千字节

Maximummessagelength：QCapture程序可以放置在发送队列中的消息的最大长度（千字节）。

Maximum message length : The maximum size ( in kilobytes ) of a message that the Q Capture program can put on the send queue .

Kbread：报告在测量时间间隔中从物理卷读取的总数据量（单位为千字节）。

Kb_read : Reports back the total data ( kilobytes ) from your measured interval that is read from the physical volumes .

如果该值为1000或更高，Informix将其解译为一定数量的千字节。

If the value is1000 or higher , Informix interprets the value as a specific number of kilobytes .

Kbps：报告已传输的数据量（单位为千字节）。

Kbps : Reports back the amount of data transferred in kilobytes .

文件大小–数码相片的大小以千字节（KB），兆字节（MB）或千兆字节计数（GB）。

FILE SIZE – the size of an image in digital photography , measured in kilobytes ( KB ), megabytes ( MB ), or gigabytes ( GB ) .

文件大小-必须小于等于240千字节。

FILE SIZE-Must be less than or equal to240 kilobytes .

设置/返回队列日志大小的最大值（以千字节为单位）。

Sets / returns the maximum size ( in kilobytes ) of the queue journal .

日志文件大小必须是介于8和1000000千字节之间的值。

The log file size must be a value between 8 and 1,000,000 Kbytes inclusive .

填充速度表示为每秒字节或每秒千字节。

This Fill Rate is described either in terms of Bytes per second or kilobytes per second .

本装置能以140千字节/秒的写带速率连续写40兆字节数据。

The apparatus can record 40 megabytes of data continuously at a recording rate of 140 kilobytes per second .

使用查看文件夹大小，您可以查看文件和文件夹大小的字节，千字节，兆字节和千兆字节。

Using View Folder Size you can view file and folder sizes in bytes , kilobytes , megabytes and gigabytes .

平均实例吞吐量是所有完成的请求数（以千字节为单位）除以参与客户数。

Average instance throughput is the total size of all completed requests in kilobytes divided by the number of participating guests .

默认情况下，使用的单位为千字节，但您可以使用选项-b替换为字节，使用-k替换为千字节，使用-m替换为兆字节，或使用-g替换为千兆字节。

By default the display is in kilobytes , but you can override this using-b for bytes , - k for kilobytes , - m for megabytes , or-g for gigabytes .

指定了打印机会接受的最大作业（作为字节流），单位是千字节。取值为0时，表示未设置限制。

Specifies the largest Job ( as a byte stream ) that the Printer will accept in units of Kbytes . A value of zero indicates that no limit has been set .