅣ控制系统总线介绍

Introduction to MARK ⅳ Control System Buses