高压泵

ɡāo yā bènɡ
  • high-pressure pump
高压泵高压泵
  1. 用螺栓安装在3.6升v6的高压泵附近。

    Bolted close to the high-pressure pump on the3.6-litre v6 .

  2. 首先关闭高压泵,切断主机电源,关闭RO设备的运行。

    First close the high-pressure pump , cut off the power supply of main device , and stop the operation of RO device .

  3. 基于CFD的反渗透海水淡化高压泵的性能预测

    Performance predictions of high pressure pump for 10000 tons reverse osmosis desalination system based on CFD

  4. 管液压成形(THF)过程非常复杂,它往往要求管内压力施加和管端轴向位移准确配合以成形出高品质的零件,为此需要配有管端轴向进给控制系统和昂贵的超高压泵给系统。

    Tube hydroformation ( THF ) is complicated and requires in-tube pressurization and axial feeding to cooperate with each other so as to form high quality parts .

  5. 高压泵流量控制装置中电磁阀的优化设计

    Optimization Design of Solenoid Valve for Electronically Controlled High Pressure Pump

  6. 松开高压泵旁边的发动机线束。

    Unclip the engine wire harness close to the high-pressure pump .

  7. 加压阶段,高压泵可以提供足够压力的液压油,实现棒料的顺利剪切;

    High-press pump can provide sufficient hydraulic liquid to make bar sheared ;

  8. 拆下燃油管路输送点处的高压泵低压管路。

    Remove low-pressure line for high-pressure pump at fuel line transfer point .

  9. 变频调速器增进高压泵性能

    Enhancing the performance of high pressure pump by frequency governor

  10. 报道了一种新型往复式螺旋双柱塞高效液相色谱高压泵。

    A reciprocating dual screw piston pump is reported .

  11. 如果更换了高压泵,则需要执行高压自适应。

    If the high-pressure pump was replaced , a high-pressure adaptation is required .

  12. 高压泵送,适合各种施工工况。

    High-pressure pump , suitable for various construction conditions .

  13. 确保高压泵在列出的压力下能够持续运行。

    Make sure that high voltage pump can continuously run under the listed pressure .

  14. 只有在已更换高压泵时才进行高压自适应。

    A high-pressure adaptation is only necessary if the high-pressure pump has been replaced .

  15. 多级煤泥泵和高压泵合二为一的研究与应用&一泵两用促进水力采煤事业发展

    Study and Application of the High-Pressure Water-Supply Pump Integrated with the Multi-Stage Slurry Pump

  16. 将高压泵完全压入橡胶垫片并旋转到极限位置。

    Press high-pressure pump completely into rubber gasket and rotate to the limit position .

  17. 对高压泵执行泄漏测试。

    Perform leak test on high-pressure pump .

  18. 三柱塞高压泵曲轴箱故障原因分析及技改

    Failure analysis of crank shaft box of tri - plunger HP pump and its improvement

  19. 拆卸和安装高压泵。

    Removing and installing high-pressure pump .

  20. 离心式高压泵电气控制系统

    Electrical Control System of Centrifugal Pump

  21. 固定爪必须在高压泵支架上的切口中接合。

    The holding claw must engage in the cut-out on the bracket for the high-pressure pump .

  22. 超高压泵强度设计应采用爆破失效准则。

    The superhigh pressure pump should be designed on the basis of the bursting failure criterion .

  23. 为高压泵加注燃油。

    Fill high-pressure pump with fuel .

  24. 即使在没有塑料防失器的情况下,高压泵及其传动机构仍可工作。

    The high-pressure pump and its drive mechanism will still work even without the plastic loss preventer .

  25. 应用正交试验法解决高压泵十字头铜套过热抱死问题

    Solution for Overheat Lock Breaking of Crosshead Copper Sleeve in High Pressure Pump by Orthogonal Test Method

  26. 抗磨液压油试验高压泵摩擦副磨损过程分析及其模拟

    Wear Process and Its Simulation Test of Friction Pair of High Pressure Pump in Antiwear Hydraulic Oil Test

  27. 另外两个链条驱动机油泵和两个高压泵开动的共轨喷射系统。

    Two more chains drive the oil pump and the two high-pressure pumps actuate the common rail injection system .

  28. 气动增压的超高压泵作为一种动力源综合了气动和液压的特点。

    The ultra-high pressure pump by pneumatic booster is a power source ; it combines pneumatic and hydraulic characteristics .

  29. 根据爆破失效准则设计并计算了超高压泵缸体壁厚;

    The equation of the wall thickness of the superhigh pressure cylinder is derived from the bursting failure criterion .

  30. 若要更换高压泵,必须松开仍然装配在车身上的低压管路。

    In order to replace the high-pressure pump , the low-pressure line that is still fitted must be unscrewed .