温度场

一个坑道周围的等温线可以理解为原始温度场的叠加。

The geoisotherms around a gallery can be explained as a superposition of the original temperature field .

结合比色测温法，给出一种基于彩色CCD图像的温度场测量方法。

A high temperature field measurement method based on color CCD is discussed according to the principle of two color pyrometer .

空间载波相移法用于全息CT测量气体温度场

Spatial carrier phase-shifting method to the holographic CT measurement of gas temperature field

用ANSYS分析钢-混凝土组合柱的温度场

Analysis of the thermal field of steel-concrete composite columns using ANSYS

电子束钎焊温度场PID控制系统

Electron beam brazing temperature field PID control system

ANSYS在激光熔覆成形温度场数值模拟中的应用

Application of ANSYS Software in Temperature Field Numerical Simulation of Laser Cladding Forming

关于2-D温度场计算的有限元法分析

Research on the Finite Element Method of 2-D Thermal Field

高压给水加热器温度场及流场的CAE分析研究

CAE Analysis and Research on Temperature Field and Flow Field of High-pressure Feed Water Heater

随机温度场Monte-Carlo法的一类近似处理

Approximate Method of Monte-Carlo Method in Stochastic Temperature Field

Kriging算法在温度场计算中的应用分析

Application Analysis of Kriging in the Calculation of Temperature Field

采用ANSYS有限元软件，系统模拟了强激光作用下的热补偿全反射硅镜的温度场分布和热变形。

The temperature and thermal deformation distributions of the thermal compensation mirror were simulated using ANSYS finite element analysis in this paper .

Marc对温压模具进行热场分析，模拟了模具的温度场状况。

Marc . are used to analyze the thermal field and simulate the temperature field of the mold .

采用ANSYS编写的程序得到地源热泵换热器的温度场分布，通过对运行结果分析得出：单管换热时埋管对周围的土壤温度影响半径；

ANSYS procedures used to prepare the ground source heat pump heat exchanger temperature distribution analysis of the results : single-tube heat exchanger pipe to the surrounding radius ;

采用格子玻耳兹曼（LB）方法建立了等离子射流温度场和速度场的计算模型，与传统数值方法相比，LB方法具有直观的物理背景。

A model for calculating the velocity and temperature field of plasma jet by Lattice Boltzmann ( LB ) method was established .

应用有限元软件Ansys，对某铁水脱硫喷枪的工作温度场与应力场进行动态仿真，显示喷枪在一次工作循环条件下热应力的动态分布。

The working body temperature field and stresses field of desulfurizing lance has been dynamically simulated with the finite element software Ansys to show the dynamic thermal stresses distribution within lance in a duty cycle .

利用CFD商用软件Flow-3d对铝板坯半连续铸造充型过程中流场与温度场耦合作用下的凝固过程进行了数值模拟。

The numerical simulation of solidification processes were done under flow field and temperature field by using CFD commercial code Flow-3d .

分别采用线性和均匀温度场模拟了生物探针在生物化学反应中的瞬态和稳态温度分布，从而解释了Fritz有关DNA分子杂交实验中的双金属效应。

Linear and uniform temperature fields are used separately to simulate transient and steady temperature distributions in biochemical reactions in order to explain the bimetallic effects in Fritz 's experiments on DNA hybridizations .

经实验验证：该系统能够检测到熔池的温度场变化信号，并能控制步进式TIG焊的焊接时间和行走时间。

The experiments show that the variable temperature signal can be detected and the welding time and traveling time can also be controlled in " step " TIG welding by this system .

得到材料内部的瞬态温度场以及由温度梯度引起的瞬态应力场，该应力场以超声Lamb波的形式在铝板材料中传播。

Then , the transient stressfield induced by temperature grads was obtained in the plate , and it is found that the transient stressfield propagates in the form of Lamb waves in the aluminum plate .

参与研制开发了有关温度场、应力场及MgO混凝土膨胀场的分析软件，并将上述软件有机地与ANSYS软件结合，在ANSYS基础上开发了外掺MgO混凝土仿真分析的专用软件。

( 3 ) Participating in the developing of analysis software about temperature field stress field and expand field of concrete ; Combining these software with ANSYS and developing special software for simulation analysis of MgO-mixed concrete base on ANSYS .

RCCD三维温度场仿真分析的浮动网格法

The relocatable grid method of simulation analysis on three-dimensional temperature field of RCC dam

结合对实测数据的分析，本文对大通风量房间不同供暖方式下室内温度场和PMV分布进行了数值模拟。

Numerical simulations are carried out by analyzing on the experimental data for discussing the indoor temperature field and PMV distribution under different ventilating rate and different heating method .

针对火电厂DCS缺乏全面而直观地反应炉内燃烧信息的现状，研发了在DCS中实现炉内三维温度场可视化的方法。

Directing against the situation of distributed control system ( DCS ) in power plants can 't fully and directly reflect combustion information in the furnace , a method can effectively realize the three-dimensional ( 3D ) temperature field to be visualized in DCS has been developed .

应用商用软件对某手术室的通风效果作了数值模拟。计算采用RNGkε紊流模型，使用现场测量数值作为边界条件，求解了三维速度场、温度场及空气龄。

Numerically simulates the ventilation effectiveness in a hospital operating room , by use of a commercial software and an RNG K ε turbulent model , with boundary conditions of site measured data , solving 3 D velocity and temperature and air age in the space .

利用有限元软件ANSYS模拟了32m混凝土箱梁在进行蒸汽养护时的温度场分布情况，证实已设计的蒸汽养护方案是可行的，分析得到的温度分布规律可以为类似的工程借鉴。

By means of FEA software & ANSYS , the paper simulates the temperature field of the 32 m box beam during steam curing , which shows the steam curing means designed is workable , and it is suitable for similar engineering .

通过对谐振腔内非线性晶体工作状态的分析，利用解析的方法得出了全固态激光器中非线性晶体KTP内部温度场的精确计算方法，并分析了影响KTP晶体内部温度场变化的各种因素。

According to intracavity nonlinear crystal working-state analysis , in high power all-solid-state laser system nonlinear crystal KTP interior precise temperature field is obtained by analytical thermal analysis method , and all kinds of relevant parameters influenced crystal interior temperature field distribution are analyzed .

利用Pro/E软件建立GJ-90型可变几何涡轮增压器（VGT）可调叶片和支撑盘的几何模型，并借助有限元分析软件ANSYS对其进行温度场分析及热变形计算。

The geometrical models of the GJ-90 style variable geometry turbocharger ( VGT ) 's regulating vane and supporting plate were built with Pro / E. The temperature fields and the transfigurations of the parts were calculated with ANSYS .

结果表明二阶全展开ETG有限元方法有较好的稳定性和较高的精度，在计算温度场和流场的时间演化过程方面有一定优点。

All the above shows that the second order and full extension ETG finite element method features a relatively fair stability and precision , and has its definite merits when used to evaluate the time evolution process of temperature and flow fields .

提出了带有PV的新型Trombe墙结构，建立了二维的光伏玻璃板以及PV-Trombe墙系统的数理模型，获得了系统的温度场、太阳电池的电性能和室内得热。

A novel Trombe wall with PV cells is presented in this paper . A two-dimensional model of PV glass panel and the model of the PV-Trombe system are established . The temperature distribution , electrical performance and heat gain of the PV-Trombe wall system are obtained respectively .

利用模拟空间热循环温度场设备对太阳能电池中石英玻璃盖片/硅橡胶粘合剂/硅晶片胶接结构进行了真空热循环试验（123～403K，10-5Pa）。

The vacuum thermal cycling tests ( 123 ~ 403K , 10 - 5 Pa ) were carried out on the bonding structure of quartz glass cover / silicon rubber adhesive / silicon crystalline in solar battery , using the system simulating the temperature filed of thermal cycling in space .