极限速度
- 名limiting velocity
-
导出了纯重力充种的充种极限速度解析式;
Under seeds filled by gravity , analytic equation of limiting velocity is conducted .
-
本文提出了仅由相对性原理导出洛仑兹变换的一种方法.并证明宇宙极限速度的存在是相对性原理的必然结果。
A universal limiting velocity is proved to be a necessary consequence of the principle of relativity .
-
普通V带传动极限速度和最佳速度计算
Calculation of Classical V Belt Drives Limit Velocity and Optimum Velocity
-
利用改进后的网卡驱动程序,系统可以以接近网卡极限速度的速率产生并发的、不重复的、含应用层数据的TCP流。
This system can generate application layer data binding TCP stream in the highest speed allowed by the network card simultaneously , using an enhanced network card driver .
-
MIPS流水线的设计目标是要达到平均每个时钟周期完成一条指令,这就是流水线的极限速度。
The aim of MIPS pipeline is that one instruction completed in one period averagely .
-
对钢球冲击LY12铝合金靶板时的击穿极限速度进行了数值模拟研究。
The penetrate limit velocity of LY12 aluminum plate which is impacted by steel ball is studied by MSC .
-
利用修正的THOR公式进行极限速度、剩余速度、剩余质量的求解;
The limit velocity , residual velocity and residual mass can be obtained from modified THOR equation .
-
为优化设计钢/Al2O3陶瓷/钢轻型复合装甲板,结合薄板冲塞的极限速度方程与Florence模型建立了钢/Al2O3陶瓷/钢轻型复合装甲板的抗弹极限速度预测模型。
A model for predicting the ballistic limit velocity was developed by combining Florence 's model with the plug equation for the projectile penetration into sheet .
-
结果表明,如果至少能在一种介质中存在Rayleigh波,且其波速小于两种介质中的最小极限速度,则滑移脉冲波就可以存在。
It is found that the slip pulse may exist if the Rayleigh wave arises at least in one medium with a speed below the minimum limiting speed of two media .
-
为了进一步提高流水线的执行效率,超越流水线的极限速度,本文在对现有32位MIPS流水线进行研究的基础上,创新性地提出了基于32位MIPS架构的双发射流水线设计方案。
For increase the CPU efficiency more , base on the research of existing 32-bit MIPS pipeline , this paper create the double-launching pipeline .
-
根据单根V带额定功率的计算公式,推导出求解普通V带传动极限速度υlim和最佳速度υopt的两个方程,并提供了计算实例。
Two equations of classical V belt drives limit velocity ( υ lim ) and optimum velocity ( υ opt ) are deduced on the ground of V belt power ratings calculating formula . Finally , the example is given .
-
分析并建立了FOPS板壳弹性变形、塑性变形和流动变形的极限速度数学模型;
In this paper , a limit speed mathematical model of elastic deformation , plastic deformation and flow deformation of the FOPS shell was established .
-
本文建立了磁悬浮列车系统轨道动力学方程组,讨论了轨道结构参数对弹性轨变形、极限速度及模态的影响,并结合KDⅢ车的试验结果作出分析。
This paper establishes dynamics equation groups about Electromagnetic Sus-pension Vehicle system of track , and discusses track structure parameters influence upon de-flection , stress 、 modal and critical velocity of elastic track , then some results according to KD ⅲ Vehicle are given .
-
在接近穿孔极限速度的入射速度(V50)范围内,这一机制依赖于复合材料板的厚度和中间层剪切强度。
In the range of incident velocities near to the perforation limit ve-locity ( V50 ) , this mechanism depends on thickness and interlaminar shear strength of composite plate .
-
靶板击穿极限速度的数值模拟分析与试验验证
Simulation and Proving Test of Penetrate Limit Velocity of Target Plate
-
测定了临界穿孔能量及弹道极限速度。
Critical energy of perforation and ballistic limit were measured also .
-
航空用防弹复合材料弹道极限速度的估算
Estimate of ballistic limit velocity of composite panels for aviation application
-
车辆在农村道路行驶时极限速度的研究
Research on the limited speed of the vehicle on Farm Road
-
一种金属薄靶板弹道极限速度的计算公式
A formula for ballistic limit velocity of thin metallic plates
-
阐明了常规弹丸速度测量原理,讨论了速度测量的数据处理方法,给出了动能子弹极限速度的定量数据,并对速度数据的不确定度进行了分析。
The measurement of bullet velocity is described in detail .
-
极限速度半经验算式的应用范围及其推广的实验研究
Experiment Research of Application Scope and Amplification for Limit Velocity Semi-empiric Formula
-
来测一下我印第安的极限速度。
To set a land speed record on my indian .
-
轮式车辆雨天行驶极限速度分析
Analysis of the Limit Speed When a Vehicle Running on the Highway in the Wet
-
铸拉工艺极限速度的计算
Calculation about limit speeds in cast drawing
-
二维抛板极限速度的相似性与古尼公式的采用
A Similarity of the Limit Speed of Two-Dimensional Projected Plate and Adoption of the Gurney Formula
-
研究了悬架和轮胎等参数对极限速度的影响规律。
The law of influence of the suspension and tyre on the limiting speed are analysed .
-
极限速度挑战赛来了不少人啊,是吗?
Looks like there 's a lot of people in town for speed week , huh ?
-
当达到极限速度时,速度表背光灯会变成亮红色以示提醒。
And the rev counter backlight changes to bright red to let you know when you hit the limiter .
-
太空署一直以来都在追求官方希望的极限速度,这将使太空飞行变得极其容易。
The space agency 's dogged pursuit of extreme speed , officials hope , will ultimately make space flight easier to accomplish .
-
选择了适用于战斗损伤仿真的极限速度公式,并提出了剩余速度的求解方法。
The limit velocity formula adapted for battle damage simulation was chosen , and the method of calculating the terminal velocity was proposed .