时效强化

  • 网络ageing strengthening;aging strengthening;age hardening
时效强化时效强化
  1. Cu-Ni-Si-Cr-Fe合金时效强化特性的研究

    Study on Age Hardening Characteristic of Cu-Ni-Si-Cr-Fe Alloy

  2. 机械合金化制备Cu-Cr合金时效强化特性的研究

    Study on Age Hardening Characteristics of Cu-Cr Alloy Prepared by Mechanical Alloying

  3. SiCp/AI合金复合材料时效强化的综合模型

    A combined model of the aging - strengthening of sic_p / al alloy composite

  4. 基于人工神经网络的Cu与Mg低质量比Al-Cu-Mg合金时效强化预测模型

    Ageing prediction model for low mass ratio of Cu to Mg of Al-Cu-Mg alloy based on neural network

  5. 采用新近发展的静液挤压加工技术,对传统的W-Ni-Fe合金进行加工形变,并研究了形变时效强化作用。

    By using recently developed isostatic extrusion processing technology , work deformation was conducted for conventional W-Ni-Fe alloy and influence on its deformation aging strengthening was studied .

  6. 基于人工神经网络的Cu-Cr-Zr合金时效强化性能预测研究

    Study of Properties in Age Hardening Cu-Cr-Zr Alloy by an Artificial Neural Network

  7. Al-Cu-Mg-Ag合金时效强化的神经网络预测模型

    Prediction of aging strengthening of Al-Cu-Mg-Ag alloy based on neural network

  8. 研究结果表明:该材料符合Mises屈服条件并具有强化特性;Ti-5Al-2Zr-2Sn-4Cr-4Mo合金时效强化特性

    The results show that the material exhibits Mises hardening characteristic . Study of Decomposition and Aging Hardening of Ti_5Al_2Zr_2Sn_4Cr_4Mo Alloy

  9. 时效强化Cu-Fe-P合金显微硬度的模糊预测

    Fuzzy Predictive Model for Microhardness of Aging Treatment Cu-Fe-P Alloys

  10. 结果表明,高体积分数SiC颗粒的加入带来的弥散强化作用,可以大幅度提高基体合金的硬度和强度,但区别于基体合金和低体积分数复合材料,复合材料本身时效强化效果不明显。

    The results show that the strengthening effect due to the addition of particles plays the leading role and aging strengthening is not the major strengthening mechanism for the high volume fraction SiC_P / LD2 composite .

  11. Al-Zn-Mg-Cu合金是时效强化合金,具有优良的综合性能,被广泛地用作航空航天领域的结构材料。

    Age-hardenable Al-Zn-Mg-Cu alloys have been widely used as the structural materials in the aerospace industry because of their excellent performance .

  12. 试验结果表明,单独加Ag对2197合金的固溶强化效果很小,但有较强的时效强化作用。在本试验中,添加05wt%Ag最为合适;

    The result showed that small addition of Ag alone has a little effect on solution-strengthening of 2197 alloy but strong aging-strengthening , the addition of 0.5wt % Ag is the most appropriate for 2197 alloy .

  13. 时效强化Fe-Ni-Ti-Al因瓦合金的力学与膨胀特性

    Mechanical Property and Expanding Property of Age Hardened Fe-Ni-Ti-Al Invar Alloy

  14. 结果表明:Cu-Zn-Cr合金是典型的时效强化型合金;

    The results show that Cu-Zn-Cr alloys are typical precipitation hardening alloy .

  15. 本文介绍作者在研制时效强化型合金时设计使用的测定时效过程中GP区温度的一种简易方法。

    In this paper , a simple method of measuring the temperature of GP zone in the process of age-hardening is described . We studied and manufactured the ageing strengthening alloy using this method and found it is effective .

  16. 工业结晶器用Cu-Co-Be合金时效强化机制

    Age-hardening mechanism of Cu-Co-Be alloy for industrial crystallizer

  17. 在Al-Zn-Mg-Cu合金中加入0.2%的混合稀土可提高强度和塑性,提高时效强化效果,改善热处理工艺性和耐蚀性。

    Adding 0.2 % mixed rare earths to Al-Zn-Mg-Cu alloy can enhance strength and plasticity , increase the ageing strengthening effect , and improve corrosion resistance and heat treatable performance of the alloy .

  18. Cr-Zr-Cu铜合金属于沉淀硬化的高强、高导、时效强化型合金,目前对其焊接性的研究和应用很少。

    Cr-Zr-Cu copper alloy is a precipitation hardening alloy with high strength , high conductivity , age-hardening type alloy , there are rarely research and application about weldability of this material .

  19. 当时效强化型合金中第二相以Orowan机制产生强化效应时,材料强度升高的幅度与基体中析出物的平均间距成反比。

    When the second-phase in the ageing-hardening alloy generates strengthening effect by Orowan mechanism , the increasing strengthen is inverse proportion to the average spacing of the precipitate among the matrix .

  20. Al-Ag合金是时效强化合金的典型代表,通过对该合金微观机理的研究,发现更多的规律,可以作为其他合金材料设计的指导。

    Al-Ag alloy is the representation of the aging hardening alloy , from the study of the microcosmic mechanism , we can find the rule which would be beneficial to the design for other alloy .

  21. 探讨了ZL110油锯活塞铸造余热淬火的脱模时间对铸淬效果及人工时效强化规律的影响。

    Influence of mould releasing time of direct quenching of ZL110 alloy chain saw piston making use of remanent heat after casting on quenching effect and strengthening of artificial aging were studied .

  22. 牙科低金含量银钯合金时效强化机制

    Age - Hardening Mechanism of a Low-Gold Content Dental Casting Alloy

  23. 铍青铜的热处理缺陷分析和双重时效强化

    Heat Treatment Defects of The Beryllium Bronze and Its Double Age-Strengthening

  24. 时效强化铝合金的机械性能分析

    The Mechanical Properties and Analysis of Age - Hardening Aluminium Alloy

  25. 铝合金时效强化的实验研究及屈服强度计算

    Experimental research and prediction of yield strength for aging strengthened aluminium alloy

  26. 2090铝锂合金时效强化相间的耦合作用

    Interaction of strengthening phases in 2090 aluminium - lithium alloys

  27. 高速铁路接触线用时效强化铜合金的发展

    Development of Aging-Strengthening Copper Alloy Used in Contact Wire of High-Speed Railway

  28. 具有盘状析出相铝合金的时效强化模型

    A model for age strengthening of plate-like-precipitate-containing Al alloys

  29. 奥氏体型铁基合金时效强化机理研究

    Research of aging - strengthening mechanism of an austenitic iron - based alloy

  30. 镁合金的强化方式主要有固溶强化、时效强化和细晶强化等。

    Aging and grain refinement are two major strengthening procedures in magnesium alloys .