沟槽

gōu cáo
  • trench;groove;slot;ditch;depression;rut;delve
沟槽沟槽
沟槽 [gōu cáo]
  • [rut] 车轮磨下或任何东西经常通过所留下的痕迹;任何东西来回移动的凹沟

沟槽[gōu cáo]
  1. 爆炸波传播的沟槽效应及分析

    Damping Ditch Effect in Propagation of Blasting Seismic Wave and its Analysis

  2. 复杂环境和复杂地质条件下的沟槽控制爆破

    Controlled blasting with ditch in complicated environment and geology

  3. P波与沟槽充填介质的作用研究

    Study on the Interaction Between the Filling Medium for slot and P Waves

  4. 结果表明亚甲基蓝可以与DNA发生强烈的作用,其作用模式为混合模式(主要为静电键合,沟槽键合)。

    Interaction mode of MB with DNA were electrostatic attraction and groove-binding .

  5. 试验结果表明,与普通醋纤滤嘴相比,C型沟槽滤棒的硬度可提高2~3个百分点;

    The results showed that the hardness of the grooved filter was 2 to 3 percentage points higher ;

  6. SEM显示:试样表面微观形貌变得粗糙、出现斑点,甚至出现了沟槽等。

    Sample surface became crude , appeared spot and cannelure for even .

  7. 带有疏液盘的V型垂直沟槽管的冷凝传热研究

    Study of Heat Transfer of Condensation on Vertical V-type Corrugated and Smooth Tubes with Drain-disks

  8. 发现Eu3+-芦丁配合物与DNA通过静电吸引和沟槽键合模式键合。

    All experimental results indicate that the complex binds to DNA by the electrostatic mode and the groove binding mode .

  9. PAN干湿法纺丝工艺中原丝的表面沟槽形态

    Study on the surface of PAN fiber in wet-spinning and dry-jet spinning

  10. 由SEM照片可见,普通粘胶短纤维、共混短纤维的表面均有沟槽。随着甲壳素含量的增加,沟槽变宽。

    There exists crank on the surface of fibre , which becomes wider with increasing chitin content .

  11. V型沟槽尖峰形状对减阻效果及流场特性影响的数值分析

    The effects of the tip shape of V-groove on drag reduction and flow field characteristics by numerical analysis

  12. 基于FLUENT的纵向沟槽水润滑轴承流体润滑数值分析

    Numerical Analysis for Fluid Lubrication on Longitudinal Grooved Water-Lubricated Bearings Based on FLUENT

  13. 实验还表明:氧氟沙星Tb3+探针与DNA分子之间主要是沟槽式结合。

    All experimental results indicate that the groove binding is the major mode for the interaction of ofloxacin-Tb 3 + fluorescence probe with DNA .

  14. 利用半导体测试仪对芯片进行了测试,包括探测器的暗电流、响应度和结电容,并分析了深n阱、浅沟槽隔离等工艺步骤对探测器参数的影响。

    Some critical parameters of these new structure photodetectors , such as dark current , responsivity , and junction capacitance , are measured and analyzed .

  15. 木瓜蛋白酶的芳香族氨基酸残基在DNA大沟槽中与它的碱基之间的芳基堆积作用是引起吸收光谱变化和荧光猝灭的主要原因。

    Papain interacted with the major groove of ctDNA . Aromatic stacking interaction is the main reason of change of absorption spectrum and fluorescence quenching of papain .

  16. 结论巴罗沙星以沟槽键合方式与DNA相瓦作用;Mg~(2+)对巴罗沙星与DNA的结合有中介作用。

    Conclusion Balofloxacin interacted with CT-DNA in the mode of groove binding and Mg ~ ( 2 + ) could mediate the binding of balofloxacin to DNA .

  17. 沟槽型MOSFET的发展(英文)短沟道场效应晶体管

    Development of Trench MOSFET short channel fet

  18. 窄沟槽衬底条形GaAlAs/GaAsDH激光器特性的测量和分析

    Measurement and analysis of characteristics of narrow-channeled substrate stripe-type GaAlAs / GaAs DH lasers

  19. 目前关于离子注入退火后SiC表面出现犁状沟槽缺陷的形成机制的理论和实验研究还是空白。

    At present , there are not theoretical and experimental reports on the mechanism of furrow defects on SiC surface after high-temperature annealing .

  20. 采用ANSYS有限元软件详细地研究了强激光作用下水冷硅镜的沟槽结构对镜面温升和变形峰谷值的影响。

    The influence of the channel parameters of the water-cooled Si mirror on temperature and thermal deformation was simulated using ANSYS finite element analysis .

  21. 基于傅里叶变换红外反射谱的DRAM深沟槽结构测量系统研究

    Model-Based FTIR Reflectometry Measurement System for Deep Trench Structures of DRAM

  22. 同时,基于各向异性刻蚀的同性刻蚀也可得到V型沟槽,但其质量有待提高。

    In the meanwhile , V-grooves could also be obtained using isotropic wet etching method based on anisotropic etching method , while the quality is undesirable .

  23. 金属结合剂杯形小直径CBN砂轮端面磨削沟槽底面时砂轮的自锐效应

    Effect of CBN wheel self-dressing in face grinding of groove bottom with metal bond cup CBN quill

  24. 负载体系中,TiO2以薄膜的形式包覆在ACF的表面,在ACF条带状沟槽处的薄膜煅烧时容易开裂,裂口处是负载体系结合性的薄弱环节。

    TiO2 film located groove in ACF easy to craze and the crack was the combination weakness of support system .

  25. 钢锭中形成沟槽偏析的传热条件不仅与凝固冷却速度有关,而且取决于轴向温度梯度GA与径向温度梯度GR之比。

    Thermal conditions forming channel segregation in a steel ingot depend not only on cooling rate but also on the ratio of axial temperature gradient , GA ? to radial one , GR.

  26. 为了抑制假模的出现,通过刻蚀沟道深隔离,并在沟槽上沉积SiO2介质绝缘层,增加沟槽对假模的吸收。

    In order to suppress the appearance of so-called spurious modes , we etched deep grooves and deposited SiO2 in the grooves .

  27. 简述了减薄GaAs衬底的作用,设计衬底电隔离沟槽宽度为5μm。

    It is necessary for this device to decrease the GaAs substrate thickness . And the bottom isolation groove width is designed as 5 μ m.

  28. 利用二维LDV系统对零压力梯度下光滑面和减阻沟槽面湍流边界层流场进行对比测量。

    Two-component LDV measurements in a turbulent boundary layer with zero pressure gradient have been performed .

  29. 已成功地在GaAs(100)面衬底上制作了周期为0.33微米的光栅皱折.在GaAs(100)面上的光栅皱折具有良好的V-形沟槽轮廓。

    Gratings with a period of 0.33m have been successfully fabricated on GaAs ( 100 ) plane substrate and the grating corrugation has better V-shaped groove profile .

  30. 设计了一种新结构垂直腔面发射激光器(VCSEL),即采用环形分布孔结构取代以往的环形沟槽结构。

    A new structure design for VCSEL is reported using perforated ring instead of ring trench .