湿法

PAC和PAM对魔芋精粉湿法生产溶剂的回收效果研究

Recycling Solvent With PAC and PAM for Wet Process of Refined Konjak Powder

GMT湿法成型用悬浮助剂的研究

Study on suspension auxilary agent for GMT wet process

目前看来湿法似占优势。

At present the wet methods seem to be in the ascendancy .

在此基础上，以硫酸钠为凝固剂，对胶原-PVA共混溶液进行湿法纺丝，制备了胶原-PVA复合纤维

Thesolution of collagen-PVA was wet spined with the sodium sulfate as coagulant and collagen-PVA composite fibers were prepared .

用途：本品主要用作药物固体制剂，全粉末直接压片的干燥粘合剂，胶囊填充剂，崩解剂，湿法造粒粘合剂和着色的延展剂。

Use : That is a padhesive with the powder Diecty , Compress tablets and replenisher , Disinteante , adhesive of the capsula .

循环浆液pH值对湿法烟气脱硫过程的影响

The Impact of the pH Value of Circulating Slurry on a Wet Flue-Gas Desulfuration Process

锑湿法冶金的基础研究（Ⅱ）&爆锑中氯化物的X射线光电子能谱研究

FUNDAMENTAL STUDIES ON THE HYDROMETALLURGY OF ANTIMONY & XPS Studies on The Chloride Contained in Explosive Antimony

湿法炼锌常规工艺铁的浸出及沉铁pH值的研究

Study on Iron Leaching and pH Value of Fe ~ ( 3 + ) Hydrolysis in Zinc Hydrometallurgy

微电子制造中Ti的湿法蚀刻

Wet Etching of Ti in the Microelectronic Manufacture

PU湿法半成品印刷压花取代干法贴膜

Printing and Embossing Replaced Dry Transfer Coating for PU Wet-base

通过湿法沉积工艺实验室合成了Ca／P摩尔比为1.67的磷酸钙粉料，其物相纯正，结晶良好。

By wet-precipitation method , pure calcium phosphate powder with Ca / P P molar ratio of 1.67 and good Crystallization is synthesized in lab.

氮化物半导体GaN的光辅助湿法腐蚀

Light Assisted Wet Etching of Semiconductor Nitride GaN

湿法低温转相α-Al2O3微粉的开发和应用

Preparation of a - a1_2o_3 micro-powder through low temperature phase transition by wet processing and its application

STD总线工控机用于湿法磷肥生产控制系统

Application of STD bus industrial control computer to control system for wet superphosphate process

湿法石灰石&石膏烟气脱硫（FGD）技术及烟气脱硫石膏应用的分析研究

Wet " Limestone-Gvpsum " FGD Technology and Analysis of FGD Gypsum Application

湿法制备单分散Co3O4粉末的形貌和粒度控制研究

Study on Morphology and Size Control of Mono-dispersed Co_3O_4 Particles Produced by Hydro-chemistry Method

以木浆粕为原料，通过化学及物理方法制备了湿法PU革用微孔剂。

By chemical and physical processes , a wood pulp-based micropore opnt for wet-method polyurethane leather was prepared .

湿法腐蚀DFB半导体激光器的均匀光栅的研究

The Wet Etching Study of the Uniform Grating DFB Semiconductor Laser

CoxFe（3－x）O4薄膜的湿法制备及性能

Preparation and properties of co_xfe_ ( 3-x ) o_ 4 films

DMSO湿法PAN纤维截面形状形成条件的研究

Study on the forming condition of cross section of polyacrylonitnle ( PAN ) fiber during DMSO wet spinning

本法可用于海绵铅及湿法冶金过程的铅、铜试料中微量铋的测定，Bi可富集10倍以上，标准加料回收率达98%，相对标准偏差约3%。

Bismuth can be concentrated more than 10 time . The recovery is 98 % and relative standard deviation , 3 %

利用MEMS（微机电系统）标准光刻、湿法腐蚀以及低温键合技术制作了微流控分析芯片。

The microfluidic chips were fabricated with standard photolithography , wet etching and low-temperature bonding techniques of MEMS ( Micro-electro-mechanical system ) .

本论文首次利用湿法腐蚀工艺制备了F-P腔。

The F-P cavities employing the wet etching process was fabricated for the first time .

固体氧化物燃料电池用YSZ电解质纳米粉体的湿法工艺进展

Progress on the Wet Chemical Synthesis of YSZ Nano-powder for Solid Oxide Fuel Cell

讨论了薄膜生长的几种常用方法，说明了热氧化和化学汽相沉积（CVD）、湿法刻蚀和干法刻蚀（ICP）分别所适用的范围极其对波导性能的影响。

We also explained the difference of hot oxide and CVD ( chemical vapor deposition ), wet etching and dry etching .

AlGaAs湿法氧化特性实验研究

Experimental Study on AlGaAs Wet Oxidation Characteristics

铬变酸2R分光光度法测定湿法磷酸中的微量镁

Determination of Magnesium from Phosphoric Acid by Wet Process with Chromotrope 2R Spectrophotometry Chromium and Health

提出了选定烟气脱硫系统的优化思想，包括系统的设计和运行优化两方面，并以广东省连州电厂的石灰石/石膏湿法FGD系统为例，对其进行优化分析。

The concept of optimization of FGD System is proposed , it can be divided into design and operation optimization .

国内外湿法冶金中常采用黄钾铁矾法或针铁矿法等方法除铁，硫化沉淀法分步沉淀或较高pH条件下萃取分离镍、钴，不适用于常温、较低pH的生物浸出液。

Iron was precipitated by the formation of jarosite or goethite . And sulfide precipitation or extraction of nickel and cobalt at high pH were used in the hydrometallurgy at home and abroad .

研究了处理BK铅厂阳极泥的湿法冶金过程。

A hydrometallurgical process treating anode slime in BK lead plant was investigated in this paper .