退火状态

  • 网络annealed
退火状态退火状态
  1. 结果表明,退火状态下钢中含有MC、M6C和M7C3型碳化物;

    The results showed that in the annealed state there are MC , M_6C and M_7C_3 in the steel ;

  2. 结果表明,该钢退火状态存在四种类型碳化物,淬火组织以板条马氏作为主。

    The results show that there are four kinds of carbides in annealed state of the steel , and major portion of quenched martensite is lath-like martensite .

  3. 研究了工业纯锆铸态和900℃×6h退火状态反复弯曲高周疲劳行为,结果表明:循环变形过程中纯锆表现为初期硬化、随后软化、再达到饱和3个阶段。

    High cycle fatigue behavior of commercial purity zirconium cast and annealed at 900 ℃× 6h conditions under cyclic reversed bend loading is investigated .

  4. 采用带拉伸机构的扫描电镜和透射电镜等实验手段研究了热轧退火状态M2高速工具钢在单向拉伸变形时微裂纹形核机制及位错塞积状态。

    SEM and TEM equiped with a tensile tester were used to investigate the nucleation of microcracks and dislocation pile up of the hot rolled M2 steel experiencing uniaxial extension and cold drawing deformation .

  5. 铜锌粉末退火状态下的组织研究

    Study on the structure of Cu-Zn powder under annealing conditions

  6. 全氢罩式炉在线退火状态评估仿真平台的开发

    Development of a simulation platform for evaluating HICON / H_2 bell annealers online annealing status

  7. 退火状态下复合材料的各级塑变抗力略高于其基体合金。

    Under annealing condition the σ p of the composite was slightly higher than that of its matrix alloy .

  8. 金相组织分析判断火烧部位曾进入到相变温度,使原来为退火状态的井架底部进行了一次不充分正火。

    Microstructure observation shows that the fired part was ever heated to transformation temperature which made the well-frame undergo a normalization .

  9. 金相法测定渗碳层深度要求试件必须为退火状态。

    Carburized layer ′ s depth of specimen , which must be in annealing state , is traditionally determined by means of metallographic examination .

  10. 与空冷状态焊接接头相比,退火状态焊接接头每个区域的晶粒都有明显的细化和均匀化。

    The grain of the annealing state of welded joints is more thinning and homogenization when it compared to those of the air-cooled state .

  11. 高于此点,由于超过共析点钢完全由珠光体和退火状态的渗碳体组成,硬度增加并不多。

    Above this point the hardness can be increased only slightly , because steels above the eutectoid point are made up entirely of pearlite and cementite in the annealed state .

  12. 结果表明,退火状态的钛合金较固熔时效态的试样应力难于松弛,但这种差异随温度的升高而减小。

    The result shows that the stress is more difficult to relax in Ti alloy under annealing than in solution and aging , but this difference decreases , depending on the temperature increase .

  13. 基于退火的状态转移式模糊C-均值聚类算法

    An Annealing-Based State Transitional Fuzzy C-Mean Algorithm

  14. 研究了添加稀土元素La,Ce(质量百分数依次为0.05%和0.15%)对93WNiFe合金动态性能的影响,所用合金分别为真空处理和锻造退火两种状态。

    The effect of La and Ce on the dynamic properties of 93W-Ni-Fe alloy was researched .

  15. 测量了动态直流磁场中退火与预应变状态下的铁和螺纹钢的微分磁化率曲线。

    The differential magnetic susceptibility curves of annealed and prestretchiron and screw-steel samples undergoing a uniform magnetic field sweep have been measured .

  16. 提出了基于模拟退火算法和信息状态转移图的度分布对设计方法。

    The design method of degree distribution is proposed based on the simulated annealing algorithm and EXIT ( Extrinsic Information Transfer Chart ) .

  17. 与已有的实验结果不同,实验中发现,这种N离子束辅助沉积的薄膜在Hanks溶液中的抗溶解特性,不是退火试样最好而是未退火状态的膜比前者更优。

    The authors observed the difference from previous experimental results that the resistance to dissolve in Hanks solution for the film deposited by nitrogen ion beam assistance not that annealed film is the best , but that unannealed one has been superior to the former .

  18. 借用模拟退火中系统温度的概念,提出基于退火的状态转移式模糊C-均值聚类方法,利用温度来控制类别中心的选取概率。

    By borrowing the system temperature concept from the technique used in the simulated annealing , a state transitional fuzzy C-means ( STFCM ) algorithm is proposed , in which the probability of the selected clustering centers depends on the decreasing temperature .