首页 / 词典 / good

静压

jìng yā
  • static pressure
静压静压
静压[jìng yā]
  1. 对软土地基使用静压PTC管桩工程事故解析一文的商榷

    Deliberation of " Analysis of a Static Pressure PTC Pipe Pile Accident "

  2. KW静压造型线型砂性能控制

    Control of Mold Sand Property Used for KW Static Pressure Molding Line

  3. 本文介绍了静压气浮导轨的设计方法,开发了止推气浮轴承设计软件;

    The design methods of static-pressure air-bearing sliders were presented and an air-bearing design system was developed .

  4. 利用等静压技术制备牙科Al2O3/ZrO2陶瓷材料

    Preparing of Al_2O3_ / ZrO_2 Composite Dental Ceramics through Isostatic Pressing Technology

  5. 实验室型热等静压设备是开展HIP技术研究的基本手段。

    Laboratory-scale HIP equipment is an essential means for studying HIP technology .

  6. 热等静压(HIP)&消除铸件缺陷的有效方法

    Hot isostatic pressing ( hip ) & an effective method eliminating casting defects

  7. GaP(N,Te,Zn)的静压光致荧光研究

    A study of photoluminescence of gap ( n , te , zn ) under high pressures

  8. 试验结果表明:高静压处理可显著钝化草莓POD活性。

    Experimental results showed that high hydrostatic pressure could passivate POD significantly .

  9. 热等静压方法制备蓝青铜K(0.3)MoO3多晶材料

    Preparation of the Blue bronze polycrystalline material K_ ( 0.3 ) MoO_3 by HIP method

  10. PHC管桩静压法施工及质量管理探析

    Discussion of static pressure construction with PHC pipe pile and quality management

  11. 静压PTC管桩施工技术

    Construction Technique of PTC Pipe-pile Static Pressure

  12. 静压PHC桩在福州软土地区应用中存在问题分析与对策

    Application of PHC Pile in Some High Buildings of Fuzhou Soft Clay Area

  13. 对化学气相沉积(CVD)ZnS经热等静压(HIP)处理前后在光学透过率等方面的改变进行了比较分析。

    Transmittance of CVD ZnS before and after heat isostatic processing ( HIP ) was measured and compared .

  14. 评述了镍基铸造高温合金的热等静压(HIP)处理对组织和力学性能的影响。

    The effect of hot isostatic pressing ( HIP ) treatment on microstructure and mechanical properties of cast Ni-base superalloy as reviewed .

  15. 无锡财富广场住宅楼静压PHC管桩施工工艺及质量控制

    Construction technique and quality control of PHC tubular pile in residential building of Fortune Square , Wuxi

  16. 本研究采用近净尺寸冷等静压成型、无压烧结Si3N4工艺成功地制备出了6105柴油机田Si3N4陶瓷气门,对陶瓷气门材料及制备工艺进行了详细讨论。

    The silicon nitride ceramic valves for 6105 diesel engine were fabricated by near net size-cold isostatic pressing and pressureless sintering .

  17. 对某设计工况下,按正交设计方法得到的6组设计方案,使用以涵盖含气率α和静压p的综合指标λ评估,可很方便地筛选出较好的设计方案。

    Design schemes under a certain working condition is obtained by using the orthogonal method , which are evaluated by the comprehensive index λ containing α and p , and an optimal scheme is screened out conveniently .

  18. 均匀冲水施工过程分析;冲水静压PHC管桩施工技术

    Homogenous flush works anyslys ; construction technology of PHC pipe pile by air-lift , water shooting and static pressure

  19. 中国低活化马氏体钢CLAM热等静压扩散焊接初步研究

    Preliminary study on hot isostatic pressing diffusion welding for China low activation martensitic ( CLAM ) steel

  20. 应用PROFIBUS总线改造HWS静压造型线

    Application of PROFIBUS in the transformation of HWS moulding line

  21. 松花江漫滩地区静压PHC管桩沉桩阻力理论估算与数值分析

    Theoretical Estimation and Numerical Analysis on the Penetrating Resistance of Jacked-in PHC Pipe Pile in the Songhua River Floodplain Areas

  22. 利用化学共沉淀法及高能球磨工艺制备微米级Ag包覆SnO2复合粉末,然后采用冷等静压和烧结热挤压法制备AgSnO2材料。

    AgSnO_2 contact material is developed by chemical co-precipitation , high energy ball milling and powder sintering as well as hot extrusion .

  23. 对使用VB语言编写的集中空调系统冷冻水静压控制优化软件进行了在线测试,并对测试结果进行了分析比较。

    Optimization control software of static pressure of chilled water in HVAC system based on VB language is tested online and the test result is analyzed and studied .

  24. 本文介绍了4100QB缸盖在KW静压造型线的铸造生产工艺及生产装备;KW造型线已实现日产1100箱合格铸型,年产2.5万吨合格铸件;

    The produce capacity of the KW moulding line have achieved 1100 regular molds per day , and produce 25 thousand tons eligible castings per year ;

  25. K17铸造镍基高温合金热等静压后热处理的研讨

    Research on post-hip heat treatment of K17 cast nikel-base Superalloy

  26. 实验结果表明,热等静压处理可以显著减轻K(17)合金主要合金元素的树枝状偏析和共晶反应偏析,使合金成分趋于均匀,从而抑制了σ相的析出。

    The experimental results show that HIP can remarkably reduce the dendritic segregation and the eutectic reaction segregation of the main elements in alloy K17 , make the composition uniform and therefore , forbid the ? phase to separate .

  27. 静压管桩遇孤石夹层后竖向承载力研究压力注浆处理孤石夹层上PHC管桩基础

    STUDY ON THE BEARING CAPACITY OF THE STATIC PRESSURE PIPED PILE AFTER ENCOUNTERED BOULDER MEZZANINE Application of jet grouting to treatment of PHC tube pile foundation on boulder mezzanine

  28. 介绍了BMCHTG高精度液体静压储罐计量系统的系统支持标准、系统组成及其应用。

    The supporting standard , system components , and application of BMC / HTG high-accuracy hydraulic tank measuring system are introduced in the paper .

  29. 应用Solidworks软件建立了静压主轴的三维模型,并对其进行了运动干涉检查,验证了主轴结构的合理性。

    Solidworks , a 3D software , is applied to establish the geometric model of hydrostatic spindle , and check its movement interference . The result shows that the structure is reasonable .

  30. 本文介绍了冷轧DSR辊中静压支承技术的原理和测试方法,以及DSR辊静压润滑在宝钢的应用和维护经验。

    This paper introduces the principle of DSR roll 's hydraulic-static support system and it 's test methods . The maintain experience for DSR hydraulic static system is also discussed .