带板

滑板的技巧主要包括：在滑杆上、在U台上、带板起跳，这些技术可说是除了翻板之外最重要的滑板动作。

Skateboarding skills include : the slider , in the U table , with plates off , these technologies can be said that the most important addition to flap outside the skateboard action .

ASEA冷带板形控制系统

ASEA Flatness Control System for Cold Strip Mill

基于UC轧机板形控制的原理，提出了一种新的采用正交多项式对冷轧薄带板形检测信号进行辨识和分解的数学模型。

In this paper , a new mathematical model which uses orthogonal polynomial to identify and decompose the measured signals of thin stirp flatness in cold rolling is given out according to the principle of flatness controlling on UC mill .

结果表明，7055合金挤压带板在470℃保温超过20min，其固溶处理基本充分，继续延长固溶处理保温时间，不能提高合金的强度，但合金延伸率略有升高。

The results showed that the alloying elements in 7055 alloy can be dissolved fully when the time of solution treatment at 470 ℃ exceeds 20min ; continuing to extend time of solution treatment can not improve the strength but can increase the elongation of the alloy slightly .

对于简单板架结构，主要考察骨材和带板之间的焊缝裂纹和骨材腐蚀两种损伤。

Welding crack and stiffener corrosion are investigated for simple panel structure .

板桁结构考虑局部屈曲空间计算的横向条带板段单元法

Transverse stripe deck beam finite element method of considering local buckling space

带板托预应力钢-混凝土连续组合梁抗裂度计算

The Calculation of Crack Resistance in Prestressed Steel-concrete Continuous Composite Beams with Bracket

某型飞机平尾带板的喷丸工艺

Shot Peening Process of Tail Strap of an Aircraft

冷轧薄带板形检测信号正交多项式分解及数学模型

Orthogonal polynomial decomposition and mathematical model for measured signals of thin strip flatness in cold rolling

带板大跨度预应力次梁楼盖边主梁协调扭转试验

Compatibility Torsion Test of Spandrel Beam with Cast-in-Place Slab in Long-Span PC Secondary Beam Floor System

螺旋叶片带板齿式轴流脱粒与分离装置试验台功耗的试验研究

Study on Power Consumption about the Axial Flow Threshing and Separating Installation with Helical Blade Plate

轧辊的带板堆焊

Strip electrode surfacing for rollers

而热轧铝板带板形控制可以通过控制横向厚度分布来实现。

The flatness control in hot rolling aluminum strip can be achieved by controlling the transverse thickness distribution .

在受损加筋板极限强度计算中，对有损伤的带板有效宽度取受损板格的有效宽度进行计算。

The effective width of damaged attached plates adopt the effective width of damaged plates in ultimate strength computation of damaged stiffened panels .

此外将油船共同规范中对骨材带板影响的要求应用到散货船结构强度直接计算分析中进行研究。

Moreover , apply the demands of influence of attached plate in Common Structural Rules for Double Hull oil Tankers to Bulk Carriers .

挤压带板的纵向强度明显高于横向的强度，但其延伸率明显低于横向的延伸率。

The strength of the plate in longitudinal direction is obviously higher than that of plate in transverse direction , but the elongation shows the opposite result .

通过实验求出组合梁在弯曲时的有效带板宽度，结果表明有效宽度数值大于12倍钢丝网水泥板厚；

At all times the value of effective breadth of ferro-cement flange beams with steel web is always larger than the thickness of ferro-cement plate by 12 times .

这些变形特征反映了阴山带板内造山过程中，是以结晶基底为受力层，并控制上覆盖层进行构造变形的，进而表明板内造山主要是由水平挤压应力造成的。

These features imply that the crystalline basement is the bearing subsistence during the formation of Yinshan orogeny , and imply that the intraplate orogeny was caused by horizontal pressure .

采用力学性能测试和金相实验，研究了7055合金挤压带板纵横向力学性能随固溶处理时间的变化，以及纵向取样位置对带板力学性能的影响。

Influences of solution treatment time on the mechanical properties of 7055 alloy extruded plate in longitudinal and transverse directions and the influence of the sampling location of the longitudinal samples on mechanical properties of the plate have been investigated .

采用力学性能和电导率测试及透射电镜组织观察的方法，研究了7050合金挤压带板的单级时效、双级时效及两级时效之间处理条件对合金组织和性能的影响。

The effects of single aging , duplex aging and conditions between the first and second step agings on the microstructures and properties of the extruded plate of 7050 aluminium alloy were investigated , by means of TEM , tensile and conductivity tests .

对带板纵焊缝间隙影响直径收缩量进行了探讨，得出了组对平均间隙与直径总收缩量的关系。

The influence of the clearance between the longitudinal weld seams of the zone plate on the shrinkage mass of the diameter was discussed , the relation between the average clearance of the installation and the total shrinkage mass of the diameter was derived .

针对轴流脱粒机在实际生产中的广泛应用和人们对于脱粒机理的研究还不深入的现状，结合国内外同类技术研究经验，研制了螺旋叶片带板齿式轴流脱粒与分离装置试验台。

As the axial flow threshing and separating equipment were used more and more widespread and the theory of threshing was not researched deeply , the axial flow threshing and separating installation with helical blade plate were triturated according to the same kind of technique experience .

重点介绍青岛FP驾驶室左/右安全带加强板冲压工艺的设计过程。

The design procedure of punching technology for the reinforcing plate of left / right seatbelt in Qingdao FP cab is mainly introduced .

本文是以修改的GrennMartin21型为基本翼型，进行了风洞试验以确定大厚度带端板地效翼的纵向空气动力特性。

Taking Grenn Martin 21 reformed for a basis type , the wind-tunnel tests has been conducted to determine the longitudinal aerodynamic characteristics of thicker wings in ground effect with end plates .

目前国外所做的一系列采用锚固板锚固的试验，均使用的是强度低于60000psi（413.9MPa）的钢筋，而实际上缺乏带锚固板的高强钢筋的锚固性能试验数据。

At present , a series of experiment using mechanical anchor have been done , which were using the steel bars that intensity is lower than 60000psi ( 413.9MPa ) . Practically , we are lack of anchorage capacity experimental data which are tested by high-strength headed bars .

改善横拼双金属带坯板形的研究

A study of improving the shape of laterally welded bimetal strip

带孔板及扰流柱楔形通道内的流动及传热

Heat transfer in a wedged pin-finned passage with preset perforated plate

板带轧制板形最佳规程的设定计算及应用

Shape Optimal Schedule Setting Calculation and Application for Sheet Strip Rolling

不带导流板矩形腔的流激振荡的频率特性

Frequency property about flow induced oscillation of cavity without flange plate

现代铝板带轧机板形控制新技术

New Technology on Shape Control in Modern Aluminium Plate & Strip Mill