弹性浮动

  • 网络Elastic Float;Elastic Floating
弹性浮动弹性浮动
  1. 单晶金刚石弹性浮动研磨技术研究

    Study on Elastic Float Lapping of Single Crystal Diamond

  2. 实验观察到金刚石弹性浮动研磨过程中存在着三个不同的加工区域:金刚石表面凹坑区、解理区、光滑区。

    Three different lapping regions , including crater area of diamond surface , dissociation area and smooth area , were observed during diamond lapping process by elastic float lapping .

  3. 影响金刚石刀具弹性浮动研磨质量的因素研究

    The Research on the Factors of the Quality in Diamond Elastic-Float Lapping

  4. 论文采用单因素方法,对弹性浮动加工系统中研磨盘的转速、弹性系数对加工的表面质量的影响进行了研究。

    In this paper , the effects of lapping speed and elastic coefficient on the quality of diamond surface are discussed .

  5. 与国内同类的小型带锯床相比,具有液压进给、电泵冷却、压锯弹性浮动的不同特点,大大提高了带锯的使用寿命。

    With domestic similar with the small compared with hydraulic telefon , feeding , cooling , sawing demonstration of elastic floating different features , greatly improving the bandsaw life-span .

  6. 本文金刚石的加工方式为弹性浮动研磨,研磨盘安装在一个弹性垫上,金刚石被夹具固定在一个弹性梁上,二者通过一种耦合的关系发生作用对金刚石实现加工。

    The grinding plate is installed on an elastic mat ; diamond is fixed on an elastic beam clamp , both through a coupling relationship works on implementation of diamond processing .

  7. 从弹性浮动研磨后的金刚石表面可以看出,不断变化的冲击主要来白研磨盘的端跳和弹性梁的振动。

    We can see , from the diamond surface after elastic float lapping , that the variational impact is mainly produced by the end beating of grinding disc and the vibration of elastic beam .

  8. 接触刚度和接触阻尼与弹性浮动研磨中加工工艺参数存在一定的联系,要研究这种关系,首先必须弄清楚弹性浮动研磨加工中的加工工艺参数。

    There are certain contacts between contact stiffness , contact damping and elastic floating in the grinding process parameters . To study this relationship , we must first know the elastic floating processing technology parameters of the grinding process .

  9. 弹性浮动研磨金刚石的表面形貌主要受到加工过程中冲击振动的影响,这种冲击振动主要来自研磨机械内部结构的振动和加工工艺参数两大部分。

    Elastic floating grinding surface morphology of the diamond are mainly affected by the impact in the manufacturing process of the influence of vibration . The impact vibration mainly comes from internal structure of grinding machine and machining process parameters .