切丝机

PROFIBUS-DP总线从站自诊断功能在切丝机中的应用

Application of Sub-station Self-diagnosing Function of PROFIBUS-DP Field Bus in Tobacco Cutter

KTC切丝机的PLC控制

The PLC control of the KTC cutting machine

这是由于RC4切丝机上下排链的进给线速度不一致，造成切丝宽度不均匀。

The variation of cut width was caused by the linear velocity difference between the top and bottom bands in RC4 cutter .

CM-1000型高速切丝机

CM-1000 Type High-speed Parting Machine

烟草切丝机磨刀装置多采用KTC型切丝机方式，该方式砂轮外圆与刀刃形成点接触，磨出的刀刃不整齐，影响切丝质量。

The grinding device in most tobacco cutters resembled that in cutter KTC , where in the periphery of grinding wheel was in point contact with the knife resulting in an imperfect ground edge , the quality of tobacco cutting was influenced .

切丝机刀辊自动定位系统的开发

Development of Automatic Positioning System of Cutting Drum in Tobacco Cutter

移动式玉米秸秆切丝机设计中几个问题的研究

Study on problems in the designing of movable corn stalk slivering machine

RC-4切丝机刀辊调速系统原理及常见故障分析

Principle and Common Faults of Knife Roller Speed Regulation System in RC_4 Cutter

切丝机铜排链清洗机的研制

Development of Machine Cleaning for Compression Bands in Tobacco Cutter Chain of Immunology

烟草切丝机曲刃刀辊体铣削夹具的设计应用

Design and Application for Drum of Curve Knife-Edge Milling Jig on Tobacco Cutter

饲用甜菜切丝机的试验研究初探

Preliminary experimental study on the fodder beet cutter

切丝机新型磨刀装置的研制

Development of New Grinding Device in Tobacco Cutter

切丝机传动系统的改造

Improvement of Tobacco Cutter Transmission System

食品加工用切丁切丝机

Cutting machine for food processing

阐述了杉木板皮切丝机的原理、组成、特点，进行了动力及传动系统、切削装置、进给装置、机架等机构的方案设计，研制了符合要求的分丝设备。

Expatiate the principle , form and quality of slab-shearing machine . Carry on the scheme design of power and transmission , cutting and feeding device and the shelf of machine .

烟草切丝机曲刃刀辊体技术要求较高、加工难度较大，为此结合加工工艺设计出两套铣削夹具，分别用于曲刃刀辊体轮廓面的粗、精铣削加工。

Technology request is very high and machine is very difficulty for Drum of Curve Knife-Edge on Tobacco Cutter . We based arts and crafts to design two sorts of milling jig , which cut contour on drum of curve knife-edge .