剩余电流动作保护器

剩余电流动作保护器应用中的中性线问题

About Problems of Neutral Conductor in Application of Residual Current Operated Protective Device

剩余电流动作保护器

Residual current operated protective device

对低压配电系统的故障状态进行了分析，论述了低压配电系统接地方式适用的范围，指出剩余电流动作保护器（RCD）适用的接地方式，以及RCD参数的选择。

It carries out analysis on the break-down state of low-voltage power distribution system , discusses the adaptable ranges for grounding method of low-voltage power distribution system , points out adaptable residual current device ( RCD ) grounding methods and the selection of RCD data .

剩余电流动作保护器的可靠性验证试验技术的研究

Study on the Reliability Compliance Test for Residual Current Operated Protector

剩余电流动作保护器在低压电网中的应用

Application of residual current protective device in low voltage electric network

剩余电流动作保护器可靠性试验方法与试验装置的研究

Study on Reliability Test Method and Device of Residual Current Operated Protector

在电磁式剩余电流动作保护器上增设过电压保护

Adding Protection against Over-voltage in Electromagnetic Residual Current Operated Protector

低压配电系统装设剩余电流动作保护器探讨

Discussion on the Installation of Residual Current Operated Protective Devices in Low-voltage Distribution System

GB6829-1995剩余电流动作保护器的一般要求

General requirements for residual current operated protective devices

农网改造后剩余电流动作保护器的安装与管理

Installation and Management of the Residual Current Operated Protective Devices after the Modification of Countryside Distribution Network

介绍了剩余电流动作保护器的工作原理及其用途，叙述了剩余电流动作保护器的选型、安装及其局限性。

The operating principle and the use of residual current protective device is introduced , and its selection , installation and limitation are commented .

为了人身安全与用电设备安全，线路中应安装剩余电流动作保护器。

In order to protect the safety of individual and the electrical equipment , the residual current operated protective devices must be installed into the circuit .

剩余电流动作保护器是一种新型低压安全保护电器，它是低压电路中防止人身触电和漏电火灾的保护类电器。

Being a type of new low-voltage safe apparatus , the residual current device ( RCD ) is used to avoid the electric shock and the fire accident .

在失效模式基础上提出剩余电流动作保护器的可靠性指标，并根据可靠性抽样理论提出其可靠性验证试验方法。

The reliability index was applied on basis of the analysis on the failure mode . And according to the sampling theory of reliability a reliability test method was put forward .