轴方向

  • 网络axis direction;axial direction
轴方向轴方向
  1. 本文以一种电光调Q脉冲Nd:YAG激光器谐振腔为例,详细分析了1/4波片在谐振腔内的各种应用,并提出通过调节1/4波片的快轴方向来控制激光器偏振方向的方法。

    This paper gives a detailed analysis of the application of QWP in a typical pulse Nd : YAG laser resonator . Particularly , a method to control the polarization of the laser beam by adjusting the fast axis direction of QWP is proposed .

  2. 压力中心轨迹数据表明,实验组有跌倒史老年人相比正常老年人压力中心在X轴方向移动范围显著增加而在Y轴方向显著降低。

    The pressure center track data indicates us that , comparing to the elderly people who have fell down and the normal elderly people , the pressure center moving range on X axis direction of the former experimental group increase evidently , the result are opposite on Y axis direction .

  3. 菏泽5.9级地震前P轴方向呈现出由紊乱到趋向一致的特征。

    The direction of P axes change from tumble into identity before moderate earthquakes .

  4. 这里是,轴方向的等式:,for,the,x,direction。,没有加速度。

    So here come the equations x That 's all & there is no acceleration .

  5. Bi(2223)银夹板厚膜C-轴方向的超导电性

    The Superconductivity Of Bi ( 2223 ) Silver Clamped Thick Film Along C-axis

  6. 这是x轴方向。

    So that 's the x direction .

  7. 降低人体Z轴方向的G值增长率。

    Decrease of G onset rate in Z axis .

  8. 压电层沿z轴方向极化。

    The polarization direction of piezoelectric material is along the z-axis .

  9. 将阀门打开同时检查X轴方向偏差及阀体叶片的操作范围。

    Open the valve and check X axis deviation and operation range of the valve blades .

  10. 你也许现在想放弃,这个关于x和y轴方向的一元观点。

    And now * you may want to abandon now this one-dimensional idea of x and y.

  11. J集在x轴方向上具有周期性。

    The J sets are periodic on x-axis .

  12. 此外,还针对Y轴方向上的由于刀架位置变化导致的X轴方向上的不同步进行了负载动态补偿。

    In addition , for the X-drift asynchronous problem caused by Y-drift tool position variation , load dynamic compensation is proceeded .

  13. X轴方向的位移:横向最大位移在第一磨牙基骨,为-20.783μm;

    Displacement of X axis : The maximum lateral displacements were at the first molar of basal bone , -20.783 μ m.

  14. x,z轴方向的角速度对其也有影响,但影响较小。

    The angular velocities in x-axis and z-axis directions can also give influences , but the influences are less .

  15. 方向为x正轴方向,在碰撞前,它有一定动量。

    Let this be the direction of increasing x , and so before the collision I have a certain amount of momentum .

  16. 比如,在i向量的方向导数,就是x轴方向的分量。

    So , for example , the directional derivative in the direction of I hat is the component along the x axes .

  17. 采用提拉法沿a、b、c轴方向生长了Tm:YAP晶体,研究了该晶体的几种常见缺陷。

    Tm : YAP crystals were grown along a , b and c axis by Czochralski method . Several kinds of defects in the crystal were studied .

  18. 测定表明安康矿属占位调制及位移调制的复合型无公度调制,而且沿c轴方向为方波调制。

    The determination indicates that the incommensurate modulation of ankangite is a combination of occupancy modulation and displacive modulation , and is a square wave modulation along c-axis .

  19. 研究了射流z轴方向流速分量w等值线流团宽度随时间的变化规律并给出了拟合公式。

    Investigated variation regularity of jet flow velocity z component w isoline patch width and educed the fitted formulas .

  20. 高频焊接H型钢具有宽肢薄腹构件的特征,其强轴方向具较强的抗侧能力,形成刚性框架。

    The high frequency welding H-section steel has properties of broad and thin section component . Its higher axial lateral resistance capacity forms rigid frame .

  21. 但记住sigma轨道沿着,键轴方向是没有节点的。

    But keep in mind sigma orbitals have no nodal planes along the bond axis .

  22. 对往复流中射流z轴方向流速分量w等值线的影响范围进行了分析,得出了一些初步结论。

    Analyzed the incidence of jet flow velocity z component w isoline in reversing current , and got some elementary conclusions .

  23. X射线衍射测量结果表明利用该方法制备的GaN纳米线具有沿c轴方向择优生长的六角纤锌矿结构。

    The measurement results of X-ray diffraction reveal that c axis orientation is preferential in the growth of GaN nanowires with hexagonal wurtzite structure .

  24. 利用X射线衍射法进行涂层表面、结合界面、基材热影响区的Z轴方向残余应力分布测量。

    The Z axis residual stress distribution in coating surface , interface and substrate heat affected zone was measured by X-ray diffraction method .

  25. 本区应力场方向的总体特征是:平均P轴方向基本水平,并呈由西部陆地中心向沿海的放射状分布;

    The overall features of stress field are as follow : the mean P axes are nearly horizontal and orientate radially from the central part of the continent to eastern coastal region ;

  26. 二是在c轴方向上可能存在强烈的退磁效应,而在ab平面方向上退磁效应可以忽略不计。

    The other reason is that the demagnetization may exist along the c axis , which does almost not exist in the ab plane .

  27. 3i就是向x轴方向平移,但是平移3个单位,而不是一个。

    3i is just going to go along the x axis but by distance of three instead of one .

  28. 纤锌矿结构的ZnO晶体沿着c轴方向具有极性,自发极化对ZnO的光电性能、化学性质等都有重要影响。

    The spontaneous polarization along the c-axis will affect the structural , optical , electrical , and chemical properties of ZnO thin films and nano-structures .

  29. 目的应用组织多普勒心肌速度分布图(myocardialvelocityprofile,MVP)对左室短轴方向局部收缩功能进行评价。

    Objective This study was designed to evaluate the regional left ventricular systolic function in short-axis orientation by myocardial velocity profile ( MVP ) .

  30. 最后生成的截面轮廓沿Z轴方向看,外轮廓的边界点按其序号大小沿逆时针方向排列,内轮廓的边界点按其序号大小沿顺时针方向排列。

    In the last making section outline , the exterior ring points arrange as counter-clockwise and the interior ring points as clockwise .