水套炉

  • 网络WATER JACKET HEATER
水套炉水套炉
  1. SL型水套炉腐蚀原因探讨

    Discussion on the Corrosion Reasons of Type-SL Water Sleeve Stove

  2. SL型水套炉是CE气田主要的加热设备,由于设计和使用中的一些原因,使水套炉受到不同程度的腐蚀,有的还相当严重。

    Type-Sl water sleeve stove is the main heating equipment in CE gas field . Because of some reasons in design and application , it makes water sleeve stove get various degree corrosion and some is quite se - rious .

  3. 水套炉盘管泄漏的原因分析

    Reasons for the Leak of Coil Pipe in Water Jacket Furnace

  4. 水套炉加热计算机自动控制系统的设计

    Design of Computer Automatic Control Heating System of Water Jacket Furnace

  5. 油田水套炉盘管失效分析

    The Analysis of Invalidation to the Tube of Oil-field Water Jacket Stove

  6. 单井集气站水套炉应用及改进方案

    Application and improvement of the water jacket furnace used for single-well gas-collecting station

  7. 油田新型高效水套炉的开发研究

    Development of New Jacket Heater Used in Oilfield

  8. 采用三维内肋管强化传热技术,可以达到降低水套炉的金属耗量和提高热效率的目的。

    The 3-D inner gilled tube strengthening heat transfer technology can be used to reduce the metal consumption and increase the thermal efficiency .

  9. 本文叙述了水套炉中,传统蛇形气盘管在盘管弯头制作、盘管焊接、盘管焊缝无损探伤的困难,及其对采油采气井场安全的影响。

    Describes difficulties in bent manufacturing , coil welding and weld nondestructive detection , and safety influence on oil and gas production on well sites .

  10. 本文通过对一台水套炉盘管泄漏的原因分析,对油田管理水套炉提供参考建议,对减少水套炉事故有一定的意义。

    This paper provides some suggestions in the management and reducing the accident of water jacket furnace , through analyzing the reasons for the leak of a coil pipe in water jacket furnace .

  11. 对火筒烟管结构、换热盘管结构形式以及整体结构进行了优化设计,对热媒介质进行了优选。在此基础上,开发了1750kW高效水套炉。

    A new oilfield jacket heater with high efficiency and miniaturization was developed on the basis of optimization of fire tube structure , heat coil structure , heat medium and whole structure of fire tube .

  12. 油田油气集输热力系统采用的加热炉多为水套炉、火筒炉、热媒炉及少量方箱炉。

    Most of the heating furnaces adopted by oil field oil-gas gathering and transportation system are water jacket furnaces , fire tube furnaces , heat medium heaters , as well as a small amount of box furnaces .

  13. 对火筒受热面积与负荷率的关系以及烟管换热面积与水套炉效率的关系进行了分析,提出了火筒烟管结构的优化设计方案。

    The relation of heating area of fire tube with load factor and the relation of heat transfer area of smoke tube with the thermal efficiency were analyzed . A scheme for structural optimization of smoke tube for fire was proposed .

  14. 在原油集输过程中,水套炉加热原油通常采用人工点火、人工调温的加热方式,存在温度控制精度低、能耗大、容易引发事故等问题。

    During the crude oil gathering and transporting , heating crude oil with water jacket furnace usually applies the manual igniting mode or manual temperature adjusting mode . It has the disadvantages such as low temperature control accuracy , large energy consumption and being susceptible to accident .

  15. 水套加热炉的改进设计

    Improved Design of the Crude Oil Heater with Water Jacket

  16. 相变换热技术在水套加热炉节能改造上的应用

    Application of Heat Transfer of Phase Change in Water Jacket Heater for Energy Saving

  17. 水套加热炉的失效分析

    Failure analysis of water - jacket heater

  18. 水套加热炉烟筒的腐蚀原因探讨

    Discussion on the Reasons Causing Corrosion of Chimney of the Stove Heated by Water Sleeve

  19. 水套加热炉的烟气腐蚀及防护

    The Corrosion and Protection of the Stack Gas of the Water Jacket Heating . Boiler

  20. 鉴于油田目前使用的水套加热炉大都存在热效率低、排烟温度高以及有安全隐患等缺陷,研制了CRHJ-250型常压超导热管水套加热炉。

    In view of the low heat efficiency and high temperature in fume exhaust and existance of potential safety hazard when the ordinary water jacket heater used , an atmospheric pressure water jacket heater with superheat pipes is developed .

  21. 本文通过实验及理论分析,探讨了川东地区水套加热炉烟筒遭受严重腐蚀破坏的主要原因,为水套炉烟筒防腐材料的研制工作提供了依据。

    Through the experiment and theoretical analysis , this article inquires into the main reasons of corrosion cracking of chimney of the stove heated by water sleeve and proposes the basis for developing corrosion-resistant materials of chimney of the stove heated by water sleeve .

  22. 水套式石墨合成炉冷却水的化学处理

    Chemistry treatment on cooling water of graphitic synthetic furnace by water jacket