硫化时间

结果表明，绢云母粉活化后对胶料的老化性能、疲劳性能、半成品粘合强度、H抽出力等性能有所改善，但焦烧时间和正硫化时间缩短；

The results showed that the aging properties and fatigue properties of compounds and the adhesion strength and H pull out force of semi products improved , and the scorch time and optimum cure time reduced by adding activated silk mica powder ;

结果表明，胶料中加入钴盐能够提高强伸性能和与钢丝帘线的初始粘合力及耐盐水老化能力，缩短胶料的正硫化时间，其中以环烷酸钴最好；

The results showed that the tensile strength and elongation at break , the initial adhesion with the steel cord and the aging property in salt water of the compound improved and the optimum cure time shortened by adding cobalt salts , especial cobalt naphthenate ;

在SBR和BR胶料中随白燕华CC用量的增大，硫化时间明显缩短。

The curing cycle shortened significantly as the level of Calcene CC in SBR or BR compounds increased .

对于EPDM胶料正硫化时间t90影响显著的因素是第二促进剂的用量；

The factor which affected the best curing time of EPDM blended rubber was the use level of secondary accelerant .

随着硫化时间的延长，硬质SBR的硬度、拉伸强度及弹性模量增大，玻璃化温度显著提高。

And as the curing time extended , the hardness , tensile strength and elastic modulus of SBR ebonite increased and its T_g rose significantly .

硫化时间对电沉积制备FeS2薄膜组织与结构的影响

The influence of sulfidation duration on microstructural morphology and parameters of FeS_2 films prepared by sulfurizing electrodeposited precursors

结果表明：双酚AF和BPP的用量主要影响胶料的交联密度及硫化时间，并对加工性能有一定的影响；

The results showed that the levels of bisphenol AF and BPP mainly influenced the crosslink density and cure time , and processibility as well .

促进剂BPP的用量主要影响胶料的硫化时间，对加工性能有一定的影响；

The dose of accelerator BPP can mainly affect the curing time and can affected the workability more or less .

研究了由不同动态硫化时间制备的氯化丁基橡胶（CIIR）和聚丙烯酸乙酯（PEA）共混物熔体的流变行为。

Rheological behaviors of melt chlorinated butyl rubber ( CIIR ) / polyethylacrylate ( PEA ) blends in different dynamically cured time were studied .

通过调整双酚AF和BPP的用量和配比，能够有效的缩短正硫化时间，提高生产效率，改善胶料的物理性能。

The production efficiency would enhance and the physical property of the compound would improve after adjust the concentration and compounding ratio of bisphenol-AF and BPP .

随着硫化时间的延长，FeS2及In2S3数量增加，晶粒尺寸增大，FeS2的晶格常数减小。

The quantities and scales of FeS_2 and In_2S_3 crystallites increase with increasing sulfidation time while the lattice constant of FeS_2 decreases .

研究了THF-PO共聚醚相对分子质量、NCO含量、扩链剂用量、硫化时间和硫化温度的不同对THF-PO共聚醚型PU弹性体力学性能的影响。

The effects of copolymer molecular weight , NCO content , chain extender , curing time and curing temperature on mechanical property of polyurethane elastomer were studies .

结果表明，Zn（MAA）2使得ACM胶料的正硫化时间延长，硬度明显提高，力学性能得以改善，热空气老化性能以及耐热油性能仍可保持较高水平。

The results show that the optimum curing time is prolonged and the shore A hardness is greatly enhanced and the mechanical properties are improved by Zn ( MAA ) 2 . The heat-air aging properties and the heat-oil aging properties could still maintain high level .

BPP用量增大，焦烧时间缩短，转矩不变，正硫化时间缩短，压缩永久变形增大，对硬度、伸长率、拉伸强度和撕裂强度的影响轻微。

The increase of BPP will result in shorten time of burning , steady torque , decrease of positive sulfuration time , increase of compression set , and slight impacts on hardness , EL , TS and tear strength .

随着过硫化时间的延长，含钴盐CN10和CN16的胶料与镀铜钢丝帘线之间的粘合力明显下降；

The adhesion strength between the CN 10 ( cobalt naphthenate ) containing compound or CN 16 ( cobalt stearate ) containing compound and the brass plated steel cord decreased significantly as the overcure time increased ;

模板不需要硫化时间可立即密封。

The form is instantly sealed with no cure time required .

二段硫化时间对FKM/CO共混胶性能的影响

Effect of Post-curing Time on Properties of FKM / CO Blends

采用逻辑电路控制橡胶制品硫化时间

Adopt Logic Circuit to Control Sulfuration Time of Rubber Products

降低了硫化时间；降低了胶料的滚动阻力，但同时使硫化胶的抗湿滑性下降。

The vulcanizates ' rolling resistance and wet skidding resistance reduced simultaneously .

硫化时间的延长有可能降低硫化胶的拉伸性能。

Beside , the tensile properties could be reduced by prolonging the cure time .

复合型硅橡胶三种组成成分硫化时间的测定

Measurement of vulcanizing time for three silicone elastomers

橡胶室温硫化时间的预测

Anticipation of Curing Time at Ambient Temperature

结果表明，热扩散系数降低时制品的硫化时间延长；

The results showed that the curing time of product extended when the heat diffusivity decreased ;

硫化时间和温度增加时，La3NbS2O5晶体结晶度提高，晶粒长大。

The degree of crystallinity and grain size increase with raise of sulfuration time and temperature .

研究了硫化时间、补强剂对鼠标垫力学性能的影响。

This paper studies the effect of curing time and filling on mechanical property of mouse pad .

硫化时间、硫化剂含量以及硫化温度等因素影响着吸波材料的力学性能。

Mechanical characteristics are affected by some factors , for example , contents of sulfuration reagent and sulfuration time and temperature .

提出一种等效硫化时间的控制方法，给出了利用计算机实现这种控制方法的方案。实际控制效果良好。

This paper presents a kind of control method of equivalent vulcanization time and gives concrete fulfilling control scheme of using computer .

同时，研究了一次发泡温度和二次硫化时间对泡沫材料压缩应力松弛的影响。

At the same time , effects of the first temperture and the second time conditions on the compress stress relaxation were also studied .

文中用回归分析法确定了热载体阻值和尺寸，并介绍了不同参数下硫化时间的计算方法。

Electric resistance and size of the thermal carriers are determined by regression analysis . The calculate method of vulcanizing time at various parameters is presented .

用热空气老化试验和热分析法讨论了硫化时间和硫化体系对粘土胶热氧老化性能的影响。

The effect of vulcanization time and vulcanization systems on thermal ageing property of the clay-rubber masterbatch were investigated by air oven ageing test and thermal analysis .