电路模型

  • 网络circuit model
电路模型电路模型
  1. n端口网络的等效电路模型研究

    A Research for Equivalent Circuit Model of n-port Networks

  2. SAW存储相关/卷积器瞬态模式的电路模型和分析

    A circuit model in transient mode of SAW storage correlator / convolver and its analysis

  3. 不连续导电模式时PWM开关的等效电路模型

    An Equivalent Circuit Model for PWM Switch in Discontinuous Conduction Mode

  4. 单相BOOST功率因数校正主电路模型的建立

    Modeling of BOOST converter using for single-phase PFC

  5. 设计了采用电压型PWM变流器主电路模型的充放电装置。

    Designed in the essay is the main circuit with voltage source PWM converter .

  6. 准TEM高温超导微带线电容等效电路模型及其分电容模型

    The capacitance equivalent circuit for quasi TEM HTS microstrip and the basic capacitance model

  7. 串联MEMS开关的一种等效电路模型

    An Equivalent Circuit Model of Series MEMS Switch

  8. 建立一个简单的电路模型,分析二次电子倍增放电与RF腔之间的相互作用。

    A simple circuit model is constructed to analyze the interaction between multipactor discharge and RF circuit .

  9. 该等效电路模型能够应用于电力电子电路的CAD设计之中,满足工程应用的需要。

    The proposed SPICE model is useful as a computer-aided design tool for analysis and design of circuits of power MOSFET ' s.

  10. 在分析CMOS器件闭锁电路模型的基础上,简要介绍了三径闭锁窗口模型的有关情况。

    The three-path latch-up window model is simply based on the analysis of CMOS device latch-up circuit model .

  11. 精确的短沟MOSFET电路模型及参数提取

    An Accurate Short-channel MOSFET Modelling and Parameter Extraction

  12. 光敏电阻的SPICE瞬态分析子电路模型

    SPICE transient analysis photoresistor - sub-circuit model

  13. 用改进算法提取GaNHEMT小信号等效电路模型

    Extraction of GaN HEMT Small Signal Equivalent Circuit Model Using an Improved Algorithm

  14. 分别采用POWERSYSTEM工具箱和考虑电感电流断续工作状态的C-MEX文件S函数建立了主电路模型,对平均电流控制型PFCBoost变换器进行了仿真。

    The PFC Boost converter is simulated using the model established with Power System toolbox and the C-MEX file S-function model respectively .

  15. XLPE电缆绕组高频暂态电路模型的研究

    Study of the high frequency transient circuit model of the XLPE cable windings

  16. 给出了改进的电容式开关等效电路模型以及基于该电路模型的一种新型的多频段工作的电容式RFMEMS开关的设计和制作研究。

    A modified equivalent circuit for capacitive RF MEMS and a novel switch design based on the modified equivalent circuit are presented .

  17. 本文结合河北省自然科学基金项目特快速瞬态过电压对变压器的影响(项目编号503624),重点研究了GIS中变压器绕组高频电路模型的建立方法。

    Supported by Hebei Natural Science Foundation under grant No. 503624 , The high frequency circuit model of the transformer windings in GIS is researched in this paper .

  18. 基于状态机的ROM接口电路模型

    An ROM Interface Model Based on FSM

  19. Gunn二极管的集总电路模型被编入了FDTD算法。

    The lumped circuit model of Gunn diode was incorporated into the FDTD arithmetic .

  20. 用改进的遗传算法从S参数中提取HBT交流小信号等效电路模型参数

    Ga_0.49 In_0.51 P / GaAs HBT Small-Signal Model Extraction Using a Improved Genetic Algorithm

  21. SiGeHBT大信号等效电路模型

    SiGe HBT large signal equivalent circuit model

  22. 在没有相应IGBT的SPICE模型库的前提下,利用等效的电路模型能更方便地实现相关电路的设计。

    Without IGBT model in SPICE , this equivalent circuit model can be used in the circuit design expediently .

  23. 从有理分式拟合方法出发,提出了用于射频CMOS平面螺旋电感2π等效电路模型参数提取的新方法。

    A novel parameter extraction method with rational functions is presented for the 2 - π equivalent circuit model of RF CMOS spiral inductors .

  24. 利用MATLAB仿真软件建立变频调速牵引电机定子绕组高频等效电路模型,探讨了电机定子绕组匝间电压的分布特性。

    Using MATLAB simulation software , the high-frequency equivalent circuit model of inverter-fed traction motor is established and the winding inter-turn voltage distribution characteristic of the stator allows investigated .

  25. XLPE电缆绕组的电路模型及其外半导电层暂态电压分布特性研究

    Characteristic of Transient Voltage Distribution in the Outer Semiconducting Layer and Circuit Model of XLPE Cable Windings

  26. 根据原理,设计吸收式微带功率均衡器,利用微波仿真软件MicrowaveOffice构建电路模型,进行仿真设计,软件优化的具体步骤,注意事项,总结设计经验,最后设计出实物,得到所需均衡曲线。

    Designing the absorbency equalizer , built model and optimized by Microwave Office . Optimizing steps , experience and methods are presented . The equalizer and the curve are got in the end .

  27. 在第二部分内容中,主要分析PIN二极管等效电路模型,并对开关线型移相器进行理论分析和计算。

    In the second section , the equivalent circuit models of PIN diode are analysed , then , switch-line phase shifter is analysed theoretically and calculated .

  28. 按照浸泡时间对各组实验进行了阶段的划分,并根据电化学阻抗谱(EIS)建立了等效电路模型。

    The experiments were divided into different stages according the immersing time . Equivalent circuit models were established by EIS .

  29. 为验证理论分析的正确性和指导实验的顺利进行,应用MATLAB软件对电路模型进行仿真,从而证实了理论分析的正确性。

    Simulations with software MATLAB are carried out to validate the aforementioned analysis and supervise the experiment . The results show that the correctness of the above mentioned analysis is verified .

  30. 适用于光发射机设计的实用VCSEL小信号等效电路模型

    A simple practical small-signal equivalent circuit model of VCSEL applicably for designing its driver