标准附录
-
对GB16749&1997标准附录B不锈钢薄板射线探伤分级的修改建议
Amending Advice to the Appendix B of GB16749 1997 Classification of Radial Examination to Stainless Steel Sheet
-
IEC60947-2低压断路器标准附录F(一)带电子过电流保护的断路器的附加试验
IEC 60947-2 Low Voltage Circuit Breaker Standard Appendix F Additional Test on the Circuit Breaker With an Electronic Overcurrent Protection
-
参考了DICOM标准附录33中灰度软拷贝显示状态对该问题的解决方案,提出了一种新的改进算法。
The paper implements the Grayscale Softcopy Presentation State specified by DICOM Supplement 33 , and proposes a new improved algorithm .
-
结论该方法提出了测定TVOC样品的最佳测试条件,其精密度和样品回收率均符合室内空气质量标准附录A《室内空气监测技术》中的要求。
Conclusion The optimal test condition for determining TVOC in air has been presented in this paper . The precision and sample recovery rate will meet the requirement of indoor air quality standard annex A Indoor Air Monitoring Technology .
-
设计建筑物时,“混凝土用紧固件设计”技术标准附录A中提及的荷载和额外设计要求应予以考虑。
In the design of the structure the loads and additional design requirements given in Annex A of that Technical Specification should be taken into account .
-
介绍了PC级和CB级ATSE的主要技术性能要求,并介绍了温升等其他试验项目及标准的附录A中的一些规定。
Introduction to main technical specifications and requirements of PC and CB class ATSE is made and as well as temperature rise etc other test items and some regulations in Appendix A.
-
附录A是标准的附录,构成本标准的一部分。
Annex A forms a normative part of this Technical Specification .
-
讨论了60Co辐照室内O3的排除计算方法,对计算公式中某些计算系数的来源及运算符号的正确表述作了说明,与相关标准提示的附录中给出的计算方法进行了比较。
Calculation method of removing ozone from 60 Co irradiation room is discussed in this paper . The source of calculation parameters and the correct expression of the calculational symbols in the formulas are explained and compared with thoes given in the relevant standards .
-
在标准3中已附录了一个基本的审计培训标准。
A basic audit training standard is annexed to standard No3 .