炼胶

浅析炼胶设备的发展动向及特点

Analysis on the development trend and feature of rubber mixing equipment

无大小驱动轮，公司生产的炼胶机全部采用滚动轴承。

No small driving wheel , the company produced rubber mixing machine used in all bearing .

详细介绍了密闭式炼胶机高压油泵改成由可编程控制器（PLC）控制过程。

Detailed introduction of high pressure oil pump for mixer modified with PLC control .

基于SVM的密炼机混炼胶的粘度预测

Prediction of the Viscosity of Mixed Rubber in Mixer Based on SVM

GTO混炼胶的b型膨胀比（B）略小于其它两软化剂胶料，挤出物表观并无明显差异。

There was no obvious difference between the appearance of extrudates of two compounds .

纳米氧化锌母炼胶对NR性能的影响

Influence of nano-zinc oxide masterbatch on physical properties of NR vulcanizate

填充MC尼龙轴承在开放式炼胶机辊筒上的应用

Application of Filled MC Nylon Bearings for the Roller of Opened Refine Rubber Machine

NR／SBR混炼胶挤出流动中自然收敛角的计算

Calculation of Natural Convergent Angle of NR / SBR Compound Flow during Extrusion

ENR、MG塑炼胶的热氧老化性能研究

Study on Thermal and Oxygenous Aging Behavior of Unvulcanized ENR and MG

加入NR可使PB混炼胶的最宜加工温度和速度范围变宽。

The optimum ranges of processing temperature and curing rate for1,2-polybutadiene are widened by blending with natural rubber .

应用ANSYS软件对NR/炭黑混炼胶的平入口收敛流动进行二维有限元模拟。

The 2 D finite element simulation for the converging flow of NR / carbon black mix at planar entrance was made by ANSYS software .

控制器以8031单片机为核心，采用积分分离PID算法，对炼胶釜的温度采用闭环控制。

The controller uses an 8031 single chip microprocessor , adopts integrate separate PID algorithm , and applies close loop control to the temperature of the producing pot .

研究了EBR生胶的加工性能和混炼胶特性。EBR生胶的混炼特性不如BR和IIR。

The properties of EBR processing and vulcanizate was studied .

混炼胶质量预测和排胶控制的GMPLS模型研究

GMPLS model for mix quality prediction and dump control

采用Z桨捏合机，将端乙烯基硅橡胶、气相法白炭黑及羟基硅氧烷进行混炼，制备了高强度硅橡胶混炼胶。

High strength silicone rubber compounds were prepared using vinyl-terminated silicone rubber , fumed silica and hydroxy siloxane by intensive mixing method in Z blade mixer .

混炼胶以210℃×4h水解处理得到的阻尼硅橡胶综合性能为好；

The mixed rubber was hydrolyzed by 210 ℃× 4 h , the properties of damping silicone is better .

结果表明，预先将聚脂短纤维和EPDM混炼制成母炼胶，然后再与PP共混进行动态硫化制备的复合材料的性能最佳。

The results showed that the blending method of premixing masterbatch of short polyester fiber and EPDM , and then blending with PP was the best method .

研究了填料对反-1，4-聚异戊二烯（TPI）硫化胶和混炼胶的物理机械性能和结晶性能的影响。

Effect of different fillers on mechanical properties and crystallinity of trans-1,4-polyisoprene ( TPI ) was investigated .

实例分析采用多流道传递式（MCT）混炼冷喂料挤出机连续制备混炼胶的工艺条件及特性。

The processing conditions and characteristics of continuous preparation of compound with MCT cold feed extruder were analyzed with examples .

用孟山都流交仪测定了不同共混比的甲基乙烯基硅橡胶（VMQ）／EPDM共混混炼胶的流变性能；

The rheological properties of VMQ / EPDM compounds with different blending ratio were determined by Monsanto rheometer ;

研究了不同硫黄硫化体系对EPDM混炼胶硫化特性、硫化胶物理机械性能以及喷霜问题的影响。结果表明，一定并用比的M/TRA/BZ/S；

The effects of various blending systems consisting of different accelerators on physical-mechanical properties and blooming of EPDM vulcanizate and vulcanization properties of EPDM compound were studied .

研究了锡偶联型溶聚丁苯橡胶（SSBR）生胶及其混炼胶的流变性能，并与乳聚丁苯橡胶（ESBR）作了对比。

The rheological properties of Sn-coupled SSBR raw and compound were studied and compared with ESBR .

表面活性剂单独使用或与ZnO、MgO并用均可硫化氟丁橡胶CR-1211，且能明显延长混炼胶的门尼焦烧，改善橡胶的加工性，提高硫化胶的物理机械性能。

Cationic surfactants could vulcanize CR - 1211 either alone or together with ZnO and MgO , with much better scorch resistance and processability , as well as better mechanical properties of vulcanizate .

随着LDPE与MVQ混炼胶的质量比的增加，材料的耐热老化性能下降。

The thermal aging resistance of LDPE / MVQ hybrid rubber decreased with the increase in the mass ratio of LDPE : MVQ .

将Fuzzy-PID算法应用于炼胶釜温度控制系统，以单片机作为温度控制系统的核心部件，实现了一套温度控制的设计方案。

Applying Fuzzy-PID algorithm to refining adhesive temperature control system , regarding one-chip computer as the key part of the control system of temperature , a design plan has been realized .

研究了不同乙二醇焦油（GTO）用量对硅铝炭黑（简称SAC）丁苯混炼胶的硫化活化、交联密度及力学性能的影响，得出了综合三种性能于最佳点的最宜GTO用量。

The effects of the amount of GTO on the activation vulcanization , the crosslink density and the mechanical properties of SAC black filled SBR compounds have been studied .

硫化动力学研究表明，含PrDTP-8的混炼胶硫化反应活化能E和频率因子A分别为87.15kJ/mol和2.33E+10。

The study showed that the curing reaction activation energy ( E ) and the frequency A were 87.15kJ/mol and 2.33E + 10 , respectively .

研究了液体天然橡胶（LNR）对NR及其炭黑混炼胶加工性能的影响。

The effect of liquid natural rubber ( LNR ) on the processability of natural rubber ( NR ) and black filled NR compound was investigated .

针对橡胶密炼机混炼胶质量的软测量建模问题，研究了适用于MISO软测量模型的一种RBF算法。

For establishing the model of soft measurement of the quality of mixing rubber in rubber mixing mill a RBF algorithm that is suitable for MISO soft measurement model is studied .

试验研究白炭黑补强乳聚丁苯橡胶（ESBR）混炼胶中的网络结构及网络结构对胶料门尼粘度和动态粘弹性的影响。

The network structure of silica-filled ESBR compound and its effect on Mooney viscosity and dynamic visco-elasticity were experimentally investigated .