最大输出

在实验室中搭建腔内倍频调Q激光器，以获得最大输出功率为目的对激光器各元件进行调节。

The Q-switched intracavity frequency doubled laser is builded in the laboratory , every component is adjusted for the max output power .

结果表明：环境温度、湿度对PEMFC堆的性能有很大影响，随着相对湿度的增加，PEMFC堆的最大输出功率显著提高；

The results showed that the relative humidity and the temperature of the surrounding air significantly affected the performance of the PEMFC stack , and the max output power of the PEMFC stack increased sharply with the air humidity rising .

具有最大输出功率的CO2激光器谐振腔

Investigation of CO_2 laser resonator with maximum output power

本文以奥托内燃机为例，讨论了热机的输出功与热效率的关系及在循环中吸热Q1可变的情况下与热机最大输出功和对应的效率。

This paper , giving an example of otto internal combustion engine , discusses the relation between the work output and thermal efficiency ;

线质特性稳定（最大输出变化Δmax≤±5%）；

The X ray quality characteristic was steady ( the maximum output variation was Δ max ≤± 5 % ) .

该文分析了CATV系统中放大器的非线性失真与最大输出电平的关系。

The relationship between nonlinear distortion and maximum output level of amplifier in CATV systems is analysed in this paper .

脉冲最大输出能量为6.5μJ，总能量转换效率大于15%。

A maximum output energy of 6.5 μ J / pulse and a total conversion efficiency of more than 15 % are achieved .

行驶方程的Matlab仿真图形表示了机器人在行驶电机最大输出扭矩下，可以达到的坡度角和加速度。

Simulation figures of the dynamic equation with Matlab showed the slope angle and acceleration that the mobile robot can reach under the maximum output torque of the driving motor .

本文根据最大输出熵准则，采用径向基（RBF）神经网络导出一种针对非线性瞬时混合系统的分离算法。

According to maximum output entropy , a new separation algorithm using Radial basis function ( RBF ) neural network for nonlinear mixtures is proposed .

在UE传输的总功率小于所允许的最大输出功率的时候上行功率控制可以被执行。

Uplink power control shall be performed while the total UE transmit power is below the maximum allowed output TX power .

分别采用真空镀膜法、热分解法和电镀法制备了铂金修饰对电极。通过对DSC太阳能电池对电极进行铂金修饰，大大提高了DSC太阳能电池的理论最大输出功率，增大了近7倍。

The opposite electrode was modified with Pt by vacuum coating , thermal decomposition and electrodeposition method , the maxim theoretic output power was increased seven times with Pt-modifying opposite electrode .

并给出了两管芯并联的实验结果：在X波段最大输出功率为5.4W，最佳效率达26.6%。

In Experiment a power output of 5.4W at X-band and maximum efficiency of 26.6 % have obtained from two-chip parallel array .

在一些情况下，经过上行功控计算得到的UE总发送功率可能会超过容许的最大输出功率限制。

In some cases the total reqUEsted UE transmit power in a timeslot after uplink power control calculation might exceed the maximum allowed output power .

功率放大器在设计时区别于小信号放大器的关键是功率匹配，在此基础上，分析了满足PA最大输出能力时的最优匹配阻抗和晶体管电参数的关系。

The relationship of optimal impedance and electrical characteristics of transistors at maximum output power , is analyzed based on the power match , which is the key difference between PA and small signal amplifier .

在输出级3V直流偏置时最大输出电压摆幅可达25Vpp。

The maximum modulation voltage is over 2.5V pp corresponding to a 3V DC bias for output stage .

实验通过采用最大输出脉冲能量为100J的TEACO2激光器，研究了从13~80J的激光脉冲能量对大气呼吸模式激光推进冲量耦合系数的影响。

A 100 J TEA CO_2 laser was employed to study the effects of variety of pulse energy from 13 J to 80 J on the momentum coefficient for air-breathing mode .

对选择式合并，工程中常采用最大输出电平准则（S+N），但在理论分析中却都用最大信噪比准则（SNR）下的结果来代替。

Though the maximum output level ( S + N ) principle is often adopted in engineering , it was the maximum signal noise ratio ( SNR ) principle that is used in the theoretical analysis .

乙酸钠为底物MFC最大输出功率较葡萄糖为底物的MFC提高了33%，COD去除率提高了10.7%。

Compared to glucose as the fuel , the maximal power density is enhanced by 33 % and the degradation rate of COD is enhanced by 10.7 % when sodium acetate as the fuel .

在此基础上，研制了Q波段悬置带线体效应振荡器，当频率为46GHz时，其最大输出功率为74mW，并具有1.2×10~（-4）的频率稳定度。

The numerical results have been A Q-Band suspended substrate stripline Gunn oscillator is developed and the maximum output power of 74 mW at 46 GHz is obtained . The frequency stability is 1.2 × 10 ~ ( - 4 ) .

用辉光放电法顺序沉积p，i，n三层非晶硅，制作出了弱光非晶硅太阳电池，在200lx白荧光灯照射下，其单位面积最大输出功率达7.76μW/cm2。

P-a-Si , i-a-Si , n-a-Si were deposited on TCO glass by means of glow discharge so that the amorphous silicon solar cells at weak illumination were fabricated . The output of maximum power of 7.76 μ W / cm 2 under 200 lx white fluoresent light was obtained .

得到了以下主要结果：采用ZT值曲线交点法研究了n型Bi2Te3/CoSb3宽温域梯度材料的最佳界面温度、最佳长度比和该材料构成的n型热电臂最大输出功率。

The main results are as follows : The best interface temperature , optimum length ratio , and maximum output power of n-type Bi2Te3 / CoSb3thermoelectric materials with wide temperature range were investigated with the intersection method of the ZT curves .

该芯片的输入电压范围是7V-42V，最大输出电流可达1.5A，并且可以通过外接DC电压或PWM信号进行亮度控制。

The input voltage of the circuit is from 7V to 42V , and the output current is up to 1.5A . It can use DC voltage or PWM signal to control the brightness .

结果表明：电池开路电压（opencircuitvoltage，OCV）随温度的变化与理论结果一致，在800℃时，OCV达1.013V，最大输出功率约为190mW。

The open circuit voltage ( OCV ) was 1.013 V and the maximum output power was about 190 mW at 800 ℃ .

考虑到气体传感器的功耗较大，论文设计了输出电压恒定为5V、最大输出功率为15W的传感器阵列加热控制电路。

Considering the larger power consumption of gas sensors array , paper designs the heating control circuits with constant 5V and 15W maximum output power .

经模态简并后的纵扭复合型超声波电机原理性样机，最大输出扭矩已超过4Nm。

After using these methods , now the output torque of the prototype motor is more than 4 Nm .

实验表明，其最大输出功率为10kW，功率因数达到0.99，轻载时直流母线电压小于800V。

The DC-link voltage is below 800V and the power factor of the system is above 0.99 .

系统对实单帧图像数据阈值分割处理后，由DCS再根据输入信号做出判断，当达到最大输出值尚不能控制火焰时进行报警。

Be made the judgment by the DCS according to the input signal , the system gives a alarm message when the solid single frame image data achieves the maximum output which could not be controlled , after processed by threshold value division .

数值模拟结果为提高单路SF-FRA最大输出功率指出了一条可操作性强的技术路径。

The simulation results present an operable technical approach to improve the maximal output power of single channel SF-FRA . 3 .

目前，该激光器的主要技术参数如下所述：最大输出功率为1100W；

The main specifications of this laser unit is depicted as follows : Maximum output power is 1100W ;

波长为1272nm和1317nm的二阶Stokes脉冲的最大输出能量分别为17.6mJ和15.2mJ，相应的转换效率分别为28.1%和22.7%。

The obtained maximum output energies of the second Stokes pulses at 1 272 nm and 1 317 nm are 17.6 mJ and 15.2 mJ , respectively , and the corresponding conversion efficiencies are 28.1 % and 22.7 % , respectively .