传输接口

暖通CAD建筑条件信息传输接口的研究

Study of the architectural information interface to HVAC CAD software

DSP与PC机的高速数据传输接口设计与实现

Design and Implementation of DSP and PC-High-Speed Data Transfer Interface

基于DSP通用随机数测试仪传输接口的设计

Design of Transmission Interface of Universal Random Test Apparatus Base on DSP

基于DSP的USB语音传输接口设计

Design of Sound Signal Communication Interface of USB Based on DSP

基于FPGA的数据帧传输接口设计

Design for data frame transmission interface based on FPGA

CCD测量系统的无线数据传输接口的设计

Design of the CCD measurement system based on the wireless data communication

在叙述X／Open传输接口API时，还对记这种设备驱动机制作了深入分析。

In the narrative X / Open transport interface , also to remember API the device driver mechanism for further analysis .

现今，越来越多的设备采用USB接口作为数据采集、传输接口。

Today , more and more devices use USB interface as a data collection , transmission interface .

基于FPGA的数字视频传输接口ASI的实现

The implement of DVB-ASI transmission with FPGA

论文完成了基于PCI总线和DSP的高速数据传输接口电路卡的硬件及软件的设计。

In this thesis , I completed the software and hardware designing of high speed communication card based on PCI & DSP .

微型计算机ALPHA和小型计算机NOVA的数据双向传输接口

An Interface for Bidirectional Transmitting Data between an ALPHA Microcomputer and a NOVA Minicomputer

在高速数据传输接口中，由于数据窗缩小以及传输路径不一致，造成数据和时钟信号在FPGA的接收端发生位偏移和字偏移。

Data may arrive at the FPGA receiver with channel-to-channel bit skew and word skew due to different trace length and smaller data window .

基于DTMF信号方式的数据传输接口软件设计

Data Transmission Interface Software Design based on DTMF Signal Mode

根据GPRS网络系统结构和数据传输接口，完成了系统数据交换命令集的定义和传输接口程序的开发。

According to GPRS network structure and data transmission interface , the sub-system defines data exchange command groups and real-time transmission of the encapsulated data . 3 .

在内部数据直接储存传输接口（IDMA）的基础上，设计了中断逻辑电路，增强了DSP与微型计算机数据通信的灵活性。

In addition to the interface of IDMA , an interrupt logical circuit is designed to increase the flexibility of the communication .

UART是一种广泛应用于短距离、低速、低成本通信的串行传输接口。

UART is a transmission interface widely used in the short distance , low speed and low cost communication .

随着通信技术和多媒体技术的发展，手持设备对LCD显示屏的规格和性能要求在不断地提高，这对小尺寸LCD数据传输接口提出了更高的带宽需求。

Along with the development of communication and multimedia technology , the demand of LCD performance in handheld devices is increasing , which results in higher bandwidth requirement to LCD interface .

介绍了一种基于通用串行总线USB2.0的成像测井数据传输接口硬件及软件设计。

A data communication equipment for image logging system based on USB 2.0 is described .

仿真系统由匝道控制器、数据传输接口软件和PTV交通仿真软件组成。

Simulation System composed by ramp controllers , data transfer interface software and PTV traffic simulation software .

以GC-06蓝牙接收模块、SD储存卡和RS232串行通讯接口为数据传输接口的蓝牙接收装置设计。

Take GC-06 blue tooth receive module , SD storage card and RS232 serial communication connection as data transmission connection .

因而，该传输接口协议是整个车地通信系统中实现业务数据有效传输的核心关键技术。本文首先对3G技术应用于车地通信系统中的可行性进行了分析和论证。

Thus , the transmission interface protocol is the core and key technologies to realize the effective data transmission . Firstly , feasibility of application of 3G technology in communication system has been analysis .

UART（通用异步接收发送设备）是一种短距离串行传输接口。在数字通信和控制系统中得到广泛应用。

UART ( Universal Asynchronous Receiver Transmitter ) is a short-haul serial communication interface which is applied widely in digital communication and control system .

针对USB传输接口的标准和USB1.1协议。给出了USB硬件接口设计和端口的软件控制方法。

Aiming at USB transfer interface standard and USB 1 1 protocol , it also gives the method of USB interface circus design and program .

然后，您可能不得不在Linux设备上配置Bluetooth芯片组，以通过HCI传输接口而不是PCM接口收发SCO音频数据分组。

You might then have to configure the Bluetooth chipset on the Linux device to receive and send SCO audio packets over the HCI transport interface rather than the PCM interface .

典型的数码相机系统有镜头、闪光灯、光学取景器、LCD显示屏、图像数据存储扩展设备接口、图像数据传输接口、供电系统以及核心处理器等八个主要模块。

Typical DSC system has the modules of lens , flash lamp , viewfinder , LCD screen , UIO expansion controller for image storage , UIO expansion controller for data exchange , power supply , microprocessor and others .

论文设计了基于FPGA的多通道数据采集硬件电路，主要包括FPGA核心控制电路、多片A/D芯片组成的模数转换电路、数模转换电路以及HOTLink串行数据传输接口电路。

The dissertation designs a kind of data acquisition circuit based on FPGA , which mainly includes FPGA control circuit , multi-channel ADC circuit , DAC circuit and HOTLink serial data transfer interface .

该方案是一种基于同轴电缆的ASI传输接口方案，采用CYPRESS公司芯片实现ASI的发送和接收，并用逻辑编程器CPLD完成SPI与ASI互相转换所需的逻辑控制。

This scheme is based on the ASI , makes the sending and receiving of ASI come true and achieve transformation between SPI and ASI with the logic programmable device CPLD .

连接器依赖于Teradata并行传输接口，它要求在加载流程的各点同步多个进程。

The connector is dependent on the Teradata parallel transport interface that requires multiple processes to be synchronized at various points during the load process .

ASI接口是TS流的标准传输接口，具有数据传输速率高和可靠性好特点，适用于高速点到点数据传输，特别是数据量大的视频数据传输。

ASI interface is a standard TS stream transmission interface , with high data transmission rate and excellent reliability features for high-speed point to point data transmission , particularly in the data volume of video data transmission .

文章通过对DTI数字传输接口电路的功能及动作原理的说明，着重论述了数字传输接口的机能与特性测试，并对传输线作了简要的叙述。

The article describes the function and action theory of DTI ( Digital Transmission Interface ) circuit , emphasizes the enginery and characteristic experiment of digital transmission interface , and briefly discusses the employ of the transmission circuitry .