转鼓

本文通过对分离机转鼓零件进行弹塑性应力分析，提出了一种超速自增强的新的最佳超速条件：使超应力参数Ky最大的超转速NA即为最佳超转速。

Having made the elasto-plasticity stress analysis of the disc-separator bowl parts , this paper suggests a kind of optimum overspeeding principle for overspeeding self-strengthening , i. e the over-speed at which the overstress parameter Ky ( N_ Δ) obtains the maximum is the optimum one .

沉降离心机转鼓内流体角速度场的研究

The Study on Angular Velocity in the Bowl of the Sedimentation Centrifuger

本钢7号高炉水渣系统转鼓转速PID控制的研究

Research on Drum Rotation Speed PID Control of BX STEEL 7 # BF INBA System

PET转鼓干燥系统的改进

Modification of tumbling dryer system of PET chip

PTA装置回转真空过滤机转鼓结构优化

The Drum Structure Optimization for Rotary Vacuum Filter in PTA Plant

EDTA对生物转鼓的NO废气净化效率的影响

Effect of EDTA on Removal Efficiency of Nitric Oxide in a Rotating-drum Biofilter

该系统通过自动化仪表、变频器、编码器及PLC的相互结合，可实现转鼓的精确调速，提高水渣品质。

Drum rate can be accurately adjusted and water slag quality improved by combining automatic equipment , frequency transformer , coder and PLC .

计算结果与转鼓试验结果吻合较好，说明轮胎模型的Bond图计算方法是有效的。

Result of calculation coincides better with test result on chassis dynamometer and demonstrates the effectiveness of the Bond graphic calculation method of tyre model .

笔者提出：采用解耦算法，最优预估控制算法，以DSP为核心硬件，提高球团矿的合格率、抗压率、转鼓率。

The author puts forward : using uncoupling algorithm 、 optimal predictive algorithm based on DSP hardware , it can promote the percent of pass , bearing , rolling drum .

将Al2O3升高到2.09%时，增加配碳量，仅能保持烧结生产率不变，转鼓指数明显下降、燃耗上升。

While the Al_2O_3 content in sinter reached 2.09 % , sintering productivity can be not changed from increasing fuel ratio , but sinter strength is reduced obviously , fuel consumption is increased obviously .

介绍了材质为316L双级推料离心机在氯化钙生产中的使用情况，分析了转鼓开裂的原因。

Introduced the material for the316L two-stage pusher centrifuges in the production of calcium chloride in the use of an analysis of cracking drum .

成品球团矿抗压强度大于2480N／个，ISO转鼓大于97%，耐磨指数小于2%。

The compression strength of the finished pellets was in excess of 2480 N / P , the ISO tumbling index over 97 % and the abrasion index less than 2 % .

试验结果表明，在碱度2.0～3.2范围内，随着碱度的上升，ISO转鼓指数上升，利用系数提高，烧结速度加快，成品率下降。

The results showed , in the basicity range of2032 , the ISO tumbler index and utilization coefficient was enhanced , sintering velocity increased , yield decreased with the increase of basicity .

转鼓式真空过滤机为PTA生产工艺中的重要设备之一，但其在工业应用中存在过滤效率较低，能耗较大的问题。

Rotary vacuum filter is one of the most important facilities in PTA production , but it has low filtration efficiency and large energy consumption in industrial application .

转鼓真空干燥器替代电阻炉对APT（仲钨酸铵）进行干燥，有许多优点。运行两年来，产品质量明显提高，蒸发速度大为加快，经济效益显著。

Year operation with vacuum dryer instead of the resistance furnace to dry APT has showed a distinct improvement of product quality , and much faster evaporation , with remarkable economic benefits .

转鼓半径在1m以上时，半径对轮胎-转鼓接触界面特性影响效应逐渐减小。

When the drum radius is more than 1 meter , the effect of radius on the characterisitics of contact surface between the tire and the drum gradually decreases .

采用自行研制的生物转鼓（RDB）反应器处理NO废气，考察了RDB净化NO的反硝化效率。

Nitric oxide ( NO ) was treated adopting self-made rotating-drum biofilter ( RDB ) and the denitrification efficiency of RDB treating NO was studied .

高TFe低SiO2烧结矿是高炉强化炼铁的优质原料，但随着TFe升高SiO2降低，烧结矿的转鼓强度会降低。

High TFe low SiO_2 sinter is a high quality raw material for intensifying blast furnace operation . But the sinter strength is reduced with TFe increase and SiO_2 decrease .

分别对100h台架快速老化前后的催化剂活性及催化剂老化前后与整车匹配后的排放情况，通过发动机台架活性评价装置、发动机快速老化试验台和整车转鼓试验进行了研究。

The catalysts activities before or after aging for 100 hours were researched on the engine bench test system .

基于改进的传统过滤理论及逐层分析法，建立了转鼓真空过滤机的计算机设计模型。采用FORTRAN语言开发了用于该机设计的计算机程序。

On basis of improved traditional filtering theory and layer by layer analysis method , computer design model of rotary drum vacuum filter is founded and computer design program is made with FORTRAN language .

基于S7-200PLC的新型转鼓碎浆机控制系统

The new type control system of drum pulpers based on siemens S7-200 PLC

GD-1300上悬式离心机转鼓的应力分析与优化

Static analysis and structural optimization for drum of GD-1300 hang type centrifuge

介绍了本田Insight混合动力电动轿车在实际道路和汽车转鼓试验台上按照国家标准和欧洲的一系列工况循环下测得的动力性、平均燃油消耗和排放的试验结果。

The results of both field test and road simulation dynamometer test on power , fuel consumption and exhaust emission of Honda Insight hybrid electric vehicle ( HEV ) in accordance with both national standards and a series of European test cycles are presented .

用光振子调制连续输出的He-Ne激光，配合转鼓相机，形成了频闪He-Ne激光高速干涉摄影装置。摄影频率达每秒20000幅。

A. cw He-Ne laser is modulated by an optical vibrator to form the He-Ne laser stroboscopic light source for stroboscopic high speed interferography in cooperation with a rotating drum camera , its framing rate cart reach to 20000 pps .

在实验室条件下，探讨了烧结机扩容对烧结矿中FeO含量及烧结矿的转鼓强度的影响。

Laboratory experiments are carried out in a sintering pot to simulate sintering machine , so that the influence of capacity expansion of sintering machine on the FeO content and drum index of sinter is studied .

基于刚性转鼓加载传递、XY传感测力法，导出表征轮胎不均匀性的径向力和侧向力变化量的传递关系。

Based on the method of load transfer from rigid drum and X-Y force sensors , the transfer relationship of the variations of radial force and lateral force , which are used to characterize the tire uniformity , is deduced .

为了达到以上目的，采用了六棱台转鼓结合双面翻转反射镜扫描光路的方案，较好地达到IRST系统的各项指标要求。

In order to get these effects , this scheme scans the search field with mirror polygon combining overturn mirror , by this means , it is able to meet all demands of an IRST system .

采用轴对称有限元ASYM程序，对两种机型的转鼓，在操作条件下的应力分布状态和位移进行计算与比较。

In this paper , the ASYM program of axisymmetrical element method are used to calculate and compare with the stress distribution and displacement of the two types of centrifugal drum .

通过对济源钢铁公司烧结矿添加ZHS添加剂的系列试验，着重研究了ZHS添加剂对烧结矿转鼓指数、还原性、低温还原粉化率及熔滴性能的影响。

A series of experiments on sinter added the ZHS additive were carried out at JIYUAN I & S Co. Effect of the ZHS on sinter properties such as sinter strength , reducibility , low-temperature reduction disintegration and melt-dropping property were studied mainly .

正常工况（FW+PC）下的应力SINT（SINT为第三强度理论的等效应力）最大值随着转鼓壁厚的减小而增大，但增大的幅度较小；

The maximum value of stress SINT ( SINT is the equivalent stress of the third strength theory ) under normal working status ( F_w + P_c ) will increase along with the decrease of wall thickness of rotary drum , but the amplitude of increase is comparatively small .