出口温度

基于BP神经网络的挤压力与挤压出口温度预测研究

Application of BP Neural Network to Predict the Extrusion Load and Exit Temperature Evolution during Extrusion Process

探讨了灰色预测模型GM（1,1）在磨煤机出口温度预测中的应用。

The application of Grey models GM ( 1,1 ) in the exit temperature prediction of coal pulverizer is discussed .

基于声学CT重建航空发动机燃烧室出口温度场的仿真研究

Temperature field simulation at aeroengine combustor exit on acoustic computer tomography

在国产化DCS上实现提升管出口温度控制

Realization of outlet temperature control in domestic DCS

VOD的出口温度能达到120℃高温，所以必须预防接触。

The outlet pipe of the VOD can reach temperatures up to120 ℃ .

仅供一次风的情况下，二燃室出口温度高，CO燃烬效果较差；

When the primary air is only supplied , the temperature at the exit of secondary combustion chamber is higher and the CO concentration in exhaust gas is higher , too .

考察影响葛根胶囊喷雾干燥试验的3个因素分别为：浸膏相对密度（A）、进风温度（B）、出口温度（C），每个因素取3个水平。

The inspection influence Radix capsule spray drying experiment 3 factors respectively are extracts the proportion ( A ), enters the wind temperature ( B ), the outlet temperature ( C ), each factor takes 3 levels .

同时，针对加热炉对象设计的整体控制方案表现良好，基础控制系统中采用的单神经元PID控制器控制效果出色，能够对加热炉出口温度进行快速响应和控制。

Meanwhile , the overall design for the heater control program behave good , basic control system used in the single neuron PID control performance is excellent , to the furnace outlet temperature for rapid response and control .

节流阀把高压侧压力节流到蒸发压力，同时控制高压侧压力并使其随气体冷却器出口温度的变化而变化，CO2制冷系统调节特性与传统制冷系统不同。

By throttles , the high pressure is dropped down to evaporator pressure , and changed with the refrigerant temperature at the gas cooler , the regulation characteristics of the system are different from traditional system .

单级蒸气压缩式CO2跨临界制冷循环的理论分析表明：蒸发温度、气体冷却器出口温度和高压压力对循环性能的影响较大。

Theoretical analysis on CO2 transcritical single stage compression refrigeration cycle is made . Results indicate that the evaporation temperature , gas cooler exit temperature and heat rejection pressure have important influence on the system performance .

根据实验数据分析了不同煤气流量、助燃剂的构成对燃烧室内部温度及出口温度、NO及CO分布的影响。

In addition , the influences the different coal gas flow rate and composition of combustion-supporting gas on the temperature in the combusting chamber , outlet temperature and distribution of NO and CO of are analysed based on experimental data .

波纹管对应强化传热修正系数Cx的值为1.85，对流段烟气中间温度、出口温度传热计算模型值和实测值的相对误差均不超过6.1%；

The compensation factor of corrugated tubes corresponding intensification heat transfer is 1.85 ; the relative error of the gas temperature in the middle and exit of convection segment between calculation data on heat transfer model and testing value does not exceed 6.1 % ;

得到了吸热器的能量损失、工质吸收能量、PCM的潜热储能和显热储能等重要指标，并且得到了换热管最大温度，工质出口温度等重要结果。

Heat loss , energy absorbed by gas , the latent and sensible thermal storage in PCM , tube maximum temperature , gas exit temperature and liquid PCM fraction were calculated .

HEAE气溶胶出口温度控制的实验研究

The Experimental Study of Controlling the Spout Temperature of HEAE

本系统采用松下fp∑系列plc控制器，由它处理相关输入输出信号，驱动各电动阀以及燃烧器，来控制整体除冰液的出口温度。

The system uses Panasonic FP Σ Series PLC controller , which will deal with relevant input and output signals to drive the electric valve and the burner to control the overall de-icing fluid outlet temperature .

球磨机制粉系统的出口温度和入口负压控制回路具有比较强的耦合作用，并且对象具有纯延迟特性，PID参数的整定比较复杂。

In a coal-pulverizing system , the control loop of exit temperature and entry underpressure has a strong coupling effect . Besides , the control objects have the characteristic of large delay time , so the tuning of PID parameters becomes very difficult .

各裂解炉管出口温度（COT）偏差的发散和误差的不确定，将对裂解炉操作和乙烯收率带来很大的影响。

The scattered coil - outlet - temperature ( COT ) and the unfixed temperature errors would influence severely the operation of cracking furnace and the ethylene yield .

着啤酒厂数量的增加，无论是国内啤酒厂还是国外啤酒厂都把希望寄托在降低啤酒出口温度（BOTS）上，以期在提高啤酒质量上争取主动。

An ever increasing number of breweries , both domestic and foreign , have mandated lower Beer Out Temperatures ( BOTS ) as a product quality improvement initiative .

第二部分介绍一种新型预测控制算法&模糊预测控制（PFC）在水泥回转窑分解炉出口温度控制中的应用情况，并给出了实际应用效果。

Secondly , a new kind of control algorithm , the Fuzzy predictive control ( FPC ) method is proposed . It is applied to design a control system of decomposing furnace exit temperature in Cement rotary kiln .

Delta-V系统在加热炉出口温度平衡控制中的应用

Application of Delta-V System in Balance Control of Heating Furnace Outlet Temperature

设计了整体的控制和安全解决方案，采用单神经元PID控制器作为加热炉出口温度串级控制系统的主回路控制器，应用CFC、SFC和SCL语言编程实现。

Design the overall control and security solutions , using single neuron PID controller as the furnace outlet temperature cascade control system of the main circuit controller , application CFC , SFC and the SCL language programming .

对化工厂PTA扩能改造后氧化反应冷凝器进行的工艺标定结果表明，换热面积不足，导致实际冷凝出口温度高于原设计温度。

After PTA capacity increasing modification , the technology rating results of the oxidation condenser showed that the heat transfer area was inadequate . As a result , the real condenser outlet temperature was higher than the original design one .

200MW核供热堆堆芯燃料元件盒冷却剂出口温度测量方法实验研究

Experimental Study on Measurement Method of Exit Temperature of Coolant of Fuel Assembly in Core of 200 MW Nuclear Heating Reactor

实验中发现，燃烧室内温度分布、出口温度场、污染物生成（即NOx、CO、UHC）及燃烧稳定性都受到加湿度的影响。

It was detected that the temperature distribution within combustor , the temperature field at combustor exit , the pollutant emission ( i.e. NOx , CO and UHC ) and the stability of combustion were affected by humidity .

通过对流场的平均温度、出口温度和壁面平均Nu数的比较发现，矩形结构表面具有较好的对流换热性能。在场协同原理基础上对该结论进行分析。

Through the comparisons of average temperature , outlet temperature and average Nu , it is found that the rectangular structure surface possesses better heat transfer performance . This conclusion is analysed based on field synergy principle .

研究结果表明，空气加湿燃烧导致NOx排放显著下降，CO和UHC排放略有上升，燃烧室中压力振荡的频谱产生了变化，燃烧室出口温度场畸变加剧。

The air humidified combustion may cause that NOx emission dramatically reduce , CO and UHC emission slightly increase , the spectrum of pressure oscillation within combustor changes , and the temperature field at combustor exit becomes more poor .

对断裂伸长率的影响依次为拉伸倍率、纺速、DF3出口温度。

The results showed the influence on fiber strength and elongation at break was in draw ratio , spinning speed , DF3 exit temperature order .

在此基础上，对反应器系统进行了模拟计算，分析了操作参数：转化器各段进口温度、转化器入口气体流量及转化器入口气体中氧气和二氧化硫的初始浓度比对SO2转化率和转化器出口温度的影响。

Based on the model , the reactor is simulated . The effects of operation condition on sulfur dioxide oxidation catalysis reaction such as the inlet temperature for each bed of reactor , gaseous flow rate and oxygen-sulfur dioxide ratio on SO2 conversion and outlet temperature are analyzed .

通过CAN总线将分布在1km轧线上轧制力、带钢宽度，入口、出口温度等信号采集上来。

By means of CAN field bus , the system collects the signals distributed along 1 km rolling line such as rolling force , strip steel width , entry and outlet strip steel temperature etc.

对于沸水设计工况的5MW低温堆，其堆芯出口温度尚未达到饱和。

For the designed two-phase regime operation of the 5 MW nuclear heating reactor , the temperature at the core exit has not reaches its saturation value .