汽车风洞

汽车风洞试验地板边界层控制技术

A Study on Boundary Layer Control of Vehicle Wind Tunnel

欧洲汽车风洞技术的发展动向

Development of Auto Wind Tunnel Technique in Europe

汽车风洞声学控制研究

The Study of Automotive Wind Tunnel Acoustic Control

汽车风洞试验中的雷诺数、阻塞和边界层效应问题综述

A Review on Reynolds Number , Blockage and Boundary Layer Effects in Automotive Wind Tunnel Tests

虚拟汽车风洞

Virtual Automobile Wind Tunnel

本文介绍了用局部开槽内部吸气法控制汽车风洞试验地板边界层的新技术。

The paper introduced a new technology to control the boundary layer of vehicle wind tunnel with the method of part-gutter inspiration .

首先实验研究了收集口喉部间隙及其大小对汽车风洞低频颤振的影响，结果表明：在一定的间隙下低频颤振最小。

Sound natural frequency of wind tunnel tube plays a key role in researching the buffeting phenomenon of low speed automotive wind tunnel .

介绍了汽车风洞的特点，汽车模型风洞试验与实车风洞试验的差异以及用航空风洞进行汽车模型风洞试验应注意的问题。

This paper describes the characteristic of automobile wind tunnel , the difference between automobile model wind tunnel , airplane wind tunnel , and some important problems about applying airplane wind tunnel to testing the automobile model .

PIV技术在汽车模型风洞中的应用

The Application of PIV Technology in Automotive Wind Tunnel

比较试验分别在TJ-2和德国斯图加特大学IVK汽车模型风洞中实施。

The comparison tests were carried out in both TJ-2 and IVK automotive model wind tunnel respectively .

厢式载货汽车模型风洞试验技术的研究

Research of Wind Tunnel Testing Technique for Model of Van Body Truck

汽车散热器风洞试验的计算机模拟软件开发

Development of Simulation Software for Automotive Radiator Wind Tunnel Tests

TJ&Ⅱ对汽车模型风洞地面边界层控制机理和控制设备研制

A Discussion on Boundary Layer Control of TJ-I Automotive Model and Control Equipment

汽车模型风洞试验支架干扰修正的试验研究

Experimental Investigation of the Support Interference Correction for Vehicle Model Wind Tunnel Tests

汽车数字风洞中的虚拟现实技术

Virtual Reality Technology in Digital Automobile Wind Tunnel

新概念汽车模型风洞试验研究

An Experimental Study on the Aerodynamic Characteristics of New Concept Car by Wind Tunnel Test

介绍了所开发的一种汽车散热器风洞试验计算机模拟软件及软件实际应用情况。

The developed automotive radiator wind tunnel test simulation software and its application are introduced .

FD－09风洞改造为汽车模型风洞的关键技术研究

The Study of Key Technology about Improving FD 09 Wind Tunnel into Automobile Model Wind Tunnel

本文就汽车模型风洞试验的条件、方法及现阶段模型风洞试验在汽车开发中的作用等进行了分析。

The conditions , methods and the effect of wind-tunnel test in the development of a vehicle are analyzed .

通过对汽车模型风洞试验腹部支架干扰的分析，提出了测量支架干扰的空装模型法。

A " Separating Model and Support ( SMS ) method " for measuring support interference is proposed according to the analysis of the support interference for vehicle model wind tunnel tests in this paper .

对不同车灯造型参数的汽车模型进行风洞试验。

It carries out wind tunnel tests of automotive model with different parametric modeling of automotive lamp .

开口式汽车气动声学风洞的低频颤振现象

Buffeting Phenomenon of Open-jet Automotive Aero-acoustic Wind Tunnel

介绍了基于传统风洞试验数据基础上，汽车散热器芯子散热性能数学模型的建立，并在此模型下，开发出汽车散热器风洞试验的计算机仿真系统。

Based on the documents of traditional wind-tunnel experiment , the mathematical model was established , And the computer simulation system was developed about the wind-tunnel of auto radiator on the basis of it .