聚合反应

jù hé fǎn yìnɡ
  • polymerization;polyreaction
聚合反应聚合反应
  1. C9-AM水溶性石油树脂聚合反应的研究

    The study on polyreaction of c9-am water soluble petroleum risen

  2. SAN聚合反应釜燃油锅炉温度控制系统设计

    Design of the oil boiler temperature control system for SAN polyreaction cauldron

  3. 己内酰胺聚合反应工程CAD软件包&Ⅰ.工业化生产实际值与软件包计算结果的比较

    CAD software for CPL polymerization engineering & ⅰ . comparison between calculation results and practical results

  4. 叙述了引入F原子或引入含氟端基的方法:电化学反应法、聚合反应法和其它反应法。

    Besides , diversity application for electrochemical reaction , polymerization and other reactions are introduced .

  5. 本体法合成ABS树脂Ⅱ.预聚合反应动力学研究

    Bulk polymerization of ABS resin ⅱ . Study on prepolymerization kinetics

  6. 对PVA用量、聚合反应温度、引发剂、pH值、AA/AAm等对胶粘剂性能的影响进行了研究。

    The effects of polymerization temperature , initiator , pH , PVA volume on adhesive properties were studied .

  7. KPS-Na2S2O3引发丙烯酸丁酯与玉米淀粉接枝共聚合反应的研究

    Study on KPS-Na_2S_2O_3 Initiated Graft Copolymerization of Butyl Acrylate onto Corn Starch

  8. 过氧化物酶催化的酚类聚合反应能够诱导形成纳米结构SiO2沉淀。

    Silica nanospheres were induced by peroxidase-catalyzed phenol polymerization .

  9. 高分子固载化Lewis酸催化剂催化α-甲基苯乙烯聚合反应及其动力学研究Ⅱ.PS-SnCl4复合物催化剂

    Polymerization of a-Methylstyrene Catalyzed by Polymer Supported Lewis Acid Catalysts ⅱ . Catalyst : PS-SnCl_4

  10. 聚合反应增长自由基ESR谱的交替线宽现象研究

    The alternating broadening effect of the ESR spectra for styrene propagating radical in bulk polymerization

  11. 对二苯酮(BP)/三乙胺(TEA)/氧体系光敏引发甲基丙炜酸甲酯聚合反应动力学进行了研究。

    Kinetic studies were carried out on the polymerization of MMA photo-initiated by benzophenone / triethylamine / oxygen ( BP / TBA / O2 ) system .

  12. 防老剂DNP对MC尼龙聚合反应的影响

    The Effect of Anti-oxidant DNP on MC Nylon Polymerization

  13. 丙烯酸与CMC接枝共聚合反应及吸水性能的研究

    Studies on the Graft Copolymerization Reaction of Acrylic Acid onto CMC and on Its Water Absorption Performance

  14. 研究了An在共单体中的比率对接枝共聚合反应行为及AES的缺口冲击强度的影响。

    The effects of An ratio in co-monomer on graft copolymerization reaction behavior and AES notched impact strength were investigated .

  15. 本文研究了(Pb3P)2PdCl2催化的丙炔醇一丙炔氯共聚合反应,红外及元素分析数据表明生成了丙炔醇一丙炔氯共聚物。

    The copolymerization of propargyl alcohol / propargyl chloride has been investigated by using ( Ph_3P ) _2.PdCl_2 catalyst .

  16. 介绍在己内酰胺阴离子催化聚合反应中,添加六甲基磷酰三胺作增韧改性剂制备改性MC尼龙。

    Hexamethylphosphoric triamide ( HPT ) was added as toughened modifier in anionic catalytic polymerization of caprolactam to prepare modified MC nylon .

  17. 依据聚合反应机理,采用ASPEN公司的POLYMERSPLUS为软件平台,对Hypol工艺的丙烯液相本体聚合过程进行建模与流程模拟。

    A comprehensive model for liquid phase bulk propylene polymerization was developed by using polymers plus of ASPEN .

  18. ZrO2-SiO2复合氧化物催化THF聚合反应的评价结果表明,所制备复合物在THF聚合反应过程中表现出良好的催化性能。

    The polymerization of THF indicated that all of the mixed oxide showed good catalytic performance .

  19. 聚合反应的动态特性具有时变、非线性、时滞的特点,应用传统的PID控制和一般的模糊控制算法,难以得到较好的控制效果。

    The dynamic characteristics of polymeric reaction are time-variant , non-linear , and with pure delay . The traditional PID and fuzzy control are not adapted to this kind of objects .

  20. 因为是三元反应,且AA对反应体系的PH值有影响,单体配比的影响讨论起来比较复杂,AA的比例含量对聚合反应影响较大。

    Because it is triple response , and AA will affect the PH of system , so that discussing the affection of monomer ratio is very complicated .

  21. 许振明教授选择了成本较为低廉的不饱和聚酯作为聚合反应的原料。对成品的机械性能测试显示,混合了PCBs的产品的性能甚至比纯聚酯还要好。

    The mechanical properties of the new material show good results with tests revealing better properties than pure UP polymers .

  22. 宽或双峰分子量分布HDPE的研制&Ⅰ.双金属复合催化剂的制备及其催化乙烯聚合反应动力学

    Study on Wide or Bimodal Molecular Weight Distribution HDPE ⅰ . Preparation of Bimetallic Composite Catalyst and its Reaction Kinetics in Ethylene Catalytic Polymerization

  23. 本文报导了(Ph3P)2·PdCl2存在下的丙炔醇与邻苯二甲酸的共聚合反应。

    Propargyl alcohol has been Copolymerized with phthalic acid by using ( Ph_3P ) _2 . PdCl catalyst .

  24. 氯硅烷在MoO2Br2催化体系引发丁二烯聚合反应中的作用

    Effect of chlorosilane in polymerization of Butadiene Initiated by moo_2br_2 catalyst system

  25. LLDPE聚合反应器SGV值的计算

    Calculation of SGV of LLDPE Reactor

  26. 采用UV固化技术可以使含有不饱和官能团的活性单体、预聚物在光引发剂的作用下进行光聚合反应发生交联。

    UV curing is used to induce photochemical polymerization or crosslinking of a monomer , prepolymer formulation containing a certain type of unsaturation , such as an acrylic group , and an appropriate initiator .

  27. 本文通过测量PMMA基片在光致聚合反应法复制过程中的形变和收缩应力,由此对其产生的机理作了一定的理论分析。

    In this paper , the deformation and shrinkage stress of PMMA substrate during the photopolymerization processing has been measured , the mechanism of them is also theoretically discussed here .

  28. 重点研究了蒙脱土(MMT)以及有机蒙脱土(OMMT)对本体法甲基丙烯酸甲酯(MMA)聚合反应机理以及聚合物结构的影响。

    The effects of MMT and Organo-MMT ( OMMT ) on the bulk polymerization mechanisms of methyl methacrylate and terminal polymer structure are also studied .

  29. 结果表明:AN与AIA在二甲基亚砜(DMSO)中的共聚合反应,遵循自由基共聚合机理。

    It has been demonstrated that the copolymerization of AN and AIA in dimethyl sulphoxide ( DMSO ) conforms to the mechanism of radical polymerization .

  30. 应用MonteCarlo方法模拟聚合反应中链增长和链交换反应速率常数,结果表明每一个活性中心接受约6个单体插入后发生链转移反应结束该聚合链增长。

    Monte Carlo method has been developed to estimate the chain propagation constant and exchange reaction constant . In average , one exchange reaction will occur after approximate six monomer molecules insert into the growing chain .