干扰源

gān rǎo yuán
  • interference source
干扰源干扰源
干扰源[gān rǎo yuán]
  1. 本文讨论了GPS干扰源抑制中的多用户检测技术。

    The technology of multi-user detection ( MUD ) in GPS interference source suppression is discussed .

  2. 造纸企业DCS系统干扰源分析与抗干扰措施

    An analysis on interference source and anti-interference measures for DCS system in paper enterprices

  3. 一种GPS信号干扰源的设计与实现

    A Design and Implementation of GPS Jammer

  4. Pe是干扰源的等效发射功率,dBm;

    Pe : the equivalent emission power of interfere souse , dBm ;

  5. 宽带高速新型ECM干扰源

    A New Wide Band and High Speed ECM Jamming Source

  6. 结论安装MRI设备时,必须将干扰源移至10m以外。

    Conclusion installing MRI sets , disturbing resources must be 10 m far away from them .

  7. 旁瓣对消中辅助通道HT变换法对干扰源数目的判别

    Using Auxiliary Channel HT Transforms to Identify the Number of Jamming in Sidelobe Cancellation

  8. 就其不足之处,提出了一种新型的电能质量干扰源设计方案。该干扰源采用了DSP技术和双环控制方法,实现逆变器干扰量的快速准确输出控制,可以实现大容量输出。

    Compared with their deficiencies , a new-style power quality disturbance source that adopts the DSP technology and double loop control strategy is presented .

  9. 而根据干扰源的不同,预编码设计可分为多小区MIMO系统和认知无线电MIMO系统中的预编码设计。

    According to sources of interference , the precoding design is specified in multicell MIMO systems and cognitive radio MIMO system .

  10. 认为在安装过程中,电导耦合、电感耦合、电磁感应及接地电位波动等均可成为DCS(集散控制系统)的干扰源。

    Conductive coupling , inductance coupling , electromagnetic induction and grounding potential fluctuation etc , were regarded as disturbance sources of DCS .

  11. TIG焊中采用的高频振荡器,是邻近电子电路的严重干扰源。

    The high-frequence oscillator used in TIG welding is a serious interference source to the nearby electronic circuits .

  12. 现代新体制雷达的不断涌现,对ECM干扰源提出了新的要求。

    With the development of modern radar , more and more requirements for the ECM jamming source are raised .

  13. 卫星干扰源定位参数TDOA和FDOA估计方法的研究

    Research on TDOA / FDOA Parameters Estimation for Satellite Interference Localization

  14. 实际上,由于环境噪声和其它干扰源的影响,要得到精确的DOA估计往往比较困难,这将导致算法的鲁棒性下降。

    In reality , it is often difficult because of noise and other interferences . It influences the robustness of the algorithm .

  15. 从普朗克黑体辐射定律出发,根据MATLAB软件模拟出的目标和干扰源的辐射特性来选择SW/MW两个红外波段。

    Based on Planck 's law of blackbody radiation , according to the radiation characteristic of the target and the flare simulated by MATLAB , the SWIR / MWIR band is chosed .

  16. 本文分析了PLC系统内部及外部干扰源,提出了系统设计,安装方面的具体抗干扰措施。

    A detailed theoretical analysis is made on internal and external interference source of PLC system in the paper . This paper discussed the design of PLC system and anti-interference measures on installation .

  17. 对于两个频基本重叠的窄带瞄准式噪声调频干扰源,提出了PRS跟踪两个干扰源中大功率源的方法。并提出了该方法对被动导引头接收机带宽的要求。

    The method for PRS tracking the weaker source from dual sources is put forward .

  18. EMC设计须从减弱干扰源(传导源)强度、衰减传播因子、提高受扰设备抗干扰能力三方面进行综合考虑。

    Design of EMC must be considered from three aspects : reducing intensity of interference source , attenuating propagation factor and enhancing anti-jamming capability of interfered equipment .

  19. 高频开关电源是严重的电磁干扰源,很多情况下需对其安装EMI电源滤波器。

    Switch power of high frequency is serious electromagnetic interference ( EMI ) source , so EMI source filter usually should be added in switch power .

  20. 能复制、放大声音形成声音的音频系统。在通信系统中,由许多干扰源的串音(的总和)引起的噪声。参阅crosstalk。

    An audio-system that can reproduce and amplify signals to produce sound . In communications , the aggregate crosstalk from a number of interfering sources .

  21. 其次,针对行进中自行火炮的主要干扰源,利用H∞。控制理论,设计了稳定系统的镇定控制器,可将扰动对系统的影响降低到期望的水平。

    Secondly , the stabilizer is designed by using H ∞ control theory aiming to the main disturbance of proper motion gun , which can reduce the disturbance effect on the gun-control system to the level of aspiration .

  22. 由于试验现场的多干扰源,为了进一步提高系统的准确性,在FPGA中设计FIR数字滤波器,对采集的信号进行实时处理。

    Because of multi-interfere source of testing field , In order to increase the veracity of system , acquired signal is processed in real time when FIR figure filter is designed in FPGA .

  23. 由于系统具有高频、高压、高功率的特点,以及使用了大量的脉宽调制(PWM)的电源控制方式,所以其本身就是一个强干扰源。

    The system , which frequently uses pulse width modulation ( PWM ), is of high frequency , high voltage and high power . Thus , the system itself is a strong interference source .

  24. 分析ESP除尘现场的多种干扰源,从不同角度设计提高ESP实时监控系统抗干扰性和电磁兼容性能的方法。

    The interference sources of ESP field are analyzed , and the method to improve the anti-interference ability and EMC ability of ESP real-time monitor and control system are designed .

  25. 在对离线式PWM变换器电磁干扰源和电磁干扰传播通道分析的基础上,通过实测和理论分析相结合的方式,建立了电磁干扰传播通道的高频模型,并进行了验证。

    Based on the analysis of the EMI sources and coupling paths of an off-line PWM converter , a high frequency model of EMI coupling paths is built and verified by measuring and theoretical calculation .

  26. 文章针对非相干干扰源信号的DOA估计算法进行了理论推导和Matlab仿真,得出了求根MUSIC算法适合于工程实现的结论。

    This paper finished the theoretical derivation and simulation by using Matlab for non-coherent interference source signal DOA estimation algorithm , and come to the conclusion that Root MUSIC algorithm is suitable for the realization of the project .

  27. GD地区由于开发程度较高,工区东部工业干扰源密布,对地震资料采集影响较大。

    Owing to higher development degree , man made intense interference sources are densely covered in the east of GD area , deteriorating quality of the acquired seismic data greatly .

  28. 随机调制技术是一种直接控制干扰源,减小系统传导EMI、改善系统电磁兼容性的有效方法,但随机调制技术的应用会引起变换器输出电压纹波峰-峰值增加和精度降低。

    Randomized modulation used in power converter can directly controls interference source and minishs conduct EMI and improves electromagnetism compatibility , while it increases output voltage fluctuate and reduces voltage precision .

  29. 为了提高卫星干扰源测时差定位的性能,提出了四阶累积量时间差(TDOA)估计优化算法。

    In order to improve the function of TDOA estimation in satellite jamming emitter location , an optimize estimation algorithm based on fourth-order cumulant is presented .

  30. 在通信系统中,由许多干扰源的串音(的总和)引起的噪声。参阅crosstalk。录音时,环境噪声和回响之类的干扰使录音质量劣化。

    In communications , the aggregate crosstalk from a number of interfering sources . In sound recording , interference , such as ambient noise and reverberation , degrade the quality .