吸水管

  • 网络suction;Suction pipe;Siphon;Streamer Z-Valve&Tube
吸水管吸水管
  1. 一种立式自吸泵,是由进水段、吸水管、导水锥、喇叭管等所组成。

    The utility model relates to a vertical self-sucking pump , which comprises a water inlet section , a suction pipe , a water-guide cone , a flare tube and the like .

  2. 不带泵进行试验,模型比尺的选取应保证一定的进水池宽度、水深和吸水管直径,从而提高试验结果的可靠性。

    In order to improve the reliability of test results , the selection of model scale should be appropriate to guarantee a minimum sump width , water depth and suction pipe diameter .

  3. 对于不平衡、涡轮气蚀、不对中、吸水管/尾水管共振、止漏环的腐蚀、尾水管的功率摆动和100Hz的铁心共振等导致水力发电机的振动/噪音做了特征分析。

    Typical vibration and noise data of turbine runner cavitation , mechanical & hydraulic unbalance , misalignment , penstock resonance , draft-tube resonance , draft tube surging due to pressure pulsation , rough-zone operations , worn seals and generator 120 Hz core resonance are displayed and analyzed .

  4. 产生原因:泵体和吸水管没灌满引水;

    Causes : pump body and suction tube not filled with water ;

  5. 离心泵吸水管上加装负压吸水罐的分析

    Analysis on Installing Negative-pressure Container on the Syphon of a Centrifugal Pump

  6. 铅直双吸水管圆形进水池试验研究

    Experimental research on circular inlet pools with aluminium double-suction tubing

  7. 无堵塞式吸水管

    The Non - plugging Type Water Suction Pipe

  8. 无吸程变频恒压设备用于二次供水无堵塞式吸水管

    The Non-plugging Type Water Suction Pipe

  9. 处理方法:检查吸水管与底阀,堵住漏气源;

    Approach : at the end of check valve and water pipe , blocked the leak source ;

  10. 离心泵泵腔和吸水管内全部充满水并无空气,出口泵关闭。

    Cavity and the suction centrifugal pump tube filled with water does not all the air , turn off the export pumps .

  11. 产生原因:影响水泵流量不足多是吸水管漏气、底阀漏气;

    Reasons : lack of impact of water flow is the water pipe leaks and more , at the end of valve leakage ;

  12. 本文提出了一种消除泵站水泵吸水管内旋涡和流动分离的圆锥形防涡装置。

    In this paper , a conical swirl-proof device is proposed to prevent eddy and flow separation in the water-inhaling pipe of the pump .

  13. 本文着眼于使用计算流体力学方法对带有竖直吸水管、正向进水的开敞式前池与进水池的流态进行数值模拟。

    In this paper the open sump flow with vertical intake is simulated with calculation fluid dynamics method according to model-test reports of Lianhu pump station .

  14. 一种旋转式自动伸收吸水管的水壶,它包括:一具有容室和一开口端的壶身;

    The utility model relates to a water pot with a rotary automatic-telescopic water suction tube and is mainly characterized in that a pot body is covered with a pot cover .

  15. 初级滤网由40目筛绢制成,用圆钢和铁丝网框架支撑成网箱状,水泵吸水管的进水口设在其中,以滤掉粗大颗粒。

    The primary filter net framed into a cage by iron bars is set at the mouth of the inlet tube of the pump , to filter out large particles in the water .

  16. 一种背负式喷雾器,由箱体、气室、唧筒、连杆、摇杆、曲柄、带吸水管的喷管组成。

    A shoulder sprayer comprises a box body , a gas chamber , a pump , a link rod , a rocker , a crank and a spray tube with a suction pipe .

  17. 陈籍水泵在启动以前,泵壳和吸水管内必须先布满水,这是因为有空气存在的情况下,泵吸人口真空无法形成和保持。

    B.water-filled Pump start before the pump casing and suction pipe must be full of water that is because of the presence of air vacuum pumping the population can not be formed and maintained .

  18. 若在吸水管上加装负压吸水罐,可在底阀泄漏情况下,使吸水管内水位不下降,启动泵时可省去灌泵程序。

    If installs negative-pressure container on the syphon , in the condition of bottom valve leaking enables the water level in the syphon not fall , when start the pump , can leave out the procedure of pouring the pump body with water .

  19. 设计不良的泵站进水建筑物,在不带泵运行的情况下,也会引起水泵进口水流预旋和吸水管内涡流,改变水泵的进水条件,恶化水泵的能量特性和汽蚀特性。

    Incorrect designed intake structure of a pumping station may result in pre swirl in the flow entering the pump and swirl in suction pipe even under no pump operation , which shall change flow condition , and affect adversely both pump performance and cavitation characteristics .

  20. 分析了离心泵吸水管底阀泄漏,使管内水位下降至低于最大允许吸上真空值,致使每次启动泵前,必须往泵体和吸水管内灌满水才能启动泵;

    Analyses that because of bottom valve leaking in a syphon of a centrifugal pump , water level in the syphon falls to below the vacuum value of permitting suction , causes that must fill the pump body and the syphon with water before starts the pump every tim ;

  21. 包覆吸水性材料椭圆管式间接蒸发冷却器的理论与实验研究

    Theoretical and Experimental Study of Ellipse Tube Type Indirect Evaporative Cooler Wrapped with Absorbing Water Materials