过盈配合联接

塑性状态过盈配合联接的承载能力计算

The calculation of bearing capacity of interference fit joint in plastic deformation

齿轮组合圆柱面过盈配合联接设计分析

Analysis of the Interference Fit of Cylindrical Surface in Combination With Gear

过盈配合联接条件分析

Analysis on the connection condition of interference fitting

有限元分析软件在过盈配合联接安全核算中的应用

The Application of Finite Element Analysis Software in Stress Computation of the Surplus Joint

在高速旋转条件下过盈配合联接强度变化的计算过盈配合的选择方法

Calculation methods for the excessive matching couple under the high rotation condition the choosing of interference fit

另外，还采用接触单元对孔轴过盈配合联接组件进行了有限元分析，得到更为精确的强度分布。

Furthermore , the contact finite element was adopted to gain the accurate distribution of strength in the subassembly with the interference between the axle hole and the shaft .

本文主要论述在高转速的条件下，由于径向离心惯性力的作用，过盈配合联接的配合面上，比压及过盈量变化的计算方法。

This paper has mainly discussed the calculation method of the pressure and the excess change on the couple surface in excessive matching , which were caused by the centrifugal inert force under the high rotation condition .

本文以标准直齿圆柱齿轮和轴的过盈配合为例，说明了ANSYS有限元分析软件在过盈配合联接安全核算中是可以适用的。

Following the example of surplus joint of standard straight cylinder gear and axle , the article has explained that ANSYS Finite Element Analysis software can be applied to stress analysis of the surplus joint .