偏心受压构件

VISUALBASIC程序设计在桥梁结构计算中的运用&圆形截面偏心受压构件强度验算程序

The Application of Visual Basic Programming in the Calculation of the Bridge Design

热轧H型钢偏心受压构件在弯矩作用平面内极限承载力的理论与试验研究

The Test and Theory Study in the In-Plane Stability Capacity of Hot-rolled H-section Columns under Eccentric Load

RC环形截面偏心受压构件配筋计算新法

A New Method for the Analysis of Eccentrically Loaded RC Compression Member with Ring Section

针对这些问题，提出了计算对称配筋小偏心受压构件截面强度的三个方案以及Rw、σg的计算公式。

For these questions , three calculating methods and formulas for calculating R_w 、σ _g are put forward for the symmetrically reinforced concrete short column with small uniaxial eccentricity .

关于偏心受压构件承载力Nu-Mu相关曲线及相关曲面的探讨

Discussion about " The Interaction Curve and Interaction Surface between The Axial Force of Eccentrically Pressed Member and Bending Force Moment "

本文从力的平衡条件出发，建立确定矩形截面钢筋混凝土斜偏心受压构件的二元高次方程组，用Newton法求解该方程组以确定中性轴位置并由此计算混凝土和钢筋的最大应力。

Based on the conditions of the equilibrium of forces and Newton 's method , a method of stress analysis for eccentrically loaded rectangular reinforced concrete short column with biaxial bending is presented .

根据平截面假定和小偏心受压构件的基本公式，通过对矩形截面非对称配筋承载力的分析计算，给出了ξ与m，n的关系以及计算ξ的线性内插公式。

Based on the plane section assumption and the formulas of compression members with small eccentricity , the interaction diagram of ξ - m , n and the linear interpolation formula of ξ according to the calculation of rectangular section capacity with asymmetrical reinforcement are presented .

循环荷载作用下偏心受压构件的滞回性能研究

Hysteretic Characteristics of the Eccentric Compressive Structure Member Under Cyclic Loading

偏心受压构件可靠度分析的极限状态方程

Limit state equation of reliability analysis for compressive members with eccentricity

沿截面高度均匀配筋的钢筋混凝土偏心受压构件的配筋计算受弯构件截面高度和配筋的控制计算

Controlling calculation of sectional altitude and steel of flexural members

砼偏心受压构件折减系数计算公式的几个注解

Notes on Computational Formula of Eccentric Compression Component of Concrete

圆形截面偏心受压构件的等效应力图形设计方法

A design method of eccentrically compressed round-section member with equivalent stress figure

木结构偏心受压构件截面选择的直接求解方法

Direct solution of selecting section of eccentric compression member for wood structures

方钢管混凝土偏心受压构件承载力计算

Load capacity analysis of concrete-filled square steel tubular members under eccentric compression

卷边槽钢偏心受压构件极限承载力的直接强度计算方法研究

Direct STRENGTH-METHOD study on ultimate load-carrying capacity of eccentrically loaded lipped channels

钢筋混凝土双向偏心受压构件的电算方法

Computer calculus for two - way eccentrically compressed member

大偏心受压构件总用钢量最小的精确设计法

An Accurate Design Method on Minimizing Weight of Steel of Large Eccentric Compression

受腐蚀钢筋混凝土偏心受压构件低周反复性能的试验研究

Experimental study on low-cycle behavior of corroded reinforced concrete member under eccentric compression

钢筋混凝土大小偏心受压构件的实用判别法

Practical discriminant method of large or small eccentric compression members for reinforced concrete

钢筋混凝土矩形空心截面偏心受压构件的正截面强度计算

Strength Calculation of Front Section of Eccentricity Pressed Parts of Steel Concrete Rectangular

钢纤维混凝土大偏心受压构件配筋计算

Calculating Reinforcement Area of Steel Fibers Reinforced Concrete Compression Members with Large Eccentricity

圆形截面混凝土偏心受压构件极限承载力的理论分析

Theoretical Analysis on Ultimate Loads of Circular Section Concrete Members Under Eccentric Loads

关于规范中偏心受压构件计算方法的探讨

Probe into Calculation Method about Eccentric Compressive Member in Code for Highway Bridge Design

对小偏心受压构件正截面强度计算提出了设计建议。

Suggestions are presented for calculating normal section strength of small eccentric compressive members .

对称配筋矩形截面小偏心受压构件新算法

New method of calculating members in micro eccentrical compression of symmetrically reinforced rectangular cross section

钢筋混凝土矩形截面偏心受压构件刚度和裂缝的试验研究

Experimental Studies of Stiffness and Crack of Eccentrically Loaded Reinforced Concrete Members with Rectangular Sections

对称配筋小偏心受压构件截面强度计算的建议

Suggestion on Calculating Section Strength for Symmetrically Reinforced Concrete Short Columns with Small Uniaxial Eccentricity

钢筋混凝土圆环截面偏心受压构件极限强度计算及程序

The Limit Strength Calculation and Program for Circular Section Reinforced Concrete Members under Eccentric Pressures

弦截法在对称配筋小偏心受压构件截面设计中应用

A design method of symmetrical reinforcement members subjected to small eccentric compression by secant method

砌体双向偏心受压构件承载力的设计方法

Design Method of the Load - bearing Capacity of Masonry Members Under Bi - eccentric Compression