最大允许偏差

  • 网络Maximum allowable deviation;Max deviation
最大允许偏差最大允许偏差
  1. 结论按照IAEA要求,该项比对的最大允许偏差为±1.5%,所以这次比对结果是合格的。

    Conclusion The deviation of calibration factors between IAEA and SSDL should be no more than ± 1.5 % . Therefore , the result of this intercomparison is considered satisfactory .

  2. 对大量数据的精减,利用角度和弦高的最大允许偏差法进行点云精减。

    A error limitation of angle and chordal highness method is used to filtrate clouding point .

  3. 文中对6种典型变化情况进行了计算分析,从中确定滚道位置最大允许偏差范围,作为加工和测量时的控制值。

    In this paper , 6 typical variation conditions are calculated and analyzed . The maximum allowable deviation range of raceway position is determining as a control value for machining and measuring .