设计车速

h-1运行；在颖河桥，货物列车可以按设计车速（80km.h-1）及以下速度运行。

And the speed of freight train running on the Yinghe river bridge can reach the design speed ( 80 km · h-1 ) .

高等级公路运行速度与设计车速匹配研究

Research on Coordination between Motorway Operation Speed and Design Speed

最大设计车速不超过50KM／h、发动机气缸总工作容积不超过50ml的两轮机动车。

The maximum designed speed is not morethan 50 km / hr , the total work capacity of the engine cylinder is not exceeding 50 ml two-wheeled motor vehicle .

这为高速公路在对应设计车速下最小平曲线半径的控制找到了以人为本的依据。

The study provides the basis for least horizontal radius taking into account of human with relative designing speed of expressway .

计算结果为设计车速下这些桥上列车不会脱轨，与长期横向振幅超限下行车未发生脱轨的实际情况符合。

The calculated results show that trains on these bridges will not derail within design speed , which is consistent with the practical facts .

同时，车辆能够按照或者接近设计车速行驶，获得尽可能不停顿的通行权。

Meanwhile , the vehicle can travel in accordance with or close to design speed to access to non-stop wayleave as far as possible .

从运营安全着手，得到了超大纵坡坡度、坡长和设计车速的确定方法。

From the view of operational safety , we obtained the method for determining large longitudinal slope gradient , slope length and design speed .

在对模型的分析讨论中，确定符合驾驶员行车时心理舒适要求的、设计车速为80kmh的高速公路平曲线半径的最小值。

After analyzing and discussing for model , minimum of the horizontal radius is identified meeting with mentality of drivers and design speed of 80km / h.

算例分析结果表明：对高车速纸机而言，设计车速对过盈量许可范围的影响不能忽略。

The results showed that the effects of design speed on the permissible range of the interference value could not be neglected , especially when the design speed was high .

通过分析加固段在道路使用中的作用和汽车的行驶轨迹，对不同设计车速的道路桥头加固段长度给出了建议值。

Through the analysis of the function of the reinforced part and the movement track of vehicle , the proposal value of length of reinforced roadbed is given for different design velocities .

草原道路由于驾驶车速经常高于设计车速，在总体事故发生率较低的同时，容易突发重大交通事故。

Due to driving speed is often higher than the design speed in prairie highway , it is easy to burst a major traffic accident with low accident rates of the total at the same time .

具体步骤是：建立具有安全系数的预防脱轨条件，确定在设计车速下预防脱轨的桥梁横向刚度限值，代入此值检算桥上列车走行平稳性与舒适性。

The detailed steps of the method include presentation of condition with safety coefficient for derailment prevention , determination of limit value of bridge lateral rigidity under design speed and check calculations of smoothness and comfort of running train on bridge .

基于格林伯格交通流理论，描述路网中的交通参数变化状态，并同时考虑交叉路口、车道宽度、设计车速等影响因素，建立了路段行驶时间模型。

Based on the Greenberg theory , the change state of parameter in the transport network is described , the intersection , lane width , design speed and other factors , took into account and the link travel time model is established .

为探讨有关技术问题，本文就城市环路建设的依据与条件、分类与设计车速、环网布设、规划与设计、服务水平、路段构造与横断面、交叉与连接等方面进行了阐述。

This article mainly discusses the concerned technical aspects in the basis , conditions , classification and design speed for ring road , layout of ring and radial road , planning and design , service standard , structure and cross section of pavement , intersection and connection , etc.

分别利用单神经元PID技术和直接广义预测控制技术设计了车速控制器和负荷控制器。

A single neurons PID speed controller and a direct generalized predictive control load controller are designed to control the speed and the load respectively .

在确定控制系统结构的基础上，设计了车速估算算法、油门位置PI控制器和制动门限控制算法。

Based on the configuration of hardware for traction control system , an algorithm for calculating reference vehicle speed , a controller for engine throttle with PI method , and an algorithm for brake with logic threshold method are devised .

论文按照国家标准设计不同车速下平顺性随机输入及脉冲输入下虚拟行驶试验，并在设计过程中编制了试验所需的路面谱生成程序。

According to the national criterion : Method of random input running test and Method of pluse input running test , the virtual road tests on the vehicle ride comfort are designed .

采用EDA技术设计的电子车速里程表

An Electronic Speedometer Designed by EDA Technique

出口国际（港澳台）邮件运输网路图册系统设计与实现由车速传感器采集的车速信号和设定车速的差值作为输入量，实际车速作为输出量。

Design and Implementation of the Diagram Volume System for International ( HK-Macau-Taiwan ) Export Postal Network ; The input is the error of the speed and the output is actual speed .

沪宁高速作为中国顶级高速公路之一，竟然用不同车种作为车道的设计标准而非车速，导致驾驶人员不得以刹车，原因是在最左边的车道上有一辆慢车。

Huning highway as one of the China best highway , was incredible setup lanes by different type of vehcile , not by driving speed , you can are forced to break as slow vehcile is in the most left lane .

增加高速巡航设计概念、以高速巡航设计车速为主最高车速为辅构成货车高速动力性的主要指标是本文的主要观点。

High speed crusing design concept should be added in design . High crusing design speed as main factor and max. design speed as secondary factor , these two factors are major index of high speed truck dynamic characteristics .

本文从交通设计的视角分析研究道路设计的若干问题，包括：道路横断面形式、车道宽度、设计车速、公交停靠站以及交叉口的标线与渠化问题。

Based on the traffic design , analysis is made of problems in road design , including the form of cross section , the width of lanes , design vehicle speed , bus stops , and markings and channelization at intersections .