导通

正向导通电压和激光器的峰值波长有关；

The forward conductive voltage is related to the peak wave length of the laser ;

然后，通过加入无源无损的箝位电路，增大输入电流的导通角、吸收漏感能量并且重新利用、提高变换器的效率、同时还能限制开关管的漏源电压。

Secondly , making use of the passive and no-destructive clamping circuit can increase the conductive angle , absorb the leakage energy and reuse , improve the efficiency of converter and at the same time the clamper can limit the drain-source voltage of switch .

平面工艺IGBT制作及导通压降的PIN模型计算

Planar IGBT Fabrication and Forward Voltage Drop Calculated by PIN Model

CMOS模拟开关的导通与截止特性

On and Off Characteristics of CMOS Analog Switches

采用P型栅压自举开关补偿技术，可以有效地克服采样管导通电阻变化引入的非线性失真，提高采样精度。

By compensating with P-type bootstrapped switch , this circuit can overcome nonlinear distortion , which is generally introduced by signal-dependent on-resistance , and improve sampling resolution .

p埋层的辅助耗尽作用使漂移区浓度提高，从而使比导通电阻降低。

Owing to the assistant depletion effect of the buried p-layer , the concentration of n-type drift region is increased and the specific on resistance is thus reduced .

基于功率MOSFET导通压降的短路保护方法

A Short-circuit Protection Method based on Detection of Power MOSFET Turn-on Voltage Drop

根据实际检测温度利用PID控制算法调整双向可控硅的导通时间来改变加热丝的功率，从而实现温度的调控。

With the measured temperature , PID controller adjusted the through time of SCR to change the heater power to control the temperature .

设计了一种采用饱和区MOS管作调节开关的电荷泵，通过控制饱和区MOS管的导通电阻来调节电荷泵的输出电压。

A charge pump with a MOSFET regulating switch working in saturation region was presented .

TCSC暂态过程中晶闸管导通角特性的研究

Research on thyristor conduction angle characteristics in transient process of TCSC

双极晶体管导通状态对功率纵向双扩散MOSFET静态电流-电压特性的影响

Effect of Bipolar Turn-On on the Static Current-Voltage Characteristics of Power Vertical Double Diffused MOSFET

一种高性能连续导通模式的PFC电路设计

Design of High Performance CCM PFC Circuits

IGBT是一种具有MOS电压控制和双极导通调制相结合的器件。

IGBT combines the features of voltage-control in MOS devices and conductivity modulation in bipolar devices .

控制电路采用脉宽调制方式（PWM）进行输出控制，即控制IGBT的导通时间来实现输出功率与输出特性的控制。

Using universal PWM method means to control output power and output characteristic through controlling IGBT switch on time .

一种新型的低导通电阻折叠硅SOILDMOS

A New SOI-LDMOS with Folded Silicon for Very Low On-Resistance

采用霍尔传感器作为无刷直流电动机的位置传感器，单片机根据位置传感器的信号使能PWM信号输出，驱动功率晶体管导通，从而控制无刷直流电动机转动。

Hall sensor used as a brushless DC motor position sensor , MCU according to the position sensor signals can be output PWM signal .

基于JTAG边界扫描的在线导通测试算法

The On Line Connection Test Algorithm Based on JTAG Boundary Scan

该保护电路不会导通.因此这种利用晶体管延时的保护电路完全可以作为CMOS集成电路电源和地之间的ESD保护电路。

So the given ESD protection circuit using transistor delay can be well applied to VDD-to-VSS ESD protection in CMOS IC .

阐述了串联IGBT同步导通、同步关断的必要性和实现方法。

The necessities and the resolving methods were stated about in step touching and in step closing of series IGBT .

大功率LED除了具有节能、环保、寿命长、可靠性高等普通LED的特点外，还有光效高和导通电流大的优势。

High power LED have the advantage of the high light effect and high current except the common LED characteristics of energy saving , long lifespan , environmental protection and high reliability .

通过MOSFET的导通和截止产生方波，实现对方波电源的设计。

A square wave is produced through MOSFET open and stops to achieve the design of the other wave power .

高温、高压LDMOS导通电阻的特性

Characteristic of on-state resistance of a high voltage LDMOS at very high temperatures

详细给出了软、硬件实施方案，得到了预期的IGBT导通及关断波形。

The detailed software and hardware implementation procedures are presented , and the anticipative turn-on and turn-off waveform of IGBT are obtained .

VDMOS击穿电压与导通电阻的最佳设计

VDMOS Optimum Design of Breakdown Voltage and on & Resistance

BJT的反向导通及其在电视技术中的应用

Reverse conduction of BJT & its application in TV technology

PWM信号为“OFF”时续流引起的转矩脉动占主要部分，非导通相续流在一定程度上可以补偿PWM关断时造成的转矩脉动。

The main part of the torque ripple was caused by the PWM_OFF , and the diode freewheeling of inactive phase can compensate the torque ripple to some extent .

文中通过原理分析及数学推导，提出了一种新的PWM调制方式，PWMONPWM调制方法，采用该调制方法可以消除非导通相的电流续流过程，从而减小电流脉动和转矩脉动；

Through theoretical and mathematical analysis , a new PWM approach is proposed in order to eliminate the diode freewheeling of the inactive phase and decrease the torque ripple .

由于便携式应用对白光LED亮度均匀性的要求，以及白光LED自身的正向导通电压大、电学参数离散性大、容易受温度影响等特点，需要设计专门的电源管理芯片来驱动白光LED。

Due to characteristics of white LED such as large forward voltage and high temperature sensitivity , and necessity of uniform brightness requirement of the portable application , specially designed power management IC is needed .

单片机应用数字PID控制算法控制可控硅的导通角，顺序驱动12只可控硅实现高精确度的功率调节。

Microprocessor adopts the digital PID algorithm to controlling the conduction angle of SCR ( silicon controlled regulator ), triggering 12 SCR s in turn to realize the power rectify with high precision .

即使可控硅能够经受高压，但由于dv／dt效应也可能导通。

Even though a thyristor is able to withstand high voltages , it could turn on due to dv / dt effects .