热弹性

本文具体针对弹性、电导和热弹性给出了IDD估计。

This dissertation gives the IDD estimation for elasticity , electric conductivity and thermoelasticity specifically .

在此基础上，对于TiC／Ni3Al系梯度材料（FGM）在稳定状态下产生的隔热应力，利用有限元方法进行了热弹性模型下的三维解析。

The heat-isolated stress of a disk-like TiC / Ni3Al FGM in steady-state are analyzed under the assumption of thermoelasticity with an axisymmetric finite element method .

K式反应罐的热弹性及蠕变分析

Thermal - elastic and Creep Analysis of K-type Reaction Cylinders

激光冲击作用下材料的非Fourier热弹性响应

Non-Fourier thermoelastic response to laser impact on a target

任意边界形状层合板热弹性分析的Hamilton半解析法

Hamilton semi-analytical method to study thermal elastic problem of composite laminates with any contour

Cu-Zn-Al合金中热弹性马氏体转变理论

Theory for Thermoelastic Martensitic Transformation in A Cu-Zn-Al Alloy

本文选择Cu基形状记忆合金作为研究对象，借助内耗测量手段，对热弹性马氏体相变的机理进行了较为系统的研究。

Cu-based SMA is selected for studying in this text , and the mechanism of thermoelastic MT is well and systematically studied by means of internal friction ( IF ) measurements .

用这种热弹性分层模型模拟计算了密执根（Michigan）盆地在古生代的沉降曲线。

The subsidence curves of Michigan Basin during Paleozoic era were modeled by using the layered thermo-elastic model in the paper .

VN型回转式空气预热器转子径向隔板热弹性变形模型

Thermoelastic model for deformation of the radial plate in rotary regenerative air heater

Cu-Al-Ni合金热弹性马氏体转变与冷却速度的关系

The relationship between thermoelastic martensitic transformation and cooling rate in Cu-Al-Ni alloys

非线性热弹性问题的Hamilton半解析法及其在层合板固化降温过程中热应力的分布研究

Hamilton semi analytical method for nonlinear thermo elastic problem and investigation of residual thermo stress distribution of composite laminates during the cooling down stage of cure process

介绍了β－NiAl金属间化合物的热弹性马氏体相变与形状记忆效应及其韧化途径。

Reviewed are the thermoelastic martensitic transformations , shape memory effec and toughening techniques in intermetallic β - NiAl alloys .

论耦合热弹性力学中各种Gurtin型变分原理

On Gurtin & type Variation Principles for Coupled Thermoelasticity

以热弹性理论为基础，采用ANSYS顺序耦合有限元程序对加热炉半热滑轨在不同外形参数下的传热、应力和应变进行了三维数值模拟。

On the base of the thermal-elastic theory , the three-dimensional finite element numerical analysis simulated distribution of temperature , strain and stress in the modest hot slides with ANSYS sequential coupling analyzing heat transfer and stress equations .

进一步指出在集成分析中热弹性分析需要解决的问题及Zernike多项式拟合中需要注意的问题，归纳了使用统一分析方法时需要特别注意的问题。

Some issues on thermal-elastic analysis and the fitting of Zernike polynomial in integrated analysis are addressed . The problems need to be considered in unified analysis are summarized .

基于经典的叠层板理论和热弹性力学的有关理论，合理简化边界条件，建立了一维非对称热应力缓和型功能梯度材料（DFM）分析模型。

The analysis model used for calculation of thermal stress in FGM is estab - lisd based on , The classical lamination theory and thermal-elastic mechanics with five assumptions .

探讨了激光与物质相互作用的机理，重点是其传热学和热弹性力学理论，并对有限单元法和ANSYS软件进行了说明。（2）成功实现了移动高斯函数分布热源在圆柱表面的加载。

Explored the interaction mechanism between the laser and material , especially emphasised on its heat transfer and thermal elasticity theory . Finite element method and ANSYS software were also introduced . ( 2 ) The moving Gauss function distribution heat source was successful loaded in the cylindrical surface .

基于热弹性力学和结构优化理论，针对典型的PBGA封装体在工作过程中的受热问题，建立了有限元数值模拟分析模型。

Based on the theory of thermal elasticity mechanics and structural optimization , the models of finite element numerical simulation for thermo-mechanical analysis of a plastic ball grid array ( PBGA ) package design are established .

试验结果表明：将合金加热到β单相区淬火后，立即在β1状态时效一定时间（30～60min），可获得稳定的形状记忆效应，并保持马氏体热弹性特征。

It is found that , after heating to simple β phase and quenching in water , immediate ageing for 30 ~ 60 minutes at β _1 phase can bring about stable shape memory effect and martensite thermoelasticity .

应力边界元法解平面热弹性问题

A bounday element method based on stress for plant thermoelastic problems

基于本体温度场的齿轮热弹性变形的综合研究

Combination Research on Gear Bulk Temperature Field and Thermal Elastic Deformation

随机介质热弹性力学模型球坐标问题的解析解

An analytical solution for spherical coordinate of random media thermal elastic model

激光辐照下有界圆厚板的热弹性弯曲响应分析

Analysis of thermoelasticity bending response of circular thick plate irradiated by laser

由热弹性分析探讨空间遥感相机结构形式

Investigation Scheme of the Space Remote sensing Camera Structure by Thermoelastic Analysis

六边形式双周期分布圆形弹性夹杂平面热弹性问题初探

Plane thermo elastic problem of hexagonal doubly-periodic arrays of circular elastic inclusions

大型光学镜子热弹性变形的有限元分析

Finite Element Analysis for Thermoelastic deformation of Large-Sized Optical Mirror

大变位热弹性扁壳的一种边值模型

The Boundary Problems of Thermoelastic Shallow Shell of Finite Deflection

空心球复合材料热弹性性质的一些精确结果

Some Exact Results Concerning Thermoelastic Properties of Hollow Sphere Composites

单晶叶片的热弹性蠕变分析

Thermoelasticity Creep Analysis of Aircraft Engines Single-Crystal Air-Cooled Turbine Blade

功能梯度材料扁锥壳的热弹性大变形分析

Large thermoelastic deformation analysis on shallow conical shell of functionally graded materials