错移

300MW低压转子偏心错移工艺研究与实践

The Mis-Shifted Process Study and Practice of 300 MW LP Rotor

NW向断裂活动时代晚于NEENE向断裂，其右行走滑运动将NEENE向断裂截切和错移。

The active ages of NW trending faults are later than those of NE-ENE trending faults , and the right lateral strike slip movements of NW trending faults cut the NE-ENE trending faults to cause their dislocations .

断面滑动矢量分析和山前年轻冲积扇体和小冲沟沿断裂错移特征分析，表明太行山南缘断裂带是一条斜张左旋走滑边界断裂带，引张方向为NWSE至NNWSSE。

Analyses of fault plane slip vectors and displacement features of younger piedmont alluvial fans and small gullies along the fault suggest that the fault zone is an oblique-extensional , sinistral strike-slip boundary fault znoe , with the extension oriented in a NW-SE to NNW-SSE direction .

论述了用横向错移法测量单模光纤模场直径的测量原理、测量装置和测量结果，该方法是国际电信电报咨询委员会（CCITT）所推荐的单模光纤模场直径测量方法之一。

The principles and devices of the offset joint method for the measurement of mode field diameter of single mode fibers , which is one of the recommendations by CCITT , are described , and the experimental results are presented .

用于单模光纤模场直径测量的横向错移法的研究

Research on Offset Joint Method for the Measurement of Mode field Diameter of Single mode Fibers

针对支撑座形状特点，巧妙采用连锻方案，解决了曲面分模的水平错移问题。

Through adopting continuously forging , the shift of parting surface was solved according to the support shape .

第四纪断裂（以红河断裂为例）错移速率不断加大；

Displacement rate along fractures in the Quaternary ( for example Red River fracture zone ) has been accelerating continuously .

分析了锤上模锻件的主要缺陷&折叠、错移、氧化皮垫伤、锻模塌陷等的主要成因，提出了预防解决的措施。

Author analyzes the causes of main defects of hammer forgings , such as overlap , mismatch , scale mark as well as die collapse , and presents preventive measures .

流体相促进位错滑移与攀移，并加速应变颗粒的恢复作用，以协调破裂过程。

Fluid enhances dislocation glide and climb , increases the rate of recovery of strained grains and accommodates the fracturing .