混炼胶

混炼胶在锥形口型流动中压力降的研究

Pressure drop of rubber compound during conical die flow

料筒与口型直径比对混炼胶挤出膨胀行为和入口压力降的影响

Effect of diameter ratio of reservoir to die on extrusion swell and entrance pressure drop of rubber compound

基于SVM的密炼机混炼胶的粘度预测

Prediction of the Viscosity of Mixed Rubber in Mixer Based on SVM

GTO混炼胶的b型膨胀比（B）略小于其它两软化剂胶料，挤出物表观并无明显差异。

There was no obvious difference between the appearance of extrudates of two compounds .

NR／SBR混炼胶挤出流动中自然收敛角的计算

Calculation of Natural Convergent Angle of NR / SBR Compound Flow during Extrusion

加入NR可使PB混炼胶的最宜加工温度和速度范围变宽。

The optimum ranges of processing temperature and curing rate for1,2-polybutadiene are widened by blending with natural rubber .

应用ANSYS软件对NR/炭黑混炼胶的平入口收敛流动进行二维有限元模拟。

The 2 D finite element simulation for the converging flow of NR / carbon black mix at planar entrance was made by ANSYS software .

研究了EBR生胶的加工性能和混炼胶特性。EBR生胶的混炼特性不如BR和IIR。

The properties of EBR processing and vulcanizate was studied .

混炼胶质量预测和排胶控制的GMPLS模型研究

GMPLS model for mix quality prediction and dump control

混炼胶以210℃×4h水解处理得到的阻尼硅橡胶综合性能为好；

The mixed rubber was hydrolyzed by 210 ℃× 4 h , the properties of damping silicone is better .

研究了填料对反-1，4-聚异戊二烯（TPI）硫化胶和混炼胶的物理机械性能和结晶性能的影响。

Effect of different fillers on mechanical properties and crystallinity of trans-1,4-polyisoprene ( TPI ) was investigated .

研究了不同硫黄硫化体系对EPDM混炼胶硫化特性、硫化胶物理机械性能以及喷霜问题的影响。结果表明，一定并用比的M/TRA/BZ/S；

The effects of various blending systems consisting of different accelerators on physical-mechanical properties and blooming of EPDM vulcanizate and vulcanization properties of EPDM compound were studied .

研究了锡偶联型溶聚丁苯橡胶（SSBR）生胶及其混炼胶的流变性能，并与乳聚丁苯橡胶（ESBR）作了对比。

The rheological properties of Sn-coupled SSBR raw and compound were studied and compared with ESBR .

表面活性剂单独使用或与ZnO、MgO并用均可硫化氟丁橡胶CR-1211，且能明显延长混炼胶的门尼焦烧，改善橡胶的加工性，提高硫化胶的物理机械性能。

Cationic surfactants could vulcanize CR - 1211 either alone or together with ZnO and MgO , with much better scorch resistance and processability , as well as better mechanical properties of vulcanizate .

随着LDPE与MVQ混炼胶的质量比的增加，材料的耐热老化性能下降。

The thermal aging resistance of LDPE / MVQ hybrid rubber decreased with the increase in the mass ratio of LDPE : MVQ .

研究了不同乙二醇焦油（GTO）用量对硅铝炭黑（简称SAC）丁苯混炼胶的硫化活化、交联密度及力学性能的影响，得出了综合三种性能于最佳点的最宜GTO用量。

The effects of the amount of GTO on the activation vulcanization , the crosslink density and the mechanical properties of SAC black filled SBR compounds have been studied .

硫化动力学研究表明，含PrDTP-8的混炼胶硫化反应活化能E和频率因子A分别为87.15kJ/mol和2.33E+10。

The study showed that the curing reaction activation energy ( E ) and the frequency A were 87.15kJ/mol and 2.33E + 10 , respectively .

研究了液体天然橡胶（LNR）对NR及其炭黑混炼胶加工性能的影响。

The effect of liquid natural rubber ( LNR ) on the processability of natural rubber ( NR ) and black filled NR compound was investigated .

针对橡胶密炼机混炼胶质量的软测量建模问题，研究了适用于MISO软测量模型的一种RBF算法。

For establishing the model of soft measurement of the quality of mixing rubber in rubber mixing mill a RBF algorithm that is suitable for MISO soft measurement model is studied .

试验研究白炭黑补强乳聚丁苯橡胶（ESBR）混炼胶中的网络结构及网络结构对胶料门尼粘度和动态粘弹性的影响。

The network structure of silica-filled ESBR compound and its effect on Mooney viscosity and dynamic visco-elasticity were experimentally investigated .

结果表明，LIR对NR/BR混炼胶有增塑作用，但增塑效果不如芳烃油；

The results showed that the plasticating effect of LIR on NR / BR blend was lower than that of aromatic oil ;

在150~180℃下实现MVQ混炼胶和低密度聚乙烯（LDPE）的熔融共混，制备出LDPE/MVQ并用胶。

The compound was then blended with low density polyethylene ( LDPE ) in the temperature range of 150 ℃ - 180 ℃ to become LDPE / MVQ hybrid rubber .

在90～140℃、表现切变速率为50～1000s~（-1）的条件下，用Monsanto加工性能试验机对混炼胶的挤出流变行为进行了测试。

The extrusion rheological behavior of rubber compound was investigated in the range of apparent shear rate 50-1000s-1 at 90 - 140 ° C , by Monsanto processability tester .

以1%WD－50硅烷偶联剂于80℃处理30min的改性粘土为增强剂，用于增强鞋用混炼胶。

Modified clay reinforcing agent treated with 1 % of silane coupling agent at 80 ℃ for 30 min was applied to shoe rubber mix .

挤出胀大效应表明锡偶联型SSBR混炼胶的弛豫速度比ESBR混炼胶的快，挤出胀大小，加工性能优于ESBR。

Die swell of extrudate indicated that the relaxation rate of Sn-coupled SSBR compound was faster and the die swell was less obvious than that of ESBR .

考察了钛系1,2&聚丁二烯橡胶生胶、混炼胶、硫化胶及其与顺丁胶（BR）天然胶（NR）并用胶的性能。

The structure and properties of raw rubbers , vulcanized rubbers and blends with cis-1 , 4-polybutadiene ( BR ) and natural rubbers ( NR ) of the 1 , 2-polybutadiene synthesized with titanium catalyst systems ( Ti 1 , 2-PBR ) have been studied .

当γw>400s~（-1）时，DJ-9073b混炼胶在加工过程中要注意对温度的控制。

However , must pay attention to the control of process temperature for DJ-9073b blend when γ w > 400s-1 .

研究了液体聚异戊二烯（LIR-50）对天然橡胶（NR）/顺丁橡胶（BR）混炼胶的混炼特性和硫化胶常规力学性能的影响。

The influence of liquid isoprene rubber ( LIR-50 ) on mixing characters and physical properties of natural rubber ( NR ) and polybutadiene rubber ( BR ) compounds was investigated . The LIR-50 was also compared with aromatic oil .

本文通过（CZ-S）和TMTD两种不同的硫化体系，研究了BIC（锦-20）的混炼胶和硫化胶性质。

This work was undertaken to study the properties of compounded rubber and vulcanizate of BIC ( sample Jin-20 ) by using two different vulcanization systems , ( CZ-S ) and TMTD .

针对混炼胶密炼工艺特性，提出广义多路部分最小二乘（GMPLS）算法，建立混炼胶门尼粘度预测和排胶控制模型，克服了普通最小二乘算法在间歇生产质量控制建模中的局限性。

A model for the Mooney viscosity prediction of mix and the dump control was estab-lished based on the general multi-way PLS ( GMPLS ) algorithm to eliminate the limitation of the model for quality control in batch production based on conventional PLS algorithm .