公差率

公差率公差率
  1. 螺纹钢的负公差率得到提高。

    The rate of minus tolerance of rebar is raised .

  2. 基于NURBS的形位公差装配成功率计算方法研究

    Research on the Calculation Method of Geometric Tolerance Stack-up Yield Based on NURBS

  3. 给出了带钢宽度、厚度公差与带钢成型时延伸率的关系式。分析了公差对延伸率的影响。

    Equations of relations between thickness and width tolerances and elongation of strip forming are given and the influences of the tolerances on the elongation are analysed .

  4. 通过对三种公差原则的尺寸公差值和公差带利用率的分析,给出应用公差原则的选择原则。

    Based on the analysis on the size tolerance rules and tolerance range usage ratio of three kinds of tolerance rules , give out the selection rules .