马氏

  • 网络Markov;mahalanobis;markovnikov;Mars
马氏马氏
  1. 利用基于马氏距离的数据分类技术,对输入样本分类。

    By adopting data sorting technology based on Mars distance the input samples are sorted .

  2. 一类自相似马氏过程k重点的存在性

    Existence of k - Multiple Point of a Self-Similar Markov Process

  3. Fe-C合金贝氏体铁素体的相变基元与类马氏体形貌贝氏体的形成

    Bainitic transformation units and formation of martensite-like bainite in Fe-C alloys

  4. Ni(18)CO-9Mo5Ti马氏体时效钢的金相组织与性能

    Metallographic Structure and Properties ofNi ( _18 ) Co_9Mo_5Ti Maraging Steel

  5. Q过程的马氏控制及其最优控制

    Controlled q - processes and its optimal Markov strategy

  6. Cu-Zn-Al合金中马氏体的有序化

    Ordering in martensite of a Cu-Zn-Al Alloy

  7. Fe和Co对Ni2MnGa合金(110)马氏体孪晶界面电子结构的影响

    Effect of Fe and Co on the electronic structure of ( 110 ) martensite twin boundary in Ni_2MnGa alloy

  8. 体系的共格界面能作为马氏体相变临界驱动力ΔGγ→εMs中的阻力项所占的比例小于10%。

    The interfacial energy as a resistance of martensitic transformation is less than 10 % of the critical driving force .

  9. 方法:采用聚类分析及马氏距离判别的多元统计学方法对参麦注射液的HPLC指纹图谱中采集的数据进行分析。

    Methods : Cluster analysis and mahalanobis distance analysis were adopted to analyze data of HPLC fingerprint of shenmai injection .

  10. 评分决名次的Excel算法基于EXCEL的马氏距离计算方法

    The Excel Calculate Method Based on Grade to Decide Place in a Competition CALCULATE MAHALANOBIS DISTANCE WITH MICROSOFT EXCEL

  11. γ(fcc)→α(bcc)马氏体相变表面浮凸的AFM观察与定量分析

    AFM Observation and Quantitative Analysis of γ( fcc )→α( bcc ) Martensitic Surface Relief

  12. Fe-Mn(Cr)-C系合金马氏体的价电子结构分析

    Analysis on Valence Electron Structure of Alloying Martensite for Fe Mn ( Cr ) C

  13. 为了便于设计石油膨胀管材料,推导了铁基合金ε马氏体的相变起始温度Ms(ε)的计算公式。

    In the end , the equation for calculating the initial transformation temperature Ms (?) of the ε martensite of the Fe-based alloy is derived .

  14. 探讨了CuZnSn合金在淬火马氏体态经形变后,在逆相变过程中的贝氏体转变机机制。

    The mechanism of the Bainite transformation during inverse phasetransition process for the quenching martensite state after deformation in Cu-Zn-Sn alloys is investigated .

  15. 对马氏体球墨铸铁在不同pH值石英砂浆中的静载三体腐蚀磨损特性进行了试验研究,并与低铬白口铸铁进行了对比。

    The three body corrosion wear behaviors of martensitic ductile iron and low chromium white cast iron under the test conditions of different pH value slurries have been studied .

  16. γ(fcc)→ε(hcp)马氏体相变切变角的原子力显微镜测定方法

    Method of γ( fcc )→ε( hcp ) Martensitic Transformation Shear Angle Determination by Atomic Force Microscope

  17. 二次硬化效应与残余奥氏体在回火过程中转变为马氏体和马氏体基体中析出细小弥散的Mo2C和VC有关。

    Secondary hardening is related to the transformation of the residual austenite into martensite and the precipitation of the fine and dispersed Mo_2C and VC .

  18. Cu-Zn-Al合金马氏体在稳定化过程中的反常浮凸

    Relief phenomenon of stabilized martensites in a Cu Zn Al alloy

  19. Cu-Zn-Al合金马氏体稳定化与母相有序态

    Stabilization of martensite and parent phase ordering in a Cu-Zn-Al Alloy

  20. 结果表明,合金的马氏体相变开始温度可达212°C,合金在马氏体及奥氏体状态下具有不同的屈服强度及形变强化能力。

    The result shows that the martensite start transformation temperature is determined as 212 ° C . The specimens in martensitic and austenitic state yield at different stress level and show different strain hardening ability .

  21. Dy对多晶Ni(52)Mn(24.7)Ga(23.3)合金马氏体相变和磁感生应变的影响

    Effect of Dy on Martensitic Transformation and Magnetic-Field-Induced Strain in Polycrystalline Ni_ ( 52 ) Mn_ ( 24.7 ) Ga_ ( 23.3 ) Alloy

  22. 本文刻画了Bandit过程与马氏决策规划的关系。

    Bandit problems are formulated as a special class of Markov decision processes .

  23. 以马氏链为工具对人类ABO血型的分布规律做了初步探讨。

    I present a initiative study about distribution laws of ABO blood type with the implementation of Markov Chain .

  24. 马氏体相或母相的屈服强度略有下降,而硬化系数则略有增加,Ni还使CuZnAl合金中α相析出变得困难。

    The yield stength of either its martensite or parent phase will decrease a little and Ni can also prevent the precipitation of α - phase from Cu-Zn-Al type alloy .

  25. 讨论了Hamilton四元数、马氏四元数及其与二维实信号类似的欧拉公式。

    In addition , Hamilton quaternion , Ma quaternion and their Euler formula similar to that of two-dimensional real signal were discussed .

  26. Cu-Zn合金马氏体相变中的内耗、电阻与形变

    Internal Friction , Electric Resistance and Shape Change in Cu-Zn Alloy during Martensitic Transformation

  27. 中国低活化马氏体钢CLAM热等静压扩散焊接初步研究

    Preliminary study on hot isostatic pressing diffusion welding for China low activation martensitic ( CLAM ) steel

  28. 马氏体相对Fe-Cr-Al合金阻尼本领和力学性能的影响

    Influence of martensite on damping capacity and mechanical properties in Fe-Cr-Al alloy

  29. 结果表明:该合金在18℃时发生热马氏体相变,生成5M马氏体;

    The results show that a martensitic phase transition to 5M martensite occurs at 18 ℃ on cooling .

  30. 保持Ni含量不变,增加Mn,降低Ga含量会使马氏体相变温度明显提高,同时相变滞后温区减小,居里温度基本不变。

    The martensitic transformation temperatures could be considerably increased by increasing Mn and decreasing Ga with fixed Ni content , while the temperature hysteresis becomes narrow and Curie temperature keeps constant .