首页 / 词典 / good

处膜

处膜处膜
  1. 一般认为,Co/Pt多层膜的垂直磁各向异性主要源于界面处沿膜面法向的平移对称性中断队及Co与Pt的d电子杂化。

    For Co / Pt multilayers , the perpendicular magnetic anisotropy is mainly re-sulted from the reduced symmetry and the hybridization between Co and Pt d orbits at interface .

  2. 结论①胎儿ASA的发生可能与妊娠早期FO处帘膜形成或继发隔的发育异常有关,因此与ASD密切相关;

    Conclusions Fetal ASA may be associated with the formation of foramen oval 's membrane in early pregnancy or secondary growth abnormality of heart septum .

  3. 利用X射线衍射仪测量了多层膜结构,在德国BessyⅡ同步辐射上测量了在工作波长处多层膜反射率,测量的峰值反射率达7.5%。

    The periodic thickness and structure of the multilayer are measured by X-ray diffractometer ( XRD ) . The reflectivity of the multilayer is measured at Bessy ⅱ synchrotron radiation ( SR ), and the peak reflectivity is measured to be 7.5 % .

  4. 本文的计算结果具有二次压力尖峰和出口处油膜颈缩等典型EHL解特征,且最大Hertz压力达到了1.3GPa,这在国内尚属少见。

    The calculating results possess the typical characters of EHL solution , such as quadratic pressure spike and the neck of oil film thickness at outlet eto . , and the maximum Hertz pressure is about 1.3 GPa , which is so high as to be less seen at home .

  5. 活齿与活齿架接触处油膜厚度的计算

    Calculation of Oil Film Thickness between Sliding Tooth and Sliding-tooth Holder

  6. 气-液界面处水合物膜形成过程的传热分析

    Heat transfer during gas hydrate film formation on gas-liquid interface

  7. 该方法同样适用于轴颈中心任意位置处油膜力的雅克比矩阵计算。

    The method is well suited for the Jacobian matrices calculation when the journal is located at a random position .

  8. 在等电点处,膜渗透性达到最大值。金属离子截留系数随流动电位增大而增大。

    At the IEP , The permeability of the membrane reached maximum value , and rejection coefficient of metal ion increased with increasing streaming potential .

  9. 当封闭润滑油核心位移大于该临界位移,其移动速度小于卷吸速度,核心处油膜厚度下降。

    But the speed of the core became lower than the entrainment speed and the core film thickness decreased as soon as it moved beyond the critical position .

  10. 实验发现,旋转气流对进口处降膜产生较大干扰,并直接影响下部壁面液膜的水量分布。

    It is found that rotating air had greater interference to the falling film at inlet , and directly had impact on the water distribution of the following film .

  11. 以轿车轮毂轴承为例,分析了主要工况参数对滚子-滚道接触处润滑膜压力分布和润滑膜形状的影响。

    The influences of working parameters , such as load and velocity , on lubrication film shape and pressure distribution are analyzed for the typical working conditions of the hub bearings .

  12. 作者通过分析计算动载荷轴承油膜区间的变化规律,发现轴承滑油进口处油膜压力随时间变化。由于轴承进口处油膜压力变化,导致滑油进口处存在压力波。

    Through analysing the fluctuation of oil film pressure of a bearing , it is found that the oil film pressure at the inlet of the bearing , varies with time , and it leads to the presence of pressure wave at the inlet of the bearing .

  13. 结论外丘穴地的位置,有特定动脉分支分布,其血管密度高,穴位处骨间膜上钙高,x2且集中于7寸附近。

    Conclusion Specific arterial branches are distributed and the density of the blood vessels is high at point Waiqiu earth . Calcium in the interosseous membrane at the point is high in content and concentrates near 7 cun above lateral malleolus .

  14. 6眼黄斑中心凹处新生血管膜形成、出血行视网膜下手术。

    And subretinal microsurgery was performed on 6 eyes of AMD with subfoveal choroidal neovascularization ( CNV ) and hemorrhage .

  15. 用溶解&沉积理论解释了铝离子在膜与溶液界面处形成新膜物质的机理。

    The process of film material formation by aluminium ions at the film-electrolyte interface is explained by a direct dissolution-precipitation theory .

  16. 在合体细胞游离面有纤维蛋白样物质沉着处,基底膜往往同时增厚。

    On the free surfaces of syncytial cells , fibrous deposition was sccn and the basal membrane of these cells was thickened .

  17. 排出极体处的细胞膜微绒毛消失,其下方是中期纺锤体,此区域可能为第二极体的释放部位。

    Near the area through which the first polar body was extruded , the microvillus of oocyte disappeared , where the second polar body might possibly be extruded .

  18. 考察了芯片构型和流体流速对稳定流体界面的影响,并尝试在两微通道的交叉处进行纳滤膜的制备。

    The chip configuration and fluid flow rate on the stability of fluid interfaces were studied , and nanofiltration membranes integration was tried at the connection of the two micro-channel .

  19. 实验结果表明:在环境湿度较高的条件下,碱性电池密封处的水膜就会被电解,产生错误的可能性就会大大增加。

    The results of experiment indicated that condition of environment humidity were higher , water was electrolysed on the sealing position , the possible of producing error results could increase .

  20. 当电流密度超过某一临界值时,部份铝离子在膜与溶液界面处形成新膜物质,膜的形态为壁垒型。

    When the applied anodic current density exceeds a critical value , a fraction of the aluminium ions acts as film material at the film - electrolyte interface in the form of barrier film .

  21. 结果①生长期毛囊:LM均匀的表达于毛乳头处,在基底膜处呈明显的线状表达,外根鞘处表达也呈明显的阳性;

    Results In the anagen phase , LM was expressed in dermal papilla , basement membrane and outer root sheath ;

  22. 正常组在神经移植处不放任何膜。

    No membrane was implanted in the normal group .

  23. 外侧角1/2处与1/4处膜边和中央细胞的上述指标健患侧间有差异,患侧各项均小于健侧。

    But on lateral crus 1 / 2 and lateral crus 1 / 4 , There were significant difference between two sides .

  24. 但膜表面泥饼层较薄,并不致密,且有多处孔洞,而膜断面上也仅有少量的不规则的颗粒物存在。

    But the mud cake layer was thin , sparse and multi-hole on the surface of membrane and there were only a small number of irregular particles on the membrane section .

  25. 观察标本上内皮脱落处的内弹性膜,用立体学方法测量照片上的窗孔数和面积,计算出单位面积上窗孔的平均面积。

    By observing the internal elastic membrane on the samples where endothelial cells fell off , measuring the number of fenestrae and relevant area on the pictures with stereological method , and counting fenestra area per unit area .

  26. 结果:内侧角1/2处与穹隆脚处膜边和中央细胞面积、周长、等效圆直径等测量值,健患侧间无显著性差异。

    Results : Comparing lateral and central cells ' area , perimeter and the same circle diameter , there were no significant differences between two sides of alar cartilages of medial crus 1 / 2 and middle crus .